Download Article
Download Article
Have you ever wanted to do an Ollie on a Tech Deck or fingerboard, but didn't know how? Or are you someone who has to do tricks with 3 fingers and not 2? With a little practice, you can pull off an ollie on a fingerboard with three fingers, no problem at all.
Steps
-
Place your index finger right behind the front screws.
-
Place your middle finger right behind the Tech Deck logo.Advertisement
-
Place your ring finger on the back of the board.
-
Smack down the tail of the board and at the same time try to move the board forward while keeping your fingers on the board.
-
Land the board while still coming forward.
-
Ride away looking cool while your friends stare in awe.
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- If you are new to Tech Deck, this could take some time.Thanks
- Tighter trucks make ollies easier.Thanks
- Don't practice at school. Teachers may take Tech Decks away during class hours.Thanks
Tips from our Readers
The advice in this section is based on the lived experiences of wikiHow readers like you. If you have a helpful tip you’d like to share on wikiHow, please submit it in the field below.
- Use your tech deck in open areas without objects in the way at first. Classrooms can be risky since teachers may confiscate boards during lessons. A counter at home is a good practice spot.
- Things like wheel shape and grip tape can impact maneuverability when learning tricks. Consider upgrades like wood boards, rubber bearings, and foam tape for best results.
- If you're having trouble getting the board off the ground, make sure to really snap the tail down to pop it upward. Use a pencil to visualize clearing an obstacle.
- For the most realistic experience, learn tricks with 2 fingers to mimic a skateboarder's feet. Once you master basics like ollies this way, you can try 3 fingers.
- Don't stress too much while learning. Ollies take practice. Find a soft surface at first, then move to harder surfaces once you get comfortable with the motion.
- Take it slow as a beginner fingerboarder. Master ollies first before moving onto kickflips and other tricks. Walk before you run!
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- After a while of using your fingerboard, the bolts could become loose. As soon as it gets wobbly, you must use your tool to tighten it. If you lost it, twist it tighter with your finger or use a bobby pin. Other variations you can try is a twist it with the end of a pen, or tack a hole in the eraser of a pencil and tighten it with that. But the point is, if it's wobbly, tighten it! Because if you don't you could lose the nut, and that won't be good (unless you have a spare)!Thanks
- Don't slam your board really hard down to the ground. It could break in half!Thanks
Advertisement
Things You'll Need
- Tech deck (or just any other fingerboard works)
- Hard flat surface
- Something to ollie over (optional)
- A ramp (optional)
About This Article
Thanks to all authors for creating a page that has been read 202,640 times.
Advertisement