How to Adjust a Deployment Clasp

PDF download Download Article
PDF download Download Article

Deployment clasps are designed to reduce stress on the leather band of a watch or bracelet. However, they are a bit more complicated than a typical watch buckle. To adjust a deployment clasp, you’ll need to unfold the hinged metal sections and set the length of the band. Once you’ve fitted the band to your wrist, there’s no need to adjust it again—simply snap the deployment clasp open and closed each time you want to wear your watch.

Part 1
Part 1 of 3:

Opening the Deployment Clasp

PDF download Download Article
  1. The two leather straps should not be buckled together. A table or countertop are good options, but make sure you’ve wiped them first. Dirt will scratch the crystal face of your watch when you flip it over. [1]
    • You could also lay a clean cloth across the surface and place your watch on top of that, for extra cushion and protection from scratching.
  2. The deployment clasp is located where the watch buckle attaches to the leather strap. Firmly grasp the leather strap with one hand, then place the finger and thumb of your other hand on opposite sides of the metal buckle. Pull on the buckle, away from the strap. [2]
    • It will snap open, revealing half of the metal deployment clasp.
    Advertisement
  3. Keep one hand on the leather strap. With your other hand, grasp the flat, open piece of the deployment clasp and pull firmly away from the strap. This will open the deployment clasp completely. [3]
    • At this point, the deployment clasp will be completely extended to its longest position.
    • The deployment clasp is made up of three hinged portions. This is known as a “butterfly clasp” because the two side pieces can flap back and forth like the wings of a butterfly.
  4. Certain watches are outfitted with push button deployment clasps, which are slightly easier to open than standard deployment clasps. Locate two small buttons on either side of the metal watch buckle. Press these buttons simultaneously with your thumb and forefinger, and the deployment clasp will spring fully open. [4]
    • Push button buckles offer additional security and prevent the clasp from opening on its own.
    • Once open, push button clasps and standard deployment clasps are adjusted the same way.
    5. Advertisement
Part 2
Part 2 of 3:

Changing the Length of the Band

PDF download Download Article
  1. The clasp is made of two hinged pieces of metal. Insert your thumbs into the space between the two flaps of the buckle and pull them apart. They should click open and reveal a small pin, known as the post. [5]
    • The larger top flap is typically embossed with the brand name of the watch, while the bottom flap is smaller and unmarked.
    • If you are unable to open the flap with your fingers, use a penny or similarly-sized coin. Insert the penny between the branded top and the unmarked flap. Twist the coin to either side. The pressure should force the flap to drop open. [6]
    • New watch buckles are often more difficult to open.
  2. Flip the watch over so the crystal face is pointing down. Slip the end of the strap without the deployment clasp into the buckle, between the two metal flaps. [7]
    • Continue threading it through until the band has reached your desired length.
    • Note that the watch will look larger now than it will once the deployment clasp is closed again. Keep that in mind while adjusting the length of the strap.
  3. The leather strap will feature a row of small holes through the center. Push the metal post through one of the holes, taking a best guess at which one will best fit your wrist if you don’t already know. [8]
    • It will be easy to re-adjust the length of your watch band, so don’t worry about making it too small or too large at this point if you’re not sure exactly which hole to use.
  4. Close the flap by pressing it back up toward the branded top bar. Fold the clasp thirds back up, pushing the top and bottom in between your fingers until you hear a click. [9]
    • Pull gently on the deployment clasp to make sure the buckle is fully locked in place.
    5. Advertisement
Part 3
Part 3 of 3:

Wearing the Watch

PDF download Download Article
  1. Slip the watch over your hand and onto your wrist. Fold the non-buckle side of the deployment clasp closed and snap it shut with your thumb and forefinger. [10]
    • You’ll hear a small click, which means that it is fully secured.
  2. Grab the end of the leather band without the buckle and slide it through the small leather loop on the other band. Push it through until it lays flat against the other band, then push down gently against your wrist with your finger. The second half of the deployment clasp will snap shut. [11]
    • You will hear another small click as the deployment clasp snaps fully shut.
    • At this point, the watch band is secure on your wrist.
    • The band should be tight enough to stay on your wrist without turning or slipping off your hand, but it should not be tight enough to dig into your skin or cut off any circulation.
  3. If you need to make any adjustments, open the watch by either pulling up on the buckle or pressing the buttons on the buckle, depending on your watch type. Follow the same steps to adjust the length: Remove the watch from your wrist, re-open the buckle, and adjust which hole the post goes through. Then, put the watch back on and close the clasp.
    • Repeat as needed until you achieve the correct fit.
  4. Once the band has been adjusted to fit your wrist, you will not need to repeat these adjustments. Each time you want to wear the watch, open the deployment clasp and expand the band to its widest position. Slip the band onto your wrist, slide the leather band through the loop, and close the clasp.
    • Deployment clasps are designed to preserve the lifespan of watch bands by reducing wear on the leather straps.
    5. Advertisement


Community Q&A

Search
Add New Question
  • Question
    How do I take links out of my Gucci watch?
    Community Answer
    Take it to a jewelry store or a person who specializes in watches. Because Gucci watches are so expensive, it would be best to take it to someone with a knowledge of watches than to take the links out by yourself.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 1 Helpful 2
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Tips

      • Watches with metal links also feature deployment clasps. These types of watches cannot be adjusted at home, however. You’ll need to take it to a jeweler who can remove the correct number of metal links to fit the watch to your wrist. [12]
        Thanks
        Helpful 0 Not Helpful 0
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!
      Advertisement

      You Might Also Like

      4 Easy Ways to Safely Open a Pandora Bracelet
      How to
      Put on a Bracelet with One Hand
      How to
      Make a Shamballa Bracelet
      What Does an Evil Eye Bracelet Mean?
      How to
      Shrink a Silicone Bracelet
      How to
      Measure a Pandora Bracelet
      How to
      Make Friendship Bracelets for Taylor Swift's Eras Tour
      How to
      Keep Bangle Bracelet from Moving Around on Your Wrist
      Advertisement

      Expert Interview

      Thanks for reading our article! If you’d like to learn more about watches, check out our in-depth interview with Bill Green .

      References

      1. ↑ https://youtu.be/uC8YkzWUkjw?t=13
      2. ↑ https://youtu.be/Pu9M5gXs_b4?t=74
      3. ↑ https://youtu.be/Pu9M5gXs_b4?t=104
      4. ↑ https://youtu.be/XVNlLKZNwts?t=22
      5. ↑ https://youtu.be/Pu9M5gXs_b4?t=139
      6. ↑ https://www.youtube.com/watch?v=XVNlLKZNwts
      7. ↑ https://youtu.be/Pu9M5gXs_b4?t=177
      8. ↑ https://youtu.be/uC8YkzWUkjw?t=37
      9. ↑ https://youtu.be/uC8YkzWUkjw?t=40
      1. ↑ https://youtu.be/Pu9M5gXs_b4?t=212
      2. ↑ https://youtu.be/Pu9M5gXs_b4?t=227
      3. ↑ https://youtu.be/8HfyIRjDJnc?t=68

      About This Article

      Thanks to all authors for creating a page that has been read 77,645 times.

      Did this article help you?

      Advertisement