Download Article
Download Article
Hair sticks are a great way to secure long hair in a bun and can be made for almost no cost in materials. Just use twigs you find lying around in the yard.
Steps
Download Article
-
1Work out your stick length. You do this by measuring the width of your bun and adding a couple of inches.
-
Find your stick. Go for a walk and collect some twigs. They should be no thicker than your index finger. Your stick should to be at least two inches longer than what you need. Shaping will shorten the final stick.
- Don't worry about getting a perfectly straight stick. Slight bends and curves in the wood make it more interesting to look at and they will hold your hair more securely.
- Avoid evergreen woods like pine as they contain large amounts of sap.
Advertisement -
Look for sticks that flex. Discard any sticks that snap easily. Hair is pretty strong. If a stick snaps when you bend it slightly, it will break in your hair.
-
4Clean your stick. Using a knife, remove the bark from your chosen stick.
-
5Cut off any prominent protrusions. Any big bumps will make it hard to slide the stick into your hair.
-
Trim your stick. With a hacksaw, cut the stick to the desired length. Be sure to remove both ends.
-
7Shape the stick. Carve one end of the stick so it tapers into a blunt point.
-
8Round off the other end of the stick. This is where you hold the stick to insert into a bun.
-
9Sand the stick. With coarse sandpaper, sand the stick until it is the right shape.
- Make sure the end of the stick is sanded into a smooth curve.
-
10Detail your stick. Draw your desired design onto the stick with a pencil or ballpoint pen. Do not use an ink pen as ink may bleed into the wood.
-
11Carve out the design. Cut into the stick at a 45° angle just below the lines you have drawn.
-
12Continue to shape the design. Cut into the stick at a 45° angle above the lines to cut out a V shaped piece of wood.
-
13Carve out the entire design in this way. Work carefully to cut away only what you want.
Advertisement
-
1Sand the stick with medium sandpaper.
-
2Sand smooth all edges. Fold the sandpaper in half and use the edge to sand inside the cuts you made for the design.
-
3Repeat with fine sandpaper. Go over the stick with fine sandpaper, folding it again to sand the cuts.
-
4Polish the stick smooth. Use a nail buffer or progressively finer sandpaper to get the stick really smooth.
-
5Oil the stick. Put a small amount of your chosen oil on a plate. Use your fingers to apply it to the wood. Make sure all the wood is covered with oil.
- Walnut oil brings out darker colours in the wood. Wood that looked rather boring before, can look stunning after it has been oiled. The darker the colour, the bigger difference the walnut oil will make.
-
6Allow the stick to soak up the oil for a couple of hours.
-
7Remove any excess oil with tissue. Wipe until no oil comes off the stick.
Advertisement
Community Q&A
Search
-
QuestionCan I paint the stick?Community AnswerOf course.
-
QuestionWhat kind of wood should I use?Community AnswerIt really doesn't matter. Oak is hard and pine is soft -- try whatever is in your area.
-
QuestionWhat is a hair stick?Community AnswerA hair stick is a sort of hair accessory, usually used to secure buns. It's a stick that you put in your hair.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- If the wood colour is too light, soak it in very strong coffee to darken and warm the colour. This should be done before applying the oil.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Thanks for submitting a tip for review!
Advertisement
Warnings
- Avoid walnut oil if you have a nut allergy or will be giving the stick to someone with a nut allergy.Thanks
- Always point the knife away from you when carving. Wear safety glasses.Thanks
Advertisement
Things You'll Need
- A twig
- A hacksaw
- A wood carving knife; if you don't have one, a penknife or craft knife will work
- Sandpaper in coarse, medium and fine
- Nail buffer or super fine sandpaper for polishing
- Walnut, linseed oil or grapeseed oil
About This Article
Thanks to all authors for creating a page that has been read 80,665 times.
Reader Success Stories
- "I have wanted to do this for a long time. Thanks for the information."
Advertisement
96%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"I have wanted to do this for a long time. Thanks for the information."
