Download Article
Download Article
The monkey fist is a type of knot that can be used as a decorative knot or as a weight at the end of a rope. Getting the hang of successfully tying the monkey knot comes with practice and patience. Go slowly and stay patient.
Steps
-
Hold the rope correctly. Place the rope over the edge of your open left hand. The short tail should be over the front of your hand. The rest of the rope should be behind your hand.
- The long portion of your rope is the working end. This is the portion you will use to create the knot.
-
Wrap the rope vertically. Grab the long tail, or working end, and wrap it around your fingers three times. [1] X Research source
- Start the first wrap on the area of your fingers closest to your palm. Each successive wrap should be closer to the tips of your fingers.
- Try wrapping the paracord around your first three fingers, or even just your first two to make it easier. [2] X Research source
Advertisement -
Slide the coiled rope off your hand. Be sure that you maintain the orientation. Keep this same hand positioned so the loops hold.
- With your free hand remove the rope from the hand you wrapped it around, keeping the first set of turns in place.
- Keep the first three turns intact by pinching the rope together with your forefinger and thumb.
- You can also keep the rope on your hand if you wish and thread the next horizontal loops through your finger. [3] X Research source
-
Wrap the rope horizontally. Grab the long tail and wrap it perpendicularly around the three vertical loops just created. Do this three times. Each subsequent horizontal strand should be above the last. When done, you should have three turns of rope looped vertically and cinched loosely by three horizontal wraps.
- Do not pull tight, these wraps need to be loose.
- Finish the horizontal turns by creating a loop, with the remainder of the rope, going through the three vertical strands. Here, you’re taking your final turn and passing through the middle, not the outside. [4] X Research source
-
Make three more vertical turns. Again grab the long tail and wrap it around the three newest horizontal strands. Pass the rope through the opening. Go over the horizontal wraps but between your first three vertical loops. Continue with this motion three times.
- Weave the rope through the top and out the bottom.
- You should notice the monkey fist shape coming into place.
-
Insert a marble. To add an extra weight to your monkey knot, add a small marble to its center. This is an optional step, but it is recommended for a sturdy monkey knot.
- Any small spherical object will work. But a marble is easiest to work with.
-
Tighten the Monkey’s fist. Spend a few minutes gently tugging each loop to tighten your knot. Start with the first loop you cast and end with the last.
- You have to cinch the slack by tightening each loop in the order in which you created it. Start with the vertical loops, then the horizontal loops, then the last set of vertical loops.
Advertisement
-
Create the monkey fist. First you’ll need to construct a standard monkey's fist with three strands.
- Leave enough slack on the tail to create the additional hangman's noose for the keyring.
- Make sure you also have a keyring for your keychain.
-
Create a hangman’s noose using the other side of the paracord opposite your monkey fist. Create an even "S" shape with the remainder of the slack.
- Now wrap the monkey fist around the S-shaped portion of rope three times, Like you would when making a monkey's fist.
-
Place the monkey fist through the loop’s opening, the hole in the noose. Take the loose strand and wrap it three times around, moving up towards the hole.
- Super glue the wraps to keep a firm hold.
- Cut off any excess rope.
-
Weave a keychain into your paracord. Take a keyring and weave it around the hole you’ve created from the bottom of the monkey fist.
- Once you’re done you can attach it to your keys or pass it on to a friend.
Advertisement
-
Position the rope. Place the rope over the edge of your open left hand. The short tail should be over the front of your hand. The rest of the rope should be behind your hand.
- Give yourself enough length of paracord with the short tail so that its doesn’t slip out of your monkey fist.
- Pull the short end down far enough so the it goes just passed your bottom finger.
-
Wrap the rope vertically five times. Grab the long tail and wrap it five times around your fingers.
- Each successive wrap should be closer to the tips of your fingers.
- On the final wrap you will loop around your finger before wrapping the paracord around the back of your fist, then drawing it around toward you.
-
Slide the coiled rope off your hand. Be sure that you maintain the orientation. Keep this same hand positioned so the loops hold.
- Alternatively, if you find it easier you can keep the paracord on your fingers. You’ll just have to loop the horizontal turns between your finger and palm.
-
Wrap the rope horizontally five times. Grab the long tail and wrap it perpendicularly around the five loops just created. Do this five times.
- Each subsequent horizontal strand should be above the last. When done, you should have five strands of rope looped vertically and cinched loosely by five horizontal wraps.
- Finish this portion of the fist by wrapping the last loop around the vertical strand.
-
Change directions to vertical. Again grab the long tail and tuck it above the five newest horizontal strands facing you, and follow through underneath. Continue with this motion five times. Weave through the top and out the bottom.
- You want to wrap your paracord in between your first vertical loops but over and under your horizontal ones.
- Finish this portion of the monkey's fist by wrapping the last loop around the original vertical strand.
- Insert a large marble. To add an extra weight to your monkey's fist, add a large marble to its center. For the five strand monkey knots, you’ll need something in the core to add to the bulk of the fist.
-
Snug up. Spend a few minutes gently tugging each loop to tighten your knot. Start with the first loop you cast and end with the last.
- You have to slowly tighten each part of the paracord in succession.
Advertisement
Video
Expert Q&A
Search
-
QuestionHow do you use a monkey fist?Lindsey Campbell is an artist and instructor behind Hello Hydrangea, a modern fiber company specializing in custom home decor and weaving supplies. She has taught over 2500 students how to weave craft through her online video classes. Lindsey's work has been featured in Design*Sponge, Huffington Post, and Vintage Revivals, and she has designed products for JoAnns Crafts, Anthropologie, and Nordstrom.Display your Monkey's fist to show off your work! Monkey's fists are mostly decorative. You can use a thick rope to create a big knot and display it on a table or in a bowl, for instance. Since they have the loop at the top, you can also hang it straight on the wall. You can also create a long loop and turn the Monkey's fist into a necklace.
-
QuestionCan you do the monkey knot without a marble or a ball?Community AnswerYes, but will be small - which means it is easy to conceal and still packs a punch.
-
QuestionWhat supplies do I need?AnjaliCommunity AnswerParacord (you can use shoelaces, string or yarn as a substitute), a marble, and a keyring (optional).
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- Making yourself a jig is the better way to go when making a monkey fist.Thanks
- Tying off the strings with a simple snake knot or lanyard knot will add character as well as making it easier to finish your lanyard or key fob.Thanks
- There are multi-colored monkey fists that follow the general weaving steps but there are also two techniques not mentioned as of yet.Thanks
**Double colors use a technique that requires a tube to weave around, as does the triple colored technique. I would suggest watching youtube channel Fusion Knots as well as Paracord Guild for all your paracord instructional how to instructions.
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
References
About This Article
Article Summary
X
To make a standard three loop monkey fist, hold the rope in your open hand so that the short tail is in front of your hand. Loop the long end of the rope around your fingers 3 times, then carefully slide this loop off of your fingers. Wrap the long tail perpendicularly 3 times around the loops you just created, but do not pull these loops tight. Loop the remainder of the tail 3 times around the newest loops you made, but inside the 3 original loops. If you like, place a marble in the center of your knot, then gently tug each loop to tighten your knot. If you want to learn other monkey fist knots, such as a five strand monkey fist or a keychain, keep reading!
Did this summary help you?
Thanks to all authors for creating a page that has been read 396,006 times.
Reader Success Stories
- "Just curious how it was done. I was raised on a Navy base and saw them and always wondered how they were made."
Advertisement
80%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"Just curious how it was done. I was raised on a Navy base and saw them and always wondered how they were made."
"It's a little confusing, but otherwise very informative."
"I liked the detailed pictures. It was very helpful."
"Gives me a good, friendly idea of how to proceed."
"I defended myself, guys! Thank you for the help."
