Q&A for How to Set a Victor Mole Trap

It depends on the style of trap you're using, but they typically either go in the mole hill, on top of it, or right next to it. In either case, you're going to need to figure out where the mole actually is before you set the trap.

The claw-style traps that crush the mole are the most effective. Unfortunately, the live traps aren't nearly as effective as those claw traps.

There are machines you can buy that will pump the mole's tunnel with carbon dioxide to put it down. Those are fairly effective. The mole won't experience any pain either, if that's something you're worried about. It will just go to sleep and die quietly.

To improve sensitivity, cut a 1 X 1-1/4-inch rectangular shim out of a 1/16th-inch thick piece of hard plastic and glue it inside and at the end of the 1-1/4-inch-wide iron channel that has the yellow label. The shim prevents the cocking mechanism from rotating as far past the triggering point when the trap is set.

To maintain the Victor Out of Sight mole trap, regularly inspect it for damage, rust, or activity, and clean it with water and mild soap after each catch to prevent disease and remove scent. Then, reset it according to the manufacturer's instructions, ensuring proper alignment in an active mole tunnel.

To set your model #0645 Victor mole trap, ensure all components are in good condition, including the trap body, pan, and latch. The trigger pan should sit flat inside the trap body and connect to the latch. If the pan's lip is too low, try adjusting its height for better latch engagement.