Download Article
Download Article
The magic circle, or Mobius strip, named after a German mathematician, is a loop with only one surface and no boundaries. [1] X Research source A Mobius strip can come in any shape and size. If an ant were to crawl along the surface of the Mobius strip, it would walk along both the bottom and the top in an infinite loop. You can easily construct and experiment with a Mobius strip using paper, scissors, tape, and a pencil.
Steps
-
Cut a strip of paper about 6 inches (15 cm) long and 1.5 inches (3.8 cm) in width. When cutting the strip, the measurements do not need to be accurate, these are just suggested. Try to keep the width even so that you have a long thin rectangle.
- To simplify the process, you can simply cut down the edge of a plain sheet of paper to make your strip.
-
Label the corners of the strip A, B, C, and D. In the top left corner of the strip, write a small letter A; in the top right corner, write a small B; the bottom left, the letter C; and the bottom right, the letter D. You will use these letters to align the strip after the twist. [2] X Research source
- The size you make the letters doesn't matter, but the position of each one is important for the twist step.
Advertisement -
Twist the A-C side a half turn and bring it to the B-D side. Hold the two ends in your hands, give the A-C side of the strip a half twist and join it to the B-D side. Match the letters, A to D and B to C and tape the edges together. Once the edges are taped, you have completed the Mobius strip. [3] X Research source
- You can twist the paper more than one time and still have a Mobius strip. [4] X Research source
Advertisement
-
Draw a line along the middle of the strip. Using a pen or pencil, start at any point in the middle of the strip and draw a line all the way around without lifting your pen. Eventually, the pen will end up back at the point you started drawing. You have drawn a line on both sides of the loop - but without lifting your pen or crossing any edge. How did this happen? The paper has only one side! [5] X Research source
- Start at a different point in the Mobius strip and see if the same thing happens.
-
Color the edge of the strip with a highlighter. Take a highlighter and start coloring the edge of the Mobius strip without lifting the highlighter from the strip. Continue with the marker until you reach the point at which you started. You'll find both edges are colored. This indicates that the Mobius strip has only one edge!
-
Cut the Mobius strip along the central line you drew earlier. With a pair of scissors, poke a hole into the middle of the Mobius strip and cut along the line until you reach the beginning cut. It does not, as you'd expect, fall apart into two separate loops; instead you now have a single, larger one-sided loop! [6] X Research source
-
Cut the Mobius strip 1/3 of the way away from the edge. Like you did cutting through the center line, take the scissors and this time, cut about 1/3 of the way from the edge of the strip. Continue cutting until you reach the original cut. [7] X Research source
- When you have finished cutting, you should have one small ring and one larger ring that are connected together.
Advertisement
Community Q&A
Search
-
QuestionWhen I cut down the center as suggested above I get one large Mobius circle, not 2 interlocking ones.Community AnswerCut down the center of the Mobius strip again and then you will have 2 interlocking ones.
-
QuestionHow do I cut to make three rings interconnected?Community AnswerCut a Möbius strip down the center, making two interlocking Möbius strips. Do the same thing with one of those two; you now have three interlocked.
-
QuestionCan I make a Mobius band from a sheet of A4 paper? As in, no cutting or anything, just twisting and bringing the short edges together exactly as with the long, thin rectangle?Community AnswerThe problem will be making the required twist without tearing the paper. I think you'll need a sheet considerably longer and/or narrower than the A4 dimensions. A 4:1 length:width ratio is doable, but maybe you'd need more or less depending on what type of paper you use; stretchier materials are better than stiffer ones.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Things You'll Need
- Scissors
- Tape
- Paper
- Pen
- Highlighter
References
- ↑ https://wonderopolis.org/wonder/What-Is-a-M%C3%B6bius--Strip
- ↑ https://www.physics.wisc.edu/ingersollmuseum/wp-content/uploads/sites/10/2020/04/Mobius-Strip-Activity-2-pages.pdf
- ↑ https://www.physics.wisc.edu/ingersollmuseum/wp-content/uploads/sites/10/2020/04/Mobius-Strip-Activity-2-pages.pdf
- ↑ https://www.fleet.org.au/blog/mobius-strip/
- ↑ https://www.snexplores.org/article/scientists-say-mobius-strip-definition-pronunciation
- ↑ https://www.youtube.com/watch?v=XlQOipIVFPk
- ↑ https://www.youtube.com/watch?v=f-19NLKxNUc
About This Article
Thanks to all authors for creating a page that has been read 134,494 times.
Reader Success Stories
- "I'm crocheting a Mobius-style cowl. My pattern didn't explain the 180 twist in the strip, but the marked spots A/C and B/D in the video helped me see how to turn my work before joining the edges. My finished piece will have 15 rows, yet appear to have 30." ..." more
Advertisement