PDF download Download Article PDF download Download Article

Learning to make your own soda can help you save money and cut down on artificial ingredients in your soft drinks. Whether mixing up a sweet syrup to cut with carbonated water, or brewing your own sodas from scratch, making soda is a lot easier than it might seem. With a handful of simple ingredients, you can make fizzy and delicious sodas to keep your fridge stocked. See Step 1 for more information.

Method 1
Method 1 of 3:

Making Quick-Mix Soda

PDF download Download Article
  1. The easiest and fastest way to make your own soda is to create a thick flavoring and add a small amount to already-carbonated soda water. If you want to start from scratch, skip to the next method and brew your own. Making syrup saves you the trouble of messing with yeast, and works in much the same way an old-fashioned soda jerk used to work, or a modern soda machine. [1] In a saucepan, mix the following ingredients:
    • 1 cup granulated sugar
    • about 1/2 cup water
    • 1/2 cup fresh fruit juice, or two tablespoons of flavor extract
  2. Whisk vigorously to keep the sugar moving, staying careful to avoid burning it. It should melt thoroughly and form a thick syrup. Bring the syrup to a boil.
    Advertisement
  3. Turn down the heat and let simmer until half of mixture is left. It'll look pretty thick and sweet, which is good. It should be very sweet and concentrated, perfect for cutting in cold soda water. [2]
  4. Let the syrup cool and store it in an easy-access container in the refrigerator. It should be good for a few weeks, or more.
    • If you've got a sports water bottle, that would be perfect for storing. You can portion out a squirt or two of the syrup per glass of soda you want to make, and keep it nicely slotted in the fridge door.
  5. Fill a glass with soda water and add a small squirt of the soda syrup to it, mixing it thoroughly with a spoon until it becomes integrated. Give it a taste and add more if necessary, or dilute it further with more soda water. Serve chilled and enjoy. [3]
    • If you've got access to a carbonator, you can even bubble up your own soda water to streamline the process and make everything yourself. While a carbonator can cost a pretty penny, you'll be able to start making your own soda water for free. If you drink lots of it, it'll pay for itself in no time.
  6. Advertisement
Method 2
Method 2 of 3:

Brewing Soda Base

PDF download Download Article
  1. Brewing your own soda is a whole lot easier than you might think. All you need is some sugar, bottles, flavoring, and a little time. To get started on your own batch, you'll need:
    • Enough bottles to hold roughly a gallon of liquid . Old recycled plastic soda bottles work fine, as long as you clean them properly. Many soda-makers prefer the plastic bottles because they have less of a chance of breaking while the soda bubbles. Glass bottles, on the other hand, are more environmentally friendly and will last longer. Flip-cap glass beer bottles work great for making soda, as long as you keep an eye on them while they carbonate.
    • Sweetener . Using regular white sugar is fine, though alternative sweeteners like honey or agave nectar are also effective if you want to cut refined sugar from the equation. [4] You'll need about a half-cup to a cup of sugar or the equivalent in alternative sweetener, depending on how sweet you want your soda.
    • Yeast . Commercial yeasts like champagne yeast are commonly available at groceries, natural food stores, and beer outlets, and are perfect for getting your soda bubbling. Don't use bread yeast to make soda.
    • Flavoring . The sky's the limit when it comes to choosing flavors for your homemade soda. Soda extracts and fruit extracts are commonly available at home-brewing stores, in flavors like root beer, ginger, and fruit flavors. It's also just as easy to use whole raw ingredients to cook up your own flavors. Want to learn to make honey-lemon-ginger soda? We've got you covered.
  2. You'll need to let your cooked-up soda sit and bubble in the bottles for at least 24 hours at room temperature, which means you need to sterilize and wash them before you get started to kill any bacteria that will taint the soda. [5]
    • If you're using plastic bottles , soak them in a mixture of chlorinated bleach and water--1 tsp. bleach per gallon water--for at least 20 minutes. Wash the bottles thoroughly with dish soap and water to remove any traces of bleach, which will kill the yeast and hurt the carbonation process. If you don't want to use bleach, you can use a natural alternative, like Straight-A, which contains no chlorine. [6]
    • If you're using glass bottles , you can use the same method for plastic bottles, or simply boil them for at least 5-10 minutes to kill bacteria.
  3. The basic method of brewing soda is to cook up a sugary batch of flavored liquid, then add the activated yeast, and let it sit in bottles to carbonate. The combination of flavors will vary depending on what kind of soda you want to make, but the basic ratio should be about 2 cups of sweetener for every gallon of water you use in the soda, and 2 tablespoons (29.6 ml) of extract. This will form the uncarbonated base of your soda.
    • If you're using extracts for flavoring , bring the temperature to hot, but not boiling, about 100 or 110 °F (38 or 43 °C), and dissolve the sugar in the liquid. Add about 2 tablespoons (30 ml) of your flavoring extract and allow the mixture to cool for several minutes until the temperature comes down.
    • If you're using raw ingredients for flavoring , bring a gallon of water just to a boil in a large pot and add the sugar, stirring vigorously to dissolve it. Let it cook for a few minutes, stirring continuously, so the flavors infuse, then remove it from the heat and add the yeast.
  4. You've got a basic flavored drink, but now you've got to add the bubbles. When the sugary liquid has come down to around 100 °F (38 °C)--it needs to be warm enough to activate the yeast, but not so warm as to kill it--add about a 1/4 teaspoon of champagne yeast to the mixture and stir vigorously to activate.
    • Yeast, depending on the age and the potency and the climate, can be a tricky thing. When you're first starting out, you may end up with soda that's too carbonated, or soda that's too flat, depending on how much you use. Anywhere from 1/4 to 1/2 teaspoon can be an appropriate amount. It's best to err on the side of not-carbonated-enough, though, since you can add bubbles after the fact.
    • Overcarbonated soda can cause bottles to explode, which can be messy at best and dangerous at worst, especially if you're using glass bottles. For your first batch, aim for the low end of carbonated and experiment to see what works best for you.
  5. Use a sanitized funnel to pour soda directly into your sanitized bottles after adding the yeast, and cap them. Allow the bottles to sit on the counter at room temperature for at least 24 hours to carbonate fully, then put them immediately into the refrigerator. [7]
    • If you cooked up soda with raw ingredients, it might be appropriate to run the soda through a strainer to get out any sediment or hard bits that might be left at the bottom of the pot.
    • If the bottles get too warm after being filled and capped, they may pop their tops or burst. As soon as they're done bubbling at room temperature, put them in the fridge to keep them safe.
  6. After letting the soda sit for 24 hours, take a bottle outside and open it. It might fizz up uncontrollably, letting you avoid a nasty mess if you're in the yard instead of the kitchen. If you're satisfied with the carbonation and the taste, put the bottles in the fridge and enjoy them over the next week or so. After five days in the fridge, they'll tend to lose some of their carbonation and become flat. [8]
    • If the soda isn't as bubbly as you'd like it, you can let them sit on the counter for another day or two to hopefully increase the carbonation. If that doesn't work, you can also add another tiny pinch of carbonation to each bottle, if you want, to try again. Or just enjoy the sodas slightly flat and cook up another batch!
  7. Advertisement
Method 3
Method 3 of 3:

Learning Classic Soda Recipes

PDF download Download Article
  1. Because sarsaparilla bark was outlawed by the FDA a long time ago, commercial root beer is made with root beer extract. It's commonly available in homebrew stores for $3-$5, enough to make several batches of your own homemade root beer. The materials pay for themselves in the long run. Zatarain's is a common and cheap brand that's widely available, but experiment with different varieties to find one you like best. [9]
    • Add two tablespoons of root beer extract after boiling the sweetener and water, before adding the yeast. Try using brown sugar instead of white for an added molasses kick to the finished product. [10]
    • Try out other roots for unusual earthy-botanical sodas. Licorice root extract is also available that tastes delicious and surprising, especially when mixed with a little lemon rind.
  2. Orange, grape, lemon-lime, strawberry, even lemon-papaya: fruit sodas are where it's at. Adding a few tablespoons of any fruit extracts you can find will give you a great fruity summertime soda. [11]
    • Instead of using extract, start your soda base with grape juice instead of water to make authentic grape soda. It's a far cry from that fake-tasting purple stuff you can get at the store.
    • If you want to make a citrus-based soda, steep the rinds of oranges, lemons, or limes in the sugar-water mixture for several hours before straining and adding the activated yeast. You'll get the most potent flavor from the rind.
    • Consider adding a few drops of food coloring if you want the flavor to match the look.
  3. The flavors that go into Coca-Cola are almost impossible to identify and replicate for a reason--you don't become the number one selling soda for nothing. With the right combinations of food-grade essential oils added to a basic soda mix, though, you can come close to approximating the classic flavor of the most famous cola. Experiment with different combos to get the flavor as close as possible, but start with a combination of equal amounts of the following surprising flavors to get in the neighborhood: [12]
    • orange
    • lime
    • lemon
    • nutmeg
    • coriander
    • lavender
  4. It's a simple classic, cool, soothing, and refreshing. Making ginger ale from raw ginger and sweetened with honey will beat any commercial soda on the market, perfect for mixing into cocktails or drinking on ice. To make up your own ginger ale: [13]
    • Mix up a gallon of water, a cup of honey, and the juice of two small lemons in a big pot and bring to a boil. Grate at least two thumb-sized (about 2 inches) pieces of peeled ginger into the pot and let it cool for at least an hour. When the temperature has subsided, you can add the yeast and strain the ginger pieces through a strainer before bottling. Let it sit for at least 48 hours before refrigerating, and let it refrigerate for a few days for the best results. [14]
  5. Advertisement


Community Q&A

Search
Add New Question
  • Question
    Why wouldn't I just buy soda?
    Ana Smith
    Community Answer
    Some people like the experience of making soda, or perhaps they are allergic to certain ingredients used in traditional store-bought soda. I prefer making soda because I know what's going into it, and I know it's safe for me to drink without triggering any allergies.
Ask a Question
      Advertisement

      Video

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Thanks for submitting a tip for review!

      Things You'll Need

      • Heavy saucepan
      • Whisk
      • Squeeze Bottle

      About This Article

      Article Summary X

      The easiest way to make your own soda is to create a thick syrup and add it to carbonated soda water. Add 1 cup (225 g) of granulated sugar, 1/2 cup (118 ml) of water, and 1/2 cup (118 ml) of fresh fruit juice to a saucepan and bring the mixture to a boil. Whisk it vigorously as it heats up to prevent burning! Once it's boiling, turn down the heat and let the mixture simmer until it reduces by half. Let it cool, then fill a glass with soda water and add a small squirt of the soda syrup to it. Mix it thoroughly, serve chilled, and enjoy! If you want to learn how to make soda flavors, such as root beer or ginger ale, keep reading the article!

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 67,783 times.

      Did this article help you?

      Advertisement