Download Article
Two easy methods for removing iron patches from home
Download Article
Iron-on patches are attached to fabric with a heat-activated or "fusible" adhesive. While these patches are easy to apply, they can be much more difficult to remove. Additionally, removed patches tend to leave behind unsightly glue residue. Luckily, there are a few tricks you can use to remove iron-on patches
Things You Should Know
- Place a piece of wax paper or a thin cloth towel over the patch, iron over it, and then gently remove the patch.
- Apply fabric-safe adhesive remover to the patch (which will loosen the glue), lift the patch, and repeat this process on stubborn, stuck-on portions of the patch.
- Lift leftover residue with more adhesive remover, a wash in the laundry machine, or white vinegar.
Steps
-
Check to see if your item can take the heat. Unless you added the patch yourself, you will first need to make sure your item won't be damaged by ironing it. Not all "iron on" patches are actually applied with heat.
- Pick a small, inconspicuous part of the item not easily visible during normal use.
- Place wax paper or a thin dish towel on top of the area.
- Press down with a pre-heated iron on the small area you're testing. Hold it for about 15 seconds.
- Remove the iron and check for damage or discoloration on your item.
- If you are treating a delicate item, make sure the iron is on the proper setting. If you don't have experience ironing this type of fabric, the adhesive remover method is probably a better idea.
-
Cover the patch. Position your item so that the cloth part of the patch is exposed. Place either wax paper or a thin cloth towel directly over the patch. Make sure the covering is completely clean and free from any substance that could melt into the fabric of your item.Advertisement
-
Iron the patch. Pre-heat your iron to its highest setting before use. Press your iron down on top of the paper/cloth where the patch would be. Hold it there for about 15 seconds. Remove the iron and the covering from your item.
- If the glue does not appear to have softened, apply the iron again. Keep adding heat until the adhesive melts.
-
Peel the patch off. The heat from the iron should be enough to melt the glue and temporarily make it sticky. Lift the edge of the patch up and peel it off of your item.
- Hold onto the item with one hand and peel with your other.
- You can use your fingers to do this, but be cautious, as the adhesive will be hot.
- If you have trouble lifting up the first part of the patch, try using tweezers or a butter knife. Tweezers will be able to slide between the patch and your item and grip the patch well. If you don't have tweezers, slip a butter knife between the patch and your item. Lift up to start the patch and remove the rest of it with your fingers.
- If the patch is large, you may have to make a few passes with the iron. Peel up large patches section by section. [1] X Research source
Advertisement
-
Purchase a fabric-safe adhesive remover. Glue removers that are xylene or orange oil-based work well. Pick a liquid-based product able to soak through fabric. An adhesive remover that comes in a spray bottle will be much easier to work with for this purpose. Common brands are Goo Gone, De-Solv-It, and Goof Off.
- Rubbing alcohol can also be an effective alternative. [2]
X
Research source
[3]
X
Expert Source
Rani Gorgis
Laundry & Cleaning Specialist Expert Interview. 7 April 2021.
- Rubbing alcohol can also be an effective alternative. [2]
X
Research source
[3]
X
Expert Source
Rani Gorgis
-
Patch test your clothing. Even if the adhesive remover is advertised as fabric safe, it is still possible that it may stain your particular item. You will need to test it out first before using the remover on a patch. Do this over a clean sink to avoid making a mess.
- Find a small, inconspicuous area on your item that is not easily visible during normal use. For example, the inside back bottom edge of a hat or jacket would be a good choice.
- Dab a small amount of adhesive remover onto this spot.
- Work the adhesive remover into the fabric using your fingers or a clean rag.
- Rinse off the adhesive remover and check for discoloration.
-
Expose the area underneath the patch. If your item is a T-shirt, a hat, or a pair of paints, turn it inside out. You will need to access the fabric that is bonded to the patch. If your item is a canvas bag, simply lay it out flat upside-down.
-
Apply your adhesive remover. Squirt or pour the glue remover liberally on the back of the cloth. Use enough that is soaks through your item completely. Make sure you cover the whole area behind the patch. Work the remover into the fabric using your fingers, a cotton ball or a clean rag. Wait about one minute for the remover to loosen the patch. [4] X Expert Source Rani Gorgis
Laundry & Cleaning Specialist Expert Interview. 7 April 2021. -
Peel off the patch. The adhesive remover should successfully soften the glue, making it sticky. The patch should now easily come off your item. [5] X Expert Source Rani Gorgis
Laundry & Cleaning Specialist Expert Interview. 7 April 2021.- Turn the item right-side-out. Hold it with one hand.
- Grip the edge of the patch between the index finger and thumb of your other hand.
- Pull back to lift the edge of the patch up and off your item.
- Work your way around the patch until it has been entirely peeled away.
-
Repeat on any stubborn areas. If part of the patch is still stuck to your item, try repeating the process, focusing on the spots where the adhesive did not soften properly.
- Reapply the adhesive remover however many times it takes to completely remove the patch. However, if the glue remover you used has not softened the adhesive at all, you will likely need to try a different one.
- If you don't plan on keeping the patch, trim off what you've already peeled off with a pair of scissors. This will make it much easier to work with and keep the patch from sticking back onto your item.
- You can also brush the iron-on patch using a lint or wire brush. [6]
X
Expert Source
Rani Gorgis
Laundry & Cleaning Specialist Expert Interview. 7 April 2021.
Advertisement
-
Check for stains. The glue from your patch will likely leave a residue behind. If the area where your patch was is now discolored or sticky, you will need to take further action to make your item looking clean and like new again.
- If you used the adhesive remover method, launder your item first. This may remove the adhesive completely on its own.
-
Apply adhesive remover directly to the residue. Squirt or pour more adhesive remover onto the patch. Massage it in using your fingers or a clean rag. Allow it to work for approximately one minute.
- You can also make your own adhesive remover at home. Just mix two parts baking soda with one part coconut oil and a few drops of orange essential oil. [7] X Research source This all natural adhesive remover works well at removing residue but not for removing the patch itself. It is a thick paste that is unable to easily soak through fabrics.
-
Launder your item as usual. Simply wash your item using whatever method you normally would. Do this as soon as possible to remove the solvent in case it may damage your item over time.
- If the item is machine wash safe, go ahead and throw it into your washing machine with a normal load of laundry.
- Hand soak delicate items using cold or room temperature water with a small amount of detergent.
- If the glue seems especially stuck-on, try scrubbing it with a soft toothbrush after the adhesive remover has been worked in.
- Apply some liquid laundry detergent directly to the residue patch as a pre-treatment.
- If there is still some residue left after you've washed your item, try repeating the process with more adhesive remover. It may take a few tries to totally remove the stain.
- Do not place the item in the dryer until the stain has been completely removed. Doing so may set the stain and make it harder to clean. [8] X Research source
-
Use white vinegar for especially tough stains. [9] X Research source White vinegar often works to loosen glue enough for water to rinse it away.
- Before soaking, first try saturating the spot with white vinegar and wash as normal. This works well for delicate items with caked-on glue from the iron method.
- If spot treatment doesn't work, try soaking your item overnight. For white items, you may use undiluted vinegar. To keep colored fabric from bleeding, dilute the vinegar in water using one cup of vinegar per gallon of water.
- While white vinegar is generally safe to use on clothing, always be sure to do a patch test first to be sure.
- Use white vinegar only. Other types may stain clothing.
Advertisement
Expert Q&A
Search
-
QuestionHow do you remove iron-on transfers from clothing?Rani Gorgis is a Laundry and Cleaning Specialist and the Owner of Park Blvd Laundry & Dry Cleaners in San Diego, California. With several years of experience in the laundry and cleaning industry, Rani specializes in dry cleaning, wash-n-fold, shirt laundry, and servicing smoke-damaged clothes. He holds a BS in Accounting and a CPA certification.Double-check your garment's care label before heating the fabric in the dryer for a few minutes. Then, with a bit of rubbing alcohol or solvent, dab the iron-on transfer with the tips of your fingers or a cotton ball. Let it soak for a bit, and then brush the iron-on transfer using a lint or wire brush. In some cases, it may peel off on its own, and you can scrape it off with a utensil.
-
QuestionWhat can I do to remove residual glue left behind by the patches?Community AnswerThere is adhesive remover that you can use that's sold in fabric stores.
-
QuestionWhat do I do if my paint was burned by an iron and became patchy?Community AnswerIf you iron a painted/printed design, chances are it probably can't be saved.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- If using an iron and adhesive remover together, exercise caution. Many types of adhesive removers are flammable. [10] X Research sourceThanks
- Use the adhesive remover to get rid of glue residue on your iron. Wait for it to cool, apply goo and wipe off.Thanks
- If the iron patch test causes discoloration, use adhesive remover instead, and vice versa. Because clothing is made using many different dyeing methods and colors, it's very difficult to determine which method will work best knowing fabric type alone.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Expert Interview
Thanks for reading our article! If you’d like to learn more about laundry tips, check out our in-depth interview with Rani Gorgis .
References
- ↑ https://www.youtube.com/watch?v=9z4aemfDdAc
- ↑ https://ccetompkins.org/resources/stain-removal-guide
- ↑ Rani Gorgis. Laundry & Cleaning Specialist. Expert Interview. 7 April 2021.
- ↑ Rani Gorgis. Laundry & Cleaning Specialist. Expert Interview. 7 April 2021.
- ↑ Rani Gorgis. Laundry & Cleaning Specialist. Expert Interview. 7 April 2021.
- ↑ Rani Gorgis. Laundry & Cleaning Specialist. Expert Interview. 7 April 2021.
- ↑ https://www.beyondtoxics.org/wp-content/uploads/GreatNaturalMoldCleaners-Instead-of-Bleach.pdf
- ↑ https://www.cleaninginstitute.org/cleaning-tips/clothes/stain-removal-guide
- ↑ https://www.cleaninginstitute.org/cleaning-tips/clothes/laundering-problems-solutions
About This Article
Article Summary
X
To remove iron-on patches, start by placing a clean cloth or piece of wax paper over the patch. Then, press down on the patch with a heated iron for 15 seconds, which will melt the glue. After 15 seconds, remove the iron and peel the patch off. If the patch won't come off, reapply the heat until the glue on the patch is melted enough. To learn how to remove leftover residue from an iron-on patch, scroll down!
Did this summary help you?
Thanks to all authors for creating a page that has been read 417,363 times.
Reader Success Stories
- "I really like a sweatshirt I've had for a while, but the logo on the back is outdated and I would like to get rid of it. I am looking forward to trying your suggestions. It amazes me how many topics are covered on the internet. Thanks for providing this." ..." more
Advertisement
"I really like a sweatshirt I've had for a while, but the logo on the back is outdated and I would like to get rid of it. I am looking forward to trying your suggestions. It amazes me how many topics are covered on the internet. Thanks for providing this."
..."
more
"I was not sure If I could take the logo off my shirt and jacket. This gives me the incentive to try."
"Confirmed my thoughts to heat the patch to remove."
"Saved an expensive shirt from a former job. "
"Very helpful, thank you."
