How to Tie a Roast

PDF download Download Article
PDF download Download Article

You can tie up many different cuts of meat to keep them from losing their shape while they cook. Whether you’re trying to hold a filling in while the meat heats up, or you’re simply trying to maintain the roast’s appearance, tying a roast is the simple solution to keep your meal in place while it cooks. [1] To tie a roast, you’ll need butcher’s twine and a knife or pair of scissors to cut it.

Part 1
Part 1 of 3:

Tying Your Butcher’s Knot

PDF download Download Article
  1. Watermark wikiHow to Tie a Roast
    With your roast laid out lengthwise, slide the cut end of your twine underneath it. The cut end of the twine should be between you and the roast, while the uncut length of twine should extend away from you. Move the twine so that it’s resting a few inches or centimeters from the end of your roast. [2]
    • Make sure that you’re using butcher’s twine and not jute twine. Butcher’s twine is sometimes called kitchen twine, and won’t burn in the oven. [3]
    • The length of twine you need depends on the size of the roast and how tightly you plan on tying it. This can be hard to estimate, so just leave the roll of twine on the table as you work.
    • The end you choose to start on doesn’t matter. Pick the side most comfortable for you.
  2. Watermark wikiHow to Tie a Roast
    With the cut end in your right hand and the uncut length of twine in your left, pull the uncut twine over the top of the meat towards you. Bring them together and pinch the junction where they meet with your left thumb and forefinger. [4]
    • If you are left-handed, reverse the directions so that each piece of twine is in the opposite hand.
    Advertisement
  3. Watermark wikiHow to Tie a Roast
    Use your right hand to wrap the cut end around the uncut end by going over it counter-clockwise. Don’t pull it tight; there should be an inch-long opening where you just wrapped the twine. [5]
  4. Watermark wikiHow to Tie a Roast
    With the uncut end held firmly in your left hand, pull the cut length of twine through the loop with your right hand by going through the bottom of the loop. While still using your right hand, pull it through all the way and tighten it so that it forms a knot. [6]
  5. Watermark wikiHow to Tie a Roast
    Pull on both ends of the twine so that the knot rests tightly against the roast. The butcher’s knot is a kind of slip knot, and you can adjust it to be tighter or looser by pulling on the twine.
  6. Watermark wikiHow to Tie a Roast
    Once your butcher’s knot is resting firmly against the roast, take the remaining portion of the cut end and pull it across the uncut end. Then, twist the uncut end underneath the cut end and tighten it. Do this twice to form a knot. [7]
    • Your butcher’s knot should be firmly pressed against the roast, but it shouldn’t be so tight that it’s pushing juices out of your meat.
    • Do not cut off any of the remaining twine on your uncut end. You’ll need it to secure your roast later. [8]
    7. Advertisement
Part 2
Part 2 of 3:

Looping the Rest of the Roast

PDF download Download Article
  1. Watermark wikiHow to Tie a Roast
    Hold the section of twine closest to the knot in your right hand, and hold the remainder of the twine in your left. Bring a section of uncut twine towards the section of cut twine in your right hand and cross the two pieces. Spin the loop shut by pulling your right hand around the left to close the junction where the two sections meet. [9]
    • Make sure that the cut side of twine rests underneath the uncut twine when you twist your loop to slide it over the roast.
    • The opening in the middle of the loop should be big enough to slide your roast through.
  2. Watermark wikiHow to Tie a Roast
    Starting on the end of the roast that you’ve already tied, slide your roast through the loop that you’re holding by lifting the meat slightly and moving the twine. Once you’re a few inches further down from the knot, pull your loop tight by pressing the junction where your length of twine forms a loop downwards with your right hand while pulling the remaining length of twine with your left.
    • Your two loops should connect at the top, wherever you chose to tighten the loop. Try to tighten your next set of loops along that same line. [10]
  3. Watermark wikiHow to Tie a Roast
    Continue to create loops and slide your roast through them in several inch-long increments. As long as it seems like the loops will keep your roast from moving around, it doesn’t really matter what the exact distance between them is. [11]
    • It should look like there’s a single piece of twine running the entire length of your roast at the junction where you’ve tightened each loop.
    4. Advertisement
Part 3
Part 3 of 3:

