Download Article
Download Article
Subways take a long time to complete in survival mode. and may be risky to make on a server with people who might destroy it. But if you're up to the challenge, you could be the one to let a whole city of players travel in style.
Steps
-
Choose locations for your subway stations. Keep your subway route away from oceans and surface lava. Try to avoid deserts and beaches. Since the sand will collapse into your tunnel, these biomes require major excavation.
- On a multiplayer server, make sure the route doesn't pass through anyone's basement without their permission.
-
Dig to a safe depth. In a multiplayer world, dig at least eight blocks down to reduce the chance of damage from surface explosions. In a single player world, four or five blocks down is usually fine.
- A deeper subway is impractical unless people need to move between underground locations. Always stay above block 10, since lava is very common below that level. [1] X Research source
Advertisement -
Dig tunnels in straight lines. Dig the tunnels as straight as you can between your planned station locations. Zig-zagging will not make the route shorter, and makes it hard to run down the tunnel.
- Start with one block wide tunnels. You can worry about the view after everything is in place.
-
Dig out the stations. Stations are just wider rooms that your mine carts will pass through. All you need is a rectangular space. If you're in a multiplayer world, don't connect them to the surface yet.
-
Add plenty of lighting and minecarts. The tunnels and stations should be well lit to avoid mobs spawning inside them. At each station, stock a chest or dispenser full of minecarts.
- To craft a minecart , form a U shape with five iron ingots.
- You can decorate these areas however you like, but wait until all the rails are laid. You may need to make adjustments along the way. Avoid wool and other flammable materials if lighting with torches.
Advertisement
-
Save resources with powered minecarts. If you're in Survival mode and don't have many resources, make a powered minecart by placing a furnace over a minecart in the crafting area. As long as you keep the furnace loaded with fuel, it will push the minecart ahead of it down ordinary rails. If you do have plenty of gold and redstone, move on to the next step for a smoother, faster ride.
- This type of subway cannot make sharp U-turns, and will have trouble climbing slopes. [2] X Research source
-
Stockpile powered rail system supplies instead. For top speed, you'll need one powered rail for every 37 normal rails, or one for every 7 if you want to move unoccupied storage carts. [3] X Research source You can power a flat passenger subway with as little as one powered rail for every 79 normal rails, but this will be much slower. [4] X Research source You'll also need one redstone torch for each powered rail.
- To make a normal rail, place one stick in the center of the crafting area and fill the left and right columns with six iron ingots.
- To make a powered rail, replace the iron in the above recipe with gold ingots, and place redstone dust below the stick.
- For a redstone torch, place redstone dust directly above a stick.
-
Lay out the rails. Lay out normal rails along your tunnel, but occasionally place a powered rail instead. See the instructions above to decide how frequently to place the powered rails.
- Powered rails cannot be used in turns. Use regular rails instead.
- If your subway changes altitude, you'll need to use powered rails more frequently on the incline.
-
Power the powered rails. The powered rails are off by default. To get them active (bright red), connect them to redstone power. You can use a circuit, but the simplest way is to place a redstone torch adjacent to each powered rail. The torch may be below the rail, or next to it on the same level.
-
Place stops at the stations. To make the cart stop automatically, place any solid block in the path of the rail. Place a powered rail leading up each side of this block and over the top, but do not power them. This will stop the cart when it arrives. To turn on the power and give the cart a good boost on its way to the next stop, place a button or lever on the wall next to the stop. [5] X Research source
- If you use the subway for two-way travel in a multiplayer world, consider building two sets of tracks and placing signs to prevent collisions.
Advertisement
-
Understand how pistons work on rails. This is all about timing and clever use of pistons. When you push a track with a piston, the track doesn't break — it's actually pushed aside! If that piston is a sticky piston, then you can retract the piston and the track will come back with it. That means that with good timing, you stop a minecart by using a redstone signal to expand a piston, which pushes out a rail right before the minecart hits this gap in the tracks. Unlike in the real world, the minecart won't just fly over this gap from its momentum. Instead, the cart will come to a complete stop when it runs out of track.
-
Set up the stop. Use a redstone-powered piston system to stop the minecart:
- Choose a powered rail for the minecart to stop on.
