PDF download Download Article
A beginner's guide to cutting wavy hair and getting gorgeous results
PDF download Download Article

Do you need to give your wavy hair a trim? We are here to help. Luckily, there are a few techniques that make it easier—even if you’ve never cut your hair before.

Method 1
Method 1 of 3:

Trimming the Ends

PDF download Download Article
  1. You don’t need to dampen your hair for this super simple technique, but it's fine to spray a little detangler on your hair if it's difficult to brush out or knots up easily. Run a comb or paddle brush from root to tip until your wavy hair is smooth and tangle-free. [1]
    • Using detangler is okay, but your hair needs to be clean and otherwise product-free.
    • This technique works for chin-length or longer hairstyles. If you're cutting wavy hair into a short or pixie style for the first time, you may want to have a stylist do the initial cut. Then, you can try keeping up with maintenance trims at home!
  2. Place the tip of a comb at the center of your front hairline. Drag the comb to the nape of your neck to create the center part. Brush or comb down the hair on each side of the part so that you have 2 smooth, even sections of hair. [2]
    • It's best to part your hair down the center when you're doing a simple, one-length trim, even if you normally style your hair in a side part. This helps prevent uneven sides.
    Advertisement
  3. Grab a section of hair and braid or twist it. Separate a 1–2 in (2.5–5.1 cm) section of hair with your fingers, starting on 1 side of your head. Braid or twist the section of hair almost all the way to the end until you get to where you want to take off length. [3]
    • A good trim usually takes off 1 4 1 2 inch (0.64–1.27 cm) of lengths.
    • The smaller and tighter you make the braids or twists, the more precise your trim will be.
  4. You will be using the hair elastic as a guide for removing the length, so place it appropriately based on how much hair you want to take off the ends. [4]
  5. Continue the same process for the remaining sections of hair, working systematically to the other side. Be sure to wrap the elastic at the same length for each braid or twist. If you need to, use the previous braid as a point of comparison. [5]
    • Be consistent and do all braid or all twists.
  6. Pick up the first braid or twist and make a straight snip across the bottom, directly below the hair elastic. Start on 1 side of your head and work systematically to the other side so you don't accidentally skip or miss any braids. [6]
    • Don't use regular scissors or kitchen shears for this! It's best to use stylist shears, which you can pick up at most drug and big-box stores. [7]
    • Also, avoid using thinning shears or razors on your hair—these tends to make wavy hair frizzy. [8]
  7. After trimming the end of each braid or twist, pull off the hair elastic. Continue this process for each braid until you’ve finished cutting all of your hair. Then, undo your braids, brush out your hair, and check out your results! [9]
  8. Advertisement
Method 2
Method 2 of 3:

Sectioning Hair for Face-Framing Layers

PDF download Download Article
  1. Towel-dry your freshly washed hair or spray your hair with a little water to dampen it. Then, run a paddle brush or wide-tooth comb through all of your hair from root to tip to get rid of any knots or tangles. [10]
    • Try applying a detangling spray if your wavy hair is thick or tends to tangle a lot.
    • This technique works best for medium and long hair. The process is similar if you want to cut a layered bob, but there are a few key differences .
  2. Identify the center of your front hairline and position the tip of a comb against your scalp. Pull the comb through the crown and all the way down to the nape of your neck. Comb the sectioned hair down on each side to smooth the hair and complete your center part. [11]
    • Be sure to smooth the hair down on both sides so your layers will be even.
    • Parting your hair in the center before cutting layers offers the most styling flexibility. However, if you always style your hair the same way, you can comb your hair into your usual side part before cutting layers. [12]
  3. Place the tip of the comb against your scalp next to the top of your left ear. Run the comb through the hair to the top of your right ear to section off the back part. Comb this section straight out in the back. [13]
    • At this point, you should have 3 sections: a top left section, top right section, and back section. The back section starts at the crown and includes all of the hair beyond the crown.
  4. Drag the comb from the lobe of 1 ear over to the lobe of your other ear to create a top section and a bottom section of hair. Twist the top section and clip it out of the way with a plastic hair clip. [14]
    • You don’t have to do this if your hair is thin, but it's generally a good idea so you aren’t working with too much hair at a time.
  5. Advertisement
Method 3
Method 3 of 3:

Creating Face-Framing Layers

PDF download Download Article
  1. Quickly run the comb through the hair once more. Place the hair in between your index finger and middle finger on your non-dominant hand. Bring your fingers down the length of the hair and stop 1–2 inches (2.5–5.1 cm) from the ends. [15]
    • The exact amount of length you cut off is up to you, but a good trim usually takes about 1 inch (2.5 cm) off. Err on the side of caution if you aren’t sure! You can always cut more hair off later.
  2. Hold the scissors in your dominant hand and cut across the hair from right to left if you’re right-handed or left to right if you’re left-handed. Use your fingers as a guide and snip off 1–2 in (2.5–5.1 cm) of length. [16]
    • If the hair if very thick, you may need to grab small sections at a time and work your way from 1 side to the other.
  3. Remove the plastic hair clip and comb out the top layer of hair. Sandwich the hair in your fingers and bring them to the ends until the hair is taut. Use the first section as a guide to cut off the same amount of length. [17]
    • Use the same process to remove length from the left and right sections. [18]
    • Be sure to make blunt cuts straight across the hair.
  4. Grab the section of hair from your hairline to your ear on whichever side you’d like to start on. Sandwich the hair in between the pointer and middle fingers and bring them down until they’re a few inches from the end. [19]
    • Remember to pull the hair taut.
  5. If you aren’t sure about the length, start about 1 inch (2.5 cm) above the current length for the first layer. Angle the fingers holding the hair up slightly. Angle the scissors down and cut across the hair, using your angled fingers as a guide. [20]
  6. Repeat the process of angling the fingers and cutting along beneath them to create the first layer. To make sure the layers on both sides are perfectly even, place the comb horizontally in the center of your hairline and comb down to bring hair from each side to the middle. Then, compare the lengths of the pieces on each side of your nose. [21]
    • Make any minor tweaks, as necessary, until the both layers are even.
  7. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    What haircut is best for wavy hair?
    April Ferri
    Professional Hair Stylist
    April Ferri is a Professional Hair Stylist and the Co-Owner of Widows Peak Salon, a hair salon based in Los Angeles, California. With over ten years of experience, April specializes in hair coloring and enhancing and transforming natural tones into vibrant shades for beautiful and low maintenance hair. Her work has been featured in Voyage LA Magazine, and she has worked as a stylist for LA Fashion Week.
    Professional Hair Stylist
    Expert Answer
    It's best to work with your natural texture—that will help you control it. A lot of people want to thin it out with thinning shears or razors, but that will usually just make wavy hair more frizzy.
Ask a Question
      Advertisement

      Video

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!

      Things You’ll Need

      Trimming the Ends

      • Detangler (optional)
      • Wide-tooth comb or paddle brush
      • 15-20 hair elastics
      • Sharp haircutting shears

      Creating Face Framing Layers on Long or Medium Hair

      • Detangler (optional)
      • Wide-tooth comb or paddle brush
      • 15-20 hair elastics
      • Sharp haircutting shears

      About This Article

      Thanks to all authors for creating a page that has been read 78,277 times.

      Did this article help you?

      Advertisement