Finishing Your Roast

PDF download Download Article
  1. Watermark wikiHow to Tie a Roast
    Once you’ve reached the end of your roast, place your last loop so that it mirrors the butcher’s knot on the opposite side. Before flipping it, inspect the tension on the loops to ensure that they’re tight enough. If you need to tighten any of them, either pull on the remaining length of twine, or retie your loops so that they’re tighter. [12]
    • It should look like a symmetrical grid after you finish your last loop.
  2. Watermark wikiHow to Tie a Roast
    Turn your roast upside down on the cutting board or countertop so that you’re looking at the bottom of the roast. Try to line it up so that the line running between your loops on the bottom is in the middle of the roast.
  3. Watermark wikiHow to Tie a Roast
    This piece of twine should be long enough that you can tie it to the first knot you made. Once you’ve got a workable length pulled out, cut it from the original ball of butcher’s twine with a knife or scissors. [13]
    • Be careful when estimating the amount of twine necessary to run over the roast. Too much twine is better than too little.
    • An easy way to check is to try pulling your length of twine to the knot and then cutting above there. You can always cut any excess twine later.
  4. Watermark wikiHow to Tie a Roast
    You should still be looking at a set of parallel loops on what was originally the bottom of your roast. Take the length of twine that you have just cut, and wrap it under and over each individual loop of twine in a straight line towards the end you originally started with. Pull firmly after each time you wrap it to secure it to each individual loop. [14]
    • This is securing the loops you’ve already made to make sure that they stay in place while cooking. [15]
  5. Watermark wikiHow to Tie a Roast
    You should still have at least a small length of twine dangling from your original butcher’s knot. Bring this length of twine together with the portion you have just used to secure the bottom of the roast. Wrap them around each other once and pull them to the roast. Wrap them around each other again and tighten it to form a knot. [16]
    • If you still have any twine left over after your last knot, cut it with scissors or a knife.
    6. Advertisement

Expert Q&A

Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Video

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Submit
      Thanks for submitting a tip for review!

      Things You’ll Need

      • Butcher’s twine
      • Knife or scissors

      You Might Also Like

      Spoiled Ground Beef: How to Identify and Prevent It
      How to
      Cook London Broil in the Oven
      How to
      Cook Diced Beef
      How to
      Cook Beef Tripe
      How to
      Boil Ground Beef
      How to
      Drain Ground Beef
      How to
      Cut London Broil
      How to
      Cut a Brisket
      How to
      Prepare Beef Ribs
      How to
      Cut Corned Beef
      How to
      Cook Lamb Shanks
      How to Smoke a Brisket: Steps, Tips, and Tricks
      How to
      Cook Meatballs
      How to
      Tenderize Beef
      Advertisement

      References

      1. ↑ https://www.foodrepublic.com/2013/11/06/why-do-you-tie-a-roast/
      2. ↑ https://youtu.be/rFIwbUBiRSE?t=54
      3. ↑ https://www.latimes.com/style/la-fo-twine4-2009mar04-story.html
      4. ↑ https://youtu.be/rFIwbUBiRSE?t=61
      5. ↑ https://www.bbc.com/food/techniques/how_to_tie_a_butchers_knot
      6. ↑ https://www.bbc.com/food/techniques/how_to_tie_a_butchers_knot
      7. ↑ https://www.bbc.com/food/techniques/how_to_tie_a_butchers_knot
      8. ↑ https://youtu.be/rFIwbUBiRSE?t=198
      9. ↑ https://www.youtube.com/watch?v=rFIwbUBiRSE
      1. ↑ https://youtu.be/rFIwbUBiRSE?t=98
      2. ↑ https://youtu.be/rFIwbUBiRSE?t=107
      3. ↑ https://youtu.be/rFIwbUBiRSE?t=150
      4. ↑ https://youtu.be/rFIwbUBiRSE?t=156
      5. ↑ https://youtu.be/rFIwbUBiRSE?t=162
      6. ↑ https://youtu.be/rFIwbUBiRSE?t=168
      7. ↑ https://youtu.be/rFIwbUBiRSE?t=190

      About This Article

      Thanks to all authors for creating a page that has been read 51,645 times.

      Did this article help you?

      Advertisement