How to Remove a Kitchen Sink

PDF download Download Article
Steps for disconnecting, detaching, & removing your sink
PDF download Download Article

Few household fixtures are used as much as kitchen sinks. They are clearly essential to a good working kitchen. After years of wear and tear, however, kitchen sinks can become outdated, stained, and even start to leak. A new sink can solve these problems, updating the look and function of your kitchen, but first you have to figure out how to get rid of the old one. Follow these steps to learn how to remove your old kitchen sink.

Replacing a Kitchen Sink

Turn off the garbage disposal and the water to your sink. Then, disconnect the water supply lines, drain pipe, and garbage disposal. Use a utility knife to cut through the caulking around the sink. Then, remove any screws and pull out the sink.

Part 1
Part 1 of 2:

Disconnecting Your Sink

PDF download Download Article
  1. Kitchen sinks come in 2 basic designs: under-mounted, which are attached to the countertop from underneath, or drop-ins, which simply drop into the sink opening in a countertop. There are only slight differences in how you remove each kind of sink and they will be explained as you go through the steps.
  2. Most of your work will be done here so clean out everything you can from this space. It will give you more room to move around and more space to place a bucket or your tools.
    Advertisement
  3. The under sink area is small and confined, with lots of pipes and other hazards to your eyes. This job can also be messy and hard on your hands, so wearing gloves is a good idea. Remember that wearing personal protective equipment can seem like a headache at times but it could save you from pain and injury in the long run.
  4. Electricity and water don't mix, so unplugging your disposal as soon as possible is a very good idea. You may even want to turn off the circuit that the disposal was plugged in to. Go to your home's fuse box and turn off the circuit breaker controlling the garbage disposal plug. [1]
  5. You should have two separate valves located below the sink, one for the hot water and one for the cold water. In some cases, the hot water shut off knob will be red and the cold water shut off knob will be blue, but this is often not the case. Either way, turn both of the handles clockwise until they are all the way off. Double check that they are closed by turning on the water in the sink. A few drips at first are fine but the flow of water should be gone. [2]
    • If you still have water coming out, you may need to consult a plumber to change out your shut off valves or you could do it yourself by following these steps: https://www.wikihow.com/Replace-Shut-off-Valves
    • If there are no water shut off valves under your sink, you will need to locate them further down your water pipes. Trace the water supply lines as far as you can, looking for valves where you could shut off the flow of water. If all else fails, there should be a main water shut off, either where water comes into your house or at the curb in a meter vault. [3]
  6. Water supply lines that connect to kitchen sinks are most often flexible plastic tubing that connect on both ends, at the sink and the water shut off valve, with metal nuts. Because the connection to the sink is found on the backside of the bottom of the sink, it may be a bit awkward to get to. Use an adjustable wrench, channel-locks, or an open-ended wrench to loosen the nut on the water line, whichever you can most easily get into the space. Hold the line in place with one hand while you loosen the nut with the other, so that when it becomes disconnected you can keep the line upright. A bit of water will still be in the line, so have a bucket handy to pour out the water trapped in the line. [4]
    • It's a good idea to spread towels across the bottom of the under-sink cabinet in order to catch small spills and reduce clean-up time later.
    • If the connection between your water lines and the sink are totally inaccessible, you can usually disconnect that lines at the water shut off valves. Remember, though, that you need to be gentle with the connections at these valves, as breaking them would send water streaming into your kitchen.
  7. The drain pipe is connected at the bottom of your sink strainer with a slip nut or a coupling nut, that connects plastic drain piping to a metal sink strainer. First loosen the nut that attaches the strainer to the drain pipe with channel locks or an adjustable wrench. [5] This is usually a plastic nut that can be loosened by hand, with a bit of strength of course. When this nut is loose don't pull the connection apart yet! You will also need to loosen the slip nut at the far side of the P-trap, which is a distinctive J- or U-shaped span of pipe in the drain line under the sink. Loosening this nut as well should allow you to take off the whole piece of piping between the strainer and the far side of the P-trap without damaging the piping. Remember to keep your bucket handy to capture spills. [6]
    • If you have a sink that is mounted underneath the counter, you may need to remove more drain piping in order to have space for the sink to come out. Remove your drain pipe further past the P-trap, giving space for the sink to be angled out. Whatever you take out can easily be replaced, as long as you leave at least an inch of pipe sticking out from the where it enters the under sink area.
    • A slip nut connection is designed for removal by hand but if you can't get it off by hand, you may want to wrap a rag around the nut and gently turn the nut with your channel locks, so that the slip nut doesn't get damaged. [7]
  8. First you will need to disconnect the drain pipe from your disposal. Unscrew the main connection between the garbage disposal and the drainpipe with a screwdriver. [8]
    • You may also need to remove the drain line for the dishwasher, if you have one connected to the drain through your garbage disposal. This is a simple connection that should be easy to detach with either a screwdriver or wrench, depending on the fixture.
  9. Remove your garbage disposal , if you have one. Some garbage disposals have a special Allen wrench that unlocks the assembly from its connection (this should come with your disposal when you buy it). Use one hand to turn the special wrench counterclockwise and keep your other hand under the disposal. Other types of garbage disposal units use snap rings to connect the disposal to the bottom of the sink. With this connection, one ring is attached to the bottom of the sink and one ring is attached to the disposal. Then the two rings have several screws that sandwich them together, which can simply be loosened and removed when detaching the disposal. Either way, the unit will come off quickly and you'll need to have a good grip on it so that you're ready to catch it.
    • In many cases, a sink with two bowls will have one bowl connected directly to the drain and one connected directly to a garbage disposal. If this is the case you will need to remove both connections.
    10. Advertisement
Part 2
Part 2 of 2:

Removing Your Sink

PDF download Download Article
  1. Use a utility knife to carefully slice through the sealant along the edges of the fixture. Be sure not to cut into the countertop if you are going to continue using it.
  2. If you have an under-mounted sink you will first need to have someone hold the sink up while you detach it, otherwise it could fall down onto you. For top-mounted sinks, this step can be done by yourself. Unscrew the metal clips that connect the sink to the countertop. Use a screwdriver to carefully take off the tiny clips. These screws may be difficult to access or be a bit rusty, so just take your time and be patient getting them off.
    • In order for your helper to hold up an under-mounted sink, remove the strainer from the sink, allowing them to hold onto the sink through the strainer hole. The strainer is connected to the sink with a locknut that is located below the sink. You will need to use large channel locks to loosen the locknut, turning the locknut clockwise until it is detached. Then simply tap the bottom of the strainer up and it should pop up and be easily removed from the sink.
  3. If it doesn't move easily, move from side to side of the sink, pushing up until the fixture is loosened on all sides. If you are having trouble getting the sink to detach, and you are worried it may pull off pieced of your laminate countertop, have a helper gradually cut along the caulking as you push up on one side of the sink. This should allow you to remove the sink without accidentally pulling off some of your counter's finish.
  4. Stainless steel drop-in units are light enough to remove by yourself but older porcelain sinks can be heavy, so get someone to help you take that type out. Getting under-mounted sinks out is just a bit trickier. You will need to angle it out of the cupboard doors, being careful not to damage any cabinet surfaces or remaining piping.
  5. Scrape off any old caulk or plumber's putty from the countertop with a paint scraper or a razor blade. Make sure the surface is clean before you begin installing a new kitchen sink. Also remember to sop up any water that may have come out of the sink during removal. [9]
    6. Advertisement

Community Q&A

Search
Add New Question
  • Question
    What can I do if the sink isn't coming off?
    Community Answer
    Use a pry bar if you're not worried about damaging the edge of the sink or the counter top. If you want to be careful, place a towel between the pry bar and the counter top.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 3 Helpful 6
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Video

      Tips

      • If necessary, find a flashlight or drop light to hang in the enclosure under the sink. You don't want to have to hold onto a light while removing the sink, so make sure it can light your space well on its own.
        Thanks
        Helpful 1 Not Helpful 0
      • If you're replacing your sink, consider replacing your faucets and your hoses, too. It's easier to do with the sink removed.
        Thanks
        Helpful 1 Not Helpful 1
      • A new sink might require that you adjust the lengths of pipes under the sink. You can do this easily if using PVC pipes. You might even want to consider replacing all the pipes under the sink whenever you put in a new fixture, as older pipes are more likely to leak.
        Thanks
        Helpful 0 Not Helpful 0
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!
      Advertisement

      Things You'll Need

      • Channel locks or pipe wrench
      • Screwdriver
      • Utility knife
      • Bucket
      • Towels
      • Drop light
      • Work gloves
      • Protective eyewear

      You Might Also Like

      Kitchen Sink Clogged? