PDF download Download Article PDF download Download Article

Whether it’s from roads and sidewalks in the winter, or from the air and water near the ocean, salt can be a problem for manmade materials. Salt buildup often occurs on the zippers of scuba gear, boots, tents, and certain boating materials, like curtains. Zippers should be cleaned of salt buildup so that they don’t stick or corrode. There are multiple tactics you can use to remove salt from zippers and keep your items in working condition.

Method 1
Method 1 of 3:

Using Fresh Water

PDF download Download Article
  1. This should ensure that you use the cleaning methods in every bit of the zipper possible. Use your fingers to hold the zipper by the pull and tug up and down. Try using needle nose pliers to hold the zipper by the slider or “car” and try to move that up and down.
    • Don't be too rough with it so that the zipper doesn’t break or get off track.
  2. If the zipper is stuck, try rubbing it with beeswax or a block of paraffin wax before cleaning it. You can find such items at health stores, hardware stores, and some supermarkets. [1]
    • If you’re outdoors without access to additional supplies, try using a bar of soap or candle wax to loosen the zipper, if you have one of those on hand.
    Advertisement
  3. Sometimes salt will dissolve in freshwater. Wash the zipper under a tap or hose. Alternately, you can use a bucket of warm water. [2]
    • Try using a small wire brush to scrub the zipper with water. Make sure that the brush is small enough or positioned so that the brush does not damage the material the zipper is attached to.
  4. Use a non-detergent soap solution in a bucket of warm water. Use a stiff brush to scrub the zipper. [3]
    • Make a fresh soapy water solution by adding five tablespoons of soap powder to 20 liters of water. Stir it in a bucket until it’s sudsy. Dispose of any leftover solution once finished. [4]
  5. Advertisement
Method 2
Method 2 of 3:

Using Vinegar and Other Products

PDF download Download Article
  1. Pour white vinegar into a bowl or container. Wet a soft-bristled toothbrush in the vinegar. Rub the zipper gently but thoroughly with the toothbrush, on both sides of the zipper. [5]
  2. You can use cola or lemon juice. Dip a toothbrush or cotton swab into the liquid and apply it to the zipper. Let it sit for a couple of minutes. [6] Make sure to wash the area completely with water afterwards.
    • The phosphoric acid in cola breaks down and combats corrosion.
    • Lemon juice contains the cleansing agent citric acid.
  3. Use a container of white vinegar or a vinegar and water solution. Add a small amount of baking soda (a sprinkle). Try to submerge only the zipper itself, if possible. If not, make sure that the material surrounding the zipper won’t be damaged by soaking it in vinegar. Either look it up or try soaking a test piece of material first.
    • If you're having a salt encrustation issue with scuba gear, take off any parts you can that are not connected to the suit such as hooks, swivels, etc. Depending on how the zipper is mounted on your bag, you may be able to simply submerge the zipper and not the rest of the suit.
  4. There are various products, for example using silicone or wax, which are specifically designed for loosening stuck zippers. You can find these online, at marine supply stores, and at some auto parts stores. Typically the products are either in tubes or sold as sprays.
    • Follow the instructions of the lubricant product. Some lubricants are applied to all parts of the zipper, whereas others are for the outer teeth only.
    • Apply the lubricant at room temperature. Use the zipper slider a few times to fully distribute the lubricant. [7] Wipe off any excess lubricant.
  5. Advertisement
Method 3
Method 3 of 3:

Preventing Future Problems

PDF download Download Article
  1. Make sure the cloth is completely clean so you don't end up clogging up the zipper further. Wipe the zipper thoroughly to remove any excess water or residue. [8]
  2. This can cause corrosion or mildew. Hang up dried garments or fold them loosely to air dry. Alternately, you can air dry items with compressed air. [9]
    • If your item is a tent, allow it to fully air dry before putting in a bag for storage. Don’t put tents in driers, as they can damage the waterproof coating.
  3. Wash items like drysuits after use to prevent salt residue from damaging fabric and building up on zippers. Rinse or wipe down boots well after they’ve been exposed to salt. Keep tents clean. [10]
    • In addition to regularly washing your items, apply a lubricant to the zippers once or twice a year.
  4. Advertisement


Expert Q&A

Ask a Question
      Advertisement

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!

      Warnings

      • Don’t use steel wool. Small pieces of it can break off and further corrode the zipper.
      • Avoid using WD 40. You can risk damaging the zipper if you don’t know exactly what the zipper is made out of, the type of material surrounding the zipper, and their compatibility with high-grade aliphatic petroleum spirit. WD 40 damages certain types of rubber. It also has potentially damaging effects to many types of material including plastic, neoprene, steel, copper, brass, nickel, zinc and various metals and hard surfaces.
      • Don’t use greasy, petroleum-based products like Vaseline on the zipper. This can encourage dirt buildup.
      Advertisement

      About This Article

      Article Summary X

      If you need to remove salt buildup from a zipper, use your fingers or a pair of pliers to tug the zipper open as much as possible. If it’s stuck, rub a little wax on the zipper to try to loosen it so you can open it more. Once the zipper is open, rinse the zipper in fresh water to dissolve most of the salt. If you need to, use a small wire brush to scrub the zipper. For stubborn salt stains, add a little soap to the water, or try dissolving it with a vinegar solution. Keep reading to learn how to make the vinegar solution for your zipper!

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 199,035 times.

      Reader Success Stories

      • Duncan Brown

        Aug 28, 2019

        "My nephew has a very expensive board bag which is shut tight. Not only did this help show what would work, it ..." more
      Share your story

      Did this article help you?

      Advertisement