Download Article
Download Article
This lovely folded star is also known as "German Christmas Star", "Eight Point Star", "Ribbon Star" and likely several other names. It was originally made in Germany with paper strips, but can be made with any creasable ribbon such as wire ribbon or "gift wrap" ribbon. The star requires only three types of folds, two of which get repeated eight times. A beginner can make this beautiful project in 20 minutes or so. Are you ready?
Steps
-
Cut four lengths of ribbon approximately 20 inches (50 cm) long. -
Fold the ribbons in half and crease them at the halfway point.Advertisement -
Interweave the ribbon loops so that the loose ends of each ribbon pass through the loop of the next ribbon to its left. -
Pull the loops snugly together. -
Fold the top layer(s) of ribbon over each other successively so that they overlap. -
Tuck the final ribbon under the loop formed by the first ribbon. -
Snug it down.
Advertisement
-
Look closely at the base. There should now be two ribbons coming out of each side. One ribbon (let's call it "A") on each side will come out under a fold of ribbon. The other ribbon (let's call it "B") will emerge out from under the side edge of a ribbon. -
Lift ribbon "B" and fold it at a 45 degree angle under itself and out to the left. -
Fold the "B" ribbon back down parallel to itself, creating yet another 45 degree angle. -
Fold the two angled pieces of ribbon together, making the ribbon lay over itself on the base. -
Bend the newly formed point away from you and hold it there temporarily. -
Slide the end of "B" under the edge of the ribbon "loop" on the base and snug it down gently. -
Repeat the above steps for all four sides of the base. -
Turn the base over and repeat, folding the outer points as instructed in this section.
Advertisement
-
Lay the base flat and lift one ribbon in the base, creasing it back on itself. Let's call this first ribbon "A". -
Lift the next ribbon counter-clockwise from the ribbon above (let's call it "B") and crease it back on itself as well. The end of this ribbon (B) will get tucked under the first (A) in a few steps. -
Fold the "B" ribbon out at a 45 degree angle, away from the center of the base. (Keep the original "back on itself" crease, then add the 45 degree angle to the outside.) -
Allow the ribbon (B) to lift up off the base. -
Curl the end of "B" around and tuck it under the "A", sliding the point through the base and out through the center of one of the flat points. Snug gently. -
Repeat for all four ribbons on this side. -
Stop at this point for a gift bow. Continue for an ornament.
Advertisement
-
Turn the base over. -
Make the 3-D points, as outlined in the previous section, for all four ribbons on the second side. -
Trim the ends of each ribbon close to the flat points. -
Slide florist wire through one of the flat points OR punch a small hole to allow hanging. -
Display proudly. -
Finished.
Advertisement
Community Q&A
Search
-
QuestionHow long does it take to make these?Community AnswerIt depends on your experience level, but it usually takes between 10-30 minutes to make one.
-
QuestionWhat is the best place to purchase paper?Community AnswerOffice supply stores such as Office Depot and Staples are the best places to purchase paper.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- New wikiHow users: You can click on each picture to enlarge it for a clearer picture.Thanks
- If you want the ends of the ribbon to slide through easier, try tapering the ends with scissors.Thanks
- The ribbon works best if it is easily creased. Soft fabric ribbons can be used, but they are trickier to work with and would easily frustrate a beginner.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Remember to take proper precautions when using scissors.Thanks
Advertisement
Things You'll Need
- Gift ribbon or any ribbon or paper strip that is easily crease-able. Half inch or wider is best for the first time making these.
- Scissors
- Ornament hanger or florist wire.
About This Article
Thanks to all authors for creating a page that has been read 269,088 times.
Reader Success Stories
- "Learned a new craft idea and can not wait to share it with my children! Perfect timing given that Christmas is right around the corner!" ..." more
Advertisement
"Learned a new craft idea and can not wait to share it with my children! Perfect timing given that Christmas is right around the corner!"
..."
more
"I needed a refresher course for this. Thanks for the ribbon use idea, I always have ribbon leftovers."
