How to Make a Fan

Co-authored by Renee Day

Last Updated: October 24, 2024

Countless numbers of school children through the years have been taught to make a simple paper fan. At its most basic, a paper fan can be made from just a single sheet of paper, but many variations exist. The folded paper fan, stacked paper fan, and craft stick photo fan can all be elegantly simple or embellished to reflect your personal style.

Method 1

Method 1 of 4:

Making a Basic Paper Fan

Download Article

1
Place a sheet of 8-inch-by-11-inch (21.6 cm by 27.9 cm) paper, wallpaper or cardstock face down on your work surface. You can use larger paper, but this size is easy to find and work with. Set the paper in portrait orientation, meaning it's taller than it is wider. ^{[1]
X
Research source}
- Practice with plain or scrap paper when you start learning. You can then switch to more decorative papers once you're comfortable with the technique.
2
Lightly draw fold lines across your paper. Using a pencil and ruler, draw vertical lines 3/4 inch to 1 inch (1.9 cm to 2.54 cm) apart. These should go straight from the bottom to top of the paper.
- For larger wall fans, move the lines apart in proportion to the paper size. Smaller fans could have smaller folds, which will make the fan seem more detailed.
Advertisement
Fold on the first line, bringing the right side of the paper toward you. Use a bone folder to press the crease firmly. You should now see a peak.
You should it in the opposite direction of the first fold, creasing the fold with the bone folder. You should now see a dip in the paper, or a valley.
You'll start seeing these dips and peaks. They should alternate between these mountains and valleys.
You should be grasping the gathered portion between your fingers, while the vertical pleats of the paper extend up and out. The paper fans out.
7
Bind the bottom of the folded strip with strong tape. Alternately, you could glue each fold to the next. Place the glue along the bottom of the fan where you've gathered it.
- If you are using glue, let it dry completely before opening the fan.
You can now use the fan or embellish it.

Method 2

Method 2 of 4:

Making a Paddle Fan

Download Article

You can leave it square, cut it into a circle, round the bottom and make the top taper for a spade shape, or cut it into a heart.
The side of the fan that will be hidden should be facing up at you.
Make sure to keep glue off the part of the stick that will extend out from the piece of cardstock.
Ensure that a good portion of the stick is extended out from the paper, so you will have a handle to hold.
This will hide the stick and create a sturdy double-sided fan. Be sure to spread glue onto the back of the handle, as well as around all edges of the fan.
Once it's dry, you can use your fan or embellish it.

Method 3

Method 3 of 4:

Making a Craft Stick Photo Fan

Download Article

You'll need a power drill, a dozen craft sticks, paint and brush (optional), a photograph (optional), a craft knife, glue, water, and embroidery floss.
2
Drill a small hole about 1/4 inch (.64 cm) from the bottom your craft sticks. Do this for the rest of your craft sticks. Make sure all the holes are drilled at the same spot on all the sticks.
- Use caution when cutting with a power drill. Wear eye protection and do the cutting on a flat surface.
This will be the top of your fan and will spread out more than the base.
4
Paint the sticks with acrylic or tempera paint (optional). Allow them to dry thoroughly.
- You may find that some colors, particularly reds, will need 2 or even 3 coats.
Make sure the sticks are touching, without any gaps in between them.
Enlarge a photograph or cut a magazine photo to the size of the sticks you measured. Make sure your image is the exact same size of the sticks when touching.
The image should completely fit over the sticks. If sticks are still visible at the sides, you should enlarge or cut a bigger image. If your photo hangs over the side of the sticks, you need to trim the image down.
Use a craft knife to score the picture lightly along the sides of each stick.
This will help keep them in order after cutting. Make sure you're numbering the back of the photo and not the picture itself.
10
Cut the photo into strips. Use a craft knife to ensure a neat, straight cut. Hold a ruler tightly against the cutting line and slide the knife along the edge of the ruler, pressing hard enough to cut through the picture.
- Be extremely careful when using the craft knife.
In a small container, mix equal parts of craft glue and water.
You'll need to brush the glue mix on the back of one picture strip. Center the strip on a stick, and brush a thin coat of the mixture on all sides of the stick and picture. Repeat this for the remaining strips and sticks. Let them dry completely.
You can check to make sure your image is correct, by spreading the sticks back out to see if they're in order.
Tie a knot in embroidery floss or 1/8-inch (.32 cm) ribbon. Thread the other end through the holes that are 1/4 inch (.64 cm) from the bottom of the sticks. Tie a knot to secure the bottom of the fan.
Spread the tops of the sticks so they lie next to one another and tie a knot in the floss while the fan is open.
Add a dot of glue to the knots and let them dry completely before opening and closing your fan.

Method 4

Method 4 of 4:

Embellishing Your Fan

Download Article

You can use a tempera or acrylic paint to decorate your craft sticks or paper. Note that if painting the paper, it's easier to paint before folding your fan. Let your paper or sticks dry completely before using.
Using glue or double-sided tape, attach bits of ribbon, lace, buttons, feathers, stickers or beads. Make sure not to add items that are heavy, since they could tear your fan.
You can easily make your fan take on a whole new shape by making a few simple cuts. While your paper is folded like an accordion, cut into the top or sides of the folds. Keep your cuts small. When you open your fan, you'll see the small cuts across all the folds. ^{[2]
X
Research source}

Community Q&A

Search

Add New Question

Question

Is this done with construction paper?

Community Answer

Yes. You just need to fold it harder. Just follow the steps, and you’re done, but it won’t appear very well.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 11 Helpful 13
Question

How can I make a hole in the sticks without using a drill?

Community Answer

A hole/paper puncher can be used for putting holes in the sticks. You can also use a nail and hammer.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 8 Helpful 18
Question

How can I do this without using a drill?

Community Answer

You may be able to use a paper punch to make the holes at the end of the sticks.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 13 Helpful 20

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Tips

Submit a Tip

All tip submissions are carefully reviewed before being published

Name

Please provide your name and last initial

Submit

Thanks for submitting a tip for review!

Warnings

Always use caution when operating a power drill or cutting with a craft knife.

Things You'll Need

Paper
Glue, stick or liquid
Bone Folder, for creasing
Ruler
Power drill
Embroidery floss or ribbon
Embellishments (optional), such as ribbons, paint, beads, buttons, photos

[1]

[2]

Log in

How to Make a Fan

Steps

Making a Basic Paper Fan

Making a Paddle Fan

Making a Craft Stick Photo Fan

Embellishing Your Fan

Community Q&A

Tips

Warnings

Things You'll Need

You Might Also Like

Expert Interview

References

About This Article

Did this article help you?

Quizzes

You Might Also Like

Featured Articles

Trending Articles

Featured Articles

Featured Articles

Watch Articles

Trending Articles

Quizzes

Explore Categories