PDF download Download Article PDF download Download Article

Beyblade launcher grips can be a big edge when battling. They can increase the power of your launch and your accuracy too. With a little work, you can make one using simple supplies around your home in about ten minutes. It will work just as well as buying on from the store and you’ll save a few dollars.

Method 1
Method 1 of 2:

Making a Grip with Cardboard Rolls

PDF download Download Article
  1. The toilet paper roll is larger, so it will fit over the base of the launcher. The aluminum foil rolls are thicker and will add some strength to the grip. [1]
  2. You will not need a grip that is the length of the entire cardboard roll. The half you use should be at least a little longer than the roll of toilet paper.
    Advertisement
  3. Leave a little of the of the toilet paper roll sticking out on one end so that the launcher can fit inside.
  4. Place the launcher so the holes are on top of the of the cardboard rolls. The launcher should rest on the aluminum foil roll inside.
  5. Wrap the tape around sideways around the Beyblade launcher. Just be sure you allow room to use the ripcord.A good strong tape will work best. Duct tape or electrical tape is ideal. They also give your launcher a nice appearance.
  6. Once you are satisfied with the performance of the grip, you can give it the look you want. You can wrap it in aluminum foil or decorate it with stickers.
  7. Advertisement
Method 2
Method 2 of 2:

Making a Grip with Pencils

PDF download Download Article
  1. The pencils can be sharpened or unsharpened. Just make sure the pencils are approximately the same length. Line the pencils up vertically. Make a triangular pattern by setting two of the pencils lined up in a row, and one pencil lined up in the middle of the other two pencils.
  2. Simple scotch tape or masking tape will work fine. Wrap a small piece of tape around the erasers, and another small piece around all the tips. This will help hold the pencils together. You don’t want them sliding out of position while you wrap them together.
  3. You will want to switch to a stronger tape. Electrical tape or duct tape is ideal. Start wrapping around one end, then roll the tape around to the other end. You can make two or three layers if you want a little more cushion to your grip. [2]
  4. They should rest over the lower half of the launcher on the backside. The pencils should be away from any of the moving pieces of the launcher.
  5. Place the pencils so they about an inch or two rests on the bottom portion of the launcher. Wrap the tape around the sides and crossing over the pencils vertically until the launcher feels secure. Be sure the tape does not interfere with the movement of the ripcord.
  6. Try launching a couple of Beyblades and make sure the grip seems to be stable enough. If you can feel the launcher moving at all you may need to add another layer of tape. Once you’re satisfied with the grip, add some decorations or stickers to finish it off.
  7. Advertisement

Expert Q&A

Ask a Question
      Advertisement

      Video

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Thanks for submitting a tip for review!

      Warnings

      • If you plan on using your Beyblade in competitions, be sure to check the rules. Many competitions do not allow modified launchers. This includes adding your grip.
      Advertisement

      Things You'll Need

      • 3 pencils
      • toilet paper roll
      • scissors
      • aluminum foil roll
      • tape or aluminum foil

      About This Article

      Thanks to all authors for creating a page that has been read 96,566 times.

      Reader Success Stories

      • Anonymous

        Oct 24, 2017

        "I think that the one with toilet rolls is better, but the one with pencils is more efficient."
      Share your story

      Did this article help you?

      Advertisement