Download Article
Download Article
Installing exterior siding may be the most effective way to increase the value and restore the beauty of your house. The process is not as complicated as it seems, and doing it yourself will save a lot of money for the cost of installation. Here are some steps to guide you as you learn how to install exterior siding.
Steps
Download Article
-
Install horizontal siding, such as aluminum or vinyl by hanging the underlayment and installing the trim.- Save some time and energy by using a pneumatic siding gun. This way, you don't have to hammer every nail by hand. [1]
X
Expert Source
Ryaan Tuttle
Home Improvement Specialist Expert Interview. 30 July 2021.
- Save some time and energy by using a pneumatic siding gun. This way, you don't have to hammer every nail by hand. [1]
X
Expert Source
Ryaan Tuttle
-
Add the corner posts, using two nails in the upper slots to suspend them. If you use more than one piece to complete a corner, be sure that there is an overlap of 1 inch (2.54cm).Advertisement -
Place the footer, which is the piece of trim that is at the bottom of each exterior wall, as starter strip of siding will slide into this. -
Apply a strip of F-channel trim at the top of the exterior walls, under the eaves. The top sheets of siding will slide under this piece. -
Install your starter sheet. Slide the bottom of the siding into the footer, being sure to allow for expansion. You should be able to wiggle the siding slightly. Slide the ends under the corner posts in the same manner.- Affix the siding to the wall by centering a nail in each section of the nail strip. Don't pound the nails in all the way.
-
Proceed up the wall, interlocking the bottom of each sheet with the top of the previous sheets. Be sure to overlap successive panels by 1 inch (2.54cm). -
Trim the siding panels using a circular saw to meet windows, doors, and corners. Use gutter-seal adhesive to finish the installation at window sills and eaves. -
Install the top panel by trimming the unneeded portion from the top of the sheet. Lock it into place at the top of the preceding panel, and slide it under the F-channel. -
Install vertical siding by first locating the mid-point of the wall. -
Draw a vertically level line at this position using a straightedge. -
Center the starter panel on that line and cut the strip 1/8 inch (0.3175cm) short, to allow for expansion. Hang this panel by placing a nail at the top of each nail strip, at about 8 inch (20.32cm) increments.- Don't attach the nails too tightly! If you do this, the vinyl might crack when it goes to expand and contract. Then, you'll start to see vinyl siding falling off or buckling in certain spots. [2]
X
Expert Source
Ryaan Tuttle
Home Improvement Specialist Expert Interview. 30 July 2021. - You can also install nails at 16 in (41 cm) intervals. [3]
X
Expert Source
Ryaan Tuttle
Home Improvement Specialist Expert Interview. 30 July 2021.
- Don't attach the nails too tightly! If you do this, the vinyl might crack when it goes to expand and contract. Then, you'll start to see vinyl siding falling off or buckling in certain spots. [2]
X
Expert Source
Ryaan Tuttle
-
Cut the successive strips to rest on the footer, always allowing a 1/8 inch (0.3175cm) gap at the top. Moving from the center out, interlock each strip with the previous one, continuing to place the nails at 8 inch (20.32cm) increments. -
Install a J-channel on the post when you reach a corner. Shim the J-channel at about 5/16 inch (0.794cm) to keep the post on the same plane as the other strips. The edges will insert between the J-channel and the outer flange of the post. -
Add panels around the doors and windows in the same manner as in Step 6. -
Proceed with the following steps for installing wood siding. The primary difference between this application and the others, is that the vertical corner boards will be installed last. -
Install trim boards to surround windows and doors. Add metal flashing to control water flow. -
Cut the boards to length, making sure that the joints meet over a stud. Make sure that each plank is cut square to avoid any gaps. Be sure to prime the sheets of siding on both sides and at the edges. Also, be sure to prime any exposed ends when panels are trimmed. -
Hang the first piece of siding so that it overlaps the foundation by 1 inch (2.54cm). Install the successive pieces so that they are nailed through the bottom of the upper board, and into the beveled edge of the lower board.- The uppermost board will be installed so that it abuts the eaves. Split the board so that the width is shortened, and then cover the exposed edge with frieze board.
-
Complete installation adding the vertical boards at the corners, so that they are flush with the horizontal boards, but always allow at least 1/8 inch (0.3175cm) for expansion.
Advertisement
Expert Q&A
Search
-
QuestionIs a siding gun worth it?Ryaan Tuttle is a Home Improvement Specialist and the CEO of Best Handyman, Inc. in Boston, Massachusetts. With over 17 years of experience, he specializes in building home service businesses, focusing on creating scalable and efficient brands. With the help of his global team, the companies have achieved over 10+ million in sales and received recognition through magazine features, and enjoy partnerships with wikiHow and Jobber field service software. Boston Magazine and LocalBest.com have named Best Handyman Boston the Best Handyman in Boston. Ryaan holds Construction Supervisor and Home Improvement Contractor Licenses.A siding gun is definitely worth it, especially if you buy a cordless one. You just plug it into the compressor, which will set the depth of the nails.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- Always use stainless steel roofing nails for wood siding and aluminum nails for aluminum siding. Never drive the nails in tight.Thanks
- When overlapping successive panels, stagger the seams in order to control water flow and avoid leaks.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
References
- ↑ Ryaan Tuttle. Home Improvement Specialist. Expert Interview. 30 July 2021.
- ↑ Ryaan Tuttle. Home Improvement Specialist. Expert Interview. 30 July 2021.
- ↑ Ryaan Tuttle. Home Improvement Specialist. Expert Interview. 30 July 2021.
- http://www.hometips.com/diy-how-to/siding-vinyl-aluminum-installation.html
- http://www.askthebuilder.com/589_Installing_Wood_Siding.shtml
About This Article
Thanks to all authors for creating a page that has been read 44,387 times.
Reader Success Stories
- "It was a very good article. I appreciate you sharing the knowledge, thank you."
Advertisement
90%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"It was a very good article. I appreciate you sharing the knowledge, thank you."