- Place a redstone-powered piston to push the rail in front of the powered rail out of the way, blocking the cart.
- Place sticky piston behind the powered rail, which can retract to pull that rail out of the way.
- Place a second sticky piston opposite the first one, with a solid block in front of it so it can push it behind the stopping minecart.
-
Make the stop automatic. Sending a redstone signal to the front piston will stop the cart, but how do you send the signal automatically? One way is to have the cart move over a detector rail. Don't place this rail in front of the pistons, and make sure the redstone dust "wire" is long enough that the pistons move after the cart has passed through. It may take some experimenting to get the timing right.
- Since the cart won't stay on the detector rail, connect the signal to a redstone comparator to maintain the signal after the detector rail is turned off.
-
Make automatic starts. To start the car again, send a redstone signal to the two sticky pistons, and to the powered rail. Suddenly, from the minecart's point of view, it has its back against a block and an open track laid out before it. Since the minecart is on a powered rail, it will move the only way it can: forward.
- You can use the same detector rail and split the signal into two branches, one longer than the other. You'll need many redstone repeaters on the "start" branch signal so it shows up about thirty seconds later than the "stop" signal.
-
Reset the track. Bring the track back to normal by cutting the redstone signal, pushing the block and rail back into place.
-
Make a multi-route system (optional). You now have a system that can transport carts back and forth between two stations. If you need more destinations, build a system of track switches: a lever with redstone leading to the curved part of the track. Have a sign with redstone lamps on each side so when you flip the switch for where to go, it changes the track and lights up the sign to indicate where the track leads.
Advertisement
-
Make a Nether Portal . Nether portals are made from burning obsidian, as described in the linked article. As you might expect, the flaming obsidian portal doesn't lead to a safe and happy place. If you have diamond equipment and are willing to face the challenges, though, the Nether can give you the fastest subway possible.
-
Plan your route. Each block you travel in the subway moves you eight blocks in the normal map. [6] X Research source It's best to build both portals before you start digging, since the portal placement on the other side won't always line up exactly.
-
Build a half-block tunnel between the two portals. Fortunately, mining goes pretty fast in the Nether. Dig out a space between your two portals, then place a floor of stone slabs, stairs, and/or glass in this space. These are the only blocks that mobs will not spawn on in the Nether. [7] X Research source This is important, since torches will not stop your subway getting overrun by zombified piglins.
- If you're building a narrow tunnel with no walkway (just a minetrack), you can use any solid materials. See below for ways to avoid mobs spawning on the track.
- The walls and ceiling can be made from any materials.
-
Avoid large spaces. Even on these special flooring materials, ghasts can spawn in an area 5 x 4 x 5 blocks. Keep the tunnels and stations smaller than this in at least one dimension to avoid this happening.
-
Place glass panes or iron bars two blocks above the floor. Leave a gap of air above the floor, then place glass panes or iron bars above that. Mobs can spawn on rails even if they're placed on slabs. These blocks will prevent this from happening. Unlike solid blocks, the glass or iron will not suffocate the passenger as you ride. [8] X Research source
-
Lay down your rails. Normal and powered rails work just as they do in the normal world. Once they're placed, you should have a safe and scenic journey through the lava-flooded nightmare realm. Enjoy!
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- Building the rails on ice can speed your subway even faster.Thanks
- When building, take lots of sand and gravel with you, so you can fill up any caverns that spawn along the path of your railway.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
References
- ↑ http://minecraft.gamepedia.com/Lava
- ↑ http://minecraft.gamepedia.com/Minecart_with_Furnace
- ↑ https://www.youtube.com/watch?v=xiA6gCVZwN4
- ↑ http://minecraft.gamepedia.com/Tutorials/Minecarts#Powering
- ↑ https://www.youtube.com/watch?v=iOKV362qJX0
- ↑ http://minecraft.gamepedia.com/The_Nether
- ↑ https://www.youtube.com/watch?v=95pA9r34NEg
- ↑ https://www.youtube.com/watch?v=95pA9r34NEg
About This Article
Thanks to all authors for creating a page that has been read 75,263 times.
Advertisement