How to Keep Car Mats in Place

Floor mats always tend to shift when you get in and out of your vehicle, which can give it a sloppy appearance. A loose car mat can also get underneath the pedals while you’re driving and cause them to stick, creating a serious safety risk. If you want quick fixes to keep your mats from moving around, look for ways to secure them directly to the floor. For a more permanent option, you can install floor mat anchors within a few minutes. If you have continued problems with your floor mats, it may be time to replace them.

Method 1
Method 1 of 3:

Attaching Car Mats to the Floor

PDF download Download Article
  1. Check on your vehicle’s floor near the front of the seat to see if there are hooks or snap fasteners built into it. If your floor has hooks, push them through the holes in the floor mat so they hold tightly. If there are snap fasteners, line up the other sides of the fasteners on your floor mat and push down firmly until they click into place. [1]
    • If your floor mats don’t have holes, then you can either use a hole punch or hole cutter to make them. Make sure to position the hole so it lines up with the floor mat.
    • Some older vehicles may not have floor mat hooks or fasteners.
  2. Flip the mat over so the bottom is face-up. Cut strips of double-sided carpet tape that are the same lengths as the edges of the floor mat. Remove 1 side of the adhesive backing and carefully place the tape around the mat’s edges. After you apply all the tape, remove the second adhesive backing and flip the mat over. Position the mat in your vehicle and press around the edges firmly to secure the tape.
    • You can buy double-sided carpet tape from home improvement and hardware stores.
    • You can use carpet tape in vehicles that have hard floors as well.
    Advertisement
  3. Look for heavy-duty Velcro strips that have adhesive backing so they’re easy to install. Take 4 pieces of Velcro with stiff bristles and press them into the corners of the floor mat. Set the floor mat inside your vehicle and mark where the Velcro pieces line up. Place the Velcro strips with the soft bristles on the vehicle’s floor. Set the mat down so the Velcro pieces line up and press firmly.
    • You can buy heavy-duty Velcro pieces from your local hardware store.
    • You may also put Velcro strips completely around the edges of the mats for added security, but they may become difficult to remove.
    • If your vehicle has carpeted floors, you only need to apply the stiff-bristled pieces to the floor mat since they will adhere to the carpeting. [2]
  4. Lay the mat in the footwell and make marks on the floor where the holes in the mat line up. Remove the mat, and hold a drapery hook so the top of the U-shape points toward the seats. Push the straight, pointed end of the hook horizontally into the mark on the floor to secure it. Repeat the process with the second hook. Put the mat back into your vehicle so the hooks loop through the holes.
    • The drapery hooks will keep the mat from moving forward, but the hooks may slide out if you forcefully move the mat backwards.
    • Drapery hooks have a straight pointed section and a large U-shaped hook, which is normally used to hang curtains on rings or rods. You can buy drapery hooks from a home goods or fabric store.
    • Drapery hooks may damage the carpeting if they’re pulled too hard, so be careful not to shift the floor mat too much.
    5. Advertisement
Method 2
Method 2 of 3:

Installing Floor Mat Anchors

PDF download Download Article
  1. Floor mat anchor kits are universal, so choose whichever design and color you want to use. Make sure the kit contains a top anchor cap, a spiked anchor bottom, a hole cutting tool, and a washer. Get enough kits so you have 2 anchors for each mat in your vehicle. [3]
    • Most floor mat kits come with 2–4 anchors and cost about $15–20 USD.
    • Floor anchors work best on vehicles that have carpeting in the footwell.
  2. Remove the floor mat and lightly tap along the floor along the front edge of the seat. Listen for a hollow thud and check that the carpet bows down when you hit it, which signifies there’s padding underneath. Look for 2 spots near the corners of the seat and mark them with a pen. [4]
    • If you hear a solid metallic sound when you hit the floor, avoid putting the anchor there since you could cause it to break.
  3. Flip the mat over so the bottom faces up. Hold the hole cutter vertically so it’s 2 inches (5.1 cm) in from the mat’s bottom corner. Tap the top of the hole cutter with a hammer to punch through the mat. Then punch a hole in the other bottom corner the same way. [5]
    • If your floor mat already has holes near the corners, then you may skip this step.
    • You can also twist the hole cutter clockwise to trim through the mat.
  4. Locate the anchor caps, which resemble large plastic screws. Flip the mat so it’s face-up and guide the threaded end of the cap through the hole you just punched. Put the second cap in the other hole on the mat. Press firmly until the bottom of the cap is flush with the mat. [6]
    • The hole will be about the same size as the threaded end of the cap, so it may take a little force to push them completely through.
  5. Locate the circular washers inside the kit and take 1 for each of the caps. Push the washer onto the threaded end of the washer on the bottom side of the mat. Slide the washer up until it’s flush with the mat. Repeat the process for the other anchor cap. [7]
    • The washer makes it easier to screw and unscrew the cap later on so your floor mats don’t get stuck inside your vehicle.
    • If your floor mat already had holes that have rubber backings, you don’t need to use the included washer.
  6. Take the bottom portions of the anchors, which look like a star with spikes sticking out from the bottom. Line up the center of the bottom piece with the threading on the cap so the spikes point down. Turn the bottom piece clockwise to tighten it onto the cap until it’s hand-tight. Attach the other bottom piece to the second cap. [8]
    • The pointed ends of the anchor are sharp, so be careful when handling them.

    Tip: If there are spikes or grippers in the way of the anchor piece, cut them flush to the bottom of the mat with a pair of wire cutters. Then screw the bottom anchor piece in.

  7. Lay the mat down on the floor in the position where you want it. Adjust the mat as needed until the anchors are directly above the sections of floor you marked earlier. [9]
    • Avoid putting the anchors anywhere else on the floor, or else you may break them when you try to secure them.
  8. Line your hammer up with the top of the cap and tap it straight down into the floor. Continue hitting the cap until the anchor underneath the mat presses firmly into the flooring beneath it. Then tap on the second anchor repeatedly until the mat lies flat. Your floor mat will no longer move around as you get in and out of the vehicle. [10]
    • You can also stomp on the anchor with your foot to press it down into the flooring.
    • The anchors will cut holes in the carpet underneath the mat, so it may damage the interior if you try to take them out.
  9. Use a screwdriver to turn the caps counterclockwise to loosen them from the anchors. Pull the mat out of the vehicle whenever you need to clean or work on your vehicle. When you’re finished, put the mat back and screw the caps back into the anchors in the floor. [11]
    • The caps will not fall out of the mat because the washers hold them firmly in place.
    10. Advertisement
Method 3
Method 3 of 3:

Buying New Mats

PDF download Download Article
  1. Use a tape measure to find the length of your floor mat at the longest and shortest sections. Then find the width of the mat the same way. Write down your measurements so you don’t forget them while you’re shopping for new mats.
    • The mats for your driver, passenger, and back seats may all vary slightly, so be sure to measure each one.
    • If your vehicle doesn’t have any mats, then measure the length and width of the footwells with a tape measure.

    Variation: You can also trace your old mats onto a sheet of butcher paper. Cut out the template, fold it, and bring it with you when you shop to visually compare the sizes.

  2. Take pictures of the inside of your vehicle so you can reference their colors. Opt for floor mats that have the same or similar tones so they look cohesive in your vehicle. If you’re unable to find matching floor mats, opt for something clear or black since they’re neutral colors and tend to match most vehicles. [12]
    • You may need to order floor mats online if you can’t find floor mats that are the same color in stores.
    • You may also get floor mats that have designs, such as words or sports logos, molded into them to personalize your vehicle more.
  3. Check the backs of the mats to make sure they have plastic spikes or rubber grippers that prevent them from slipping around in the footwell. Make sure the floor mats match the sizes of your old ones so they fit properly in your vehicle. [13]
    • Carpet tends to get dirty easier than other styles of floor mats.
  4. Universal rubber mats come in one size, but they have segments you’re able to cut off to make them fit. Lay your old floor mat on top of the rubber one and trace around it with a marker. Slowly cut around your outline with a pair of scissors to ensure it fits properly. [14]
    • Rubber floor mats are thick and water-resistant so they’re easy to clean.
    • Since rubber mats are thicker, they may be more likely to get caught on the accelerator pedal. Be sure to leave a 2 in (5.1 cm) between the mat and the pedal.
  5. Look for all-weather mats that are made for the year, make, and model of your vehicle, or else they may not fit properly. Move the seats and pedals back as far as they can go so you can easily position the mat inside your vehicle. The mat will press against the sides of the footwell so it doesn’t slip around. [15]
    • All-weather mats are heavy-duty and easy to clean, but they can also be the most expensive style.
    • You can buy all-weather mats from specialty automotive stores or online.
    6. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    How do I secure the mats in my car?
    Chad Zani
    Auto Detailing Expert
    Chad Zani is an Auto Detailing Expert based in Los Angeles, California. He is the Director of Franchising at Detail Garage, an automotive detailing company with locations around the U.S. and Sweden. He and his team are auto detailing experts that offer detailing and car care services.
    Chad Zani
    Auto Detailing Expert
    Expert Answer
    Buy hook-and-loop tape, then put the hook side on the mat. That way, the strips of tape will stick to the carpet underneath.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 2 Helpful 8
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!

      Warnings

      • Remove the old floor mats before you install new ones, or else they may get too thick cause the pedals to get stuck. [16]
        Thanks
        Helpful 0 Not Helpful 0
      Advertisement

      Things You’ll Need

      Attaching Car Mats to the Floor

      • Carpet tape
      • Velcro
      • Pin-in drapery hooks

      Installing New Floor Mat Anchors

      • Hammer
      • Floor mat anchor kit

      You Might Also Like

      How to
      Get Urine Out of a Car Seat
      How to
      Get the Gasoline Smell Out of a Car
      How to
      Clean a Car Ceiling
      How to
      Get the Smell of Spoiled Milk Out of Your Car Interior
      How to
      Fix Wrinkled Leather Car Seats
      How to
      Remove Odors from Your Car
      How to
      Get Throw Up Smell Out of Your Car
      How to
      Remove Vomit From a Car Interior
      How to
      Clean Car AC Vents
      How to
      Remove Soda Stains from a Car's Interior
      How to
      Make Your Car Smell Good
      14 Easy Ways to Get Smoke Smell Out of Your Car Permanently
      How to
      Remove Grease and Oil From a Car's Interior
      How to
      Make a Car Air Freshener
      Advertisement

      References

      1. ↑ https://www.globalsuzuki.com/after_sales/automobile/pdf/floormat_flyer.pdf
      2. ↑ Chris Parker. Founder, Parker Eco Pest Control. Expert Interview. 16 February 2021.
      3. ↑ https://youtu.be/BN_Z508mWLg?t=75
      4. ↑ https://youtu.be/TEF34BHP5Yo?t=55
      5. ↑ https://youtu.be/TEF34BHP5Yo?t=92
      6. ↑ https://youtu.be/AsBEEpVJyAI?t=49
      7. ↑ https://youtu.be/BN_Z508mWLg?t=142
      8. ↑ https://youtu.be/BN_Z508mWLg?t=151
      9. ↑ https://youtu.be/TEF34BHP5Yo?t=209
      1. ↑ https://youtu.be/AsBEEpVJyAI?t=65
      2. ↑ https://youtu.be/TEF34BHP5Yo?t=262
      3. ↑ https://youtu.be/Dcu7cToy00k?t=88
      4. ↑ https://youtu.be/Dcu7cToy00k?t=88
      5. ↑ https://youtu.be/HwibHxD9JFg?t=15
      6. ↑ https://youtu.be/Dcu7cToy00k?t=21
      7. ↑ https://assets.weathertech.com/assets/1/25/WT_FL___FM_Warning_67FLFMINS2_0115_ENGLISH_EU3.PDF

      About This Article

      Thanks to all authors for creating a page that has been read 65,123 times.

      Did this article help you?

      Advertisement