Download Article
Download Article
When bending pipes or tubes, it is important to make correct measurements. Any mistake at this stage will result in an incorrectly bent pipe or tube, and in many cases, is an irreversible scenario. In other cases, it is time-consuming, and can deform your pipe or tube permanently.
Steps
Download Article
-
Estimate the overall length of the pipe. Depending on the length of the bends and the length of the spaces between them, determine the total length of pipe or tubing you require. Ensure that a couple of inches (or centimeters) of margin is available to accommodate any errors in calculation or judgment. [1] X Research source -
Measure the distance for the first bend. From one end of the tube, mark the point for the first bend. Here, you need to carefully mark the beginning and the end of the bend. You also need to measure the distance between the bends. [2] X Research sourceAdvertisement -
Measure the distance for the second bend. Repeat the previous step, but use the vertex of the first bend as the reference/ starting point instead of the end of the tube or pipe. The vertex is the exact point where the two legs of an angle intersect. [3] X Research source- Alternatively, you can use the initial reference point (the end of the tube) to measure the distance for all bends.
-
Measure more bends. Repeat the previous step for measuring more bends. Always mark the exact spots as you go along. [4] X Research source -
Measure reverse bends. Repeat step 2, but mark the direction of the bend. It is the same process except that the direction of the bend differs. You also need to deduct the gain. -
Compensate for spring back when measuring. All tubes and pipes, irrespective of material, experience some amount of spring back. It is dependent on the material, the angle of the bend, and the radius of the bend. This can be compensated for by using two methods:- With experience and the right methods, you can estimate the amount of spring back and over bend the tube; or
- You can wait for the spring back to occur, measure the angle and then bend the tube accordingly.
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- Use a piece of scrap pipe or tubing to check your calculation and the resulting product.Thanks
- Use the correct formula to calculate the circumference of the bend. For example, the formula used when making a 90˚ bend is: Circumference = (pi*2*r) / (360/90).Thanks
- When bending, take into account the ability of the material to bend and sustain the bend. It should also not break during the process or later in application.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Read the manual thoroughly before using the equipment.Thanks
- Do not attempt to use any machinery without proper guidance.Thanks
- Make sure you are well equipped with the relevant safety gear.Thanks
Advertisement
References
- ↑ https://www.huffpost.com/entry/tape-measure-trick-accurate_n_5640a959e4b0307f2cadfd75
- ↑ http://www.ultimatehandyman.co.uk/how-to/plumbing/complex-pipe-bending
- ↑ http://www.ultimatehandyman.co.uk/how-to/plumbing/complex-pipe-bending
- ↑ https://www.thefabricator.com/thefabricator/article/tubepipefabrication/tube-and-pipe-basics-how-to-achieve-the-perfect-bend
- https://sciencing.com/how-5272411-measure-pipe-bend-radius.html
About This Article
Thanks to all authors for creating a page that has been read 83,915 times.
Advertisement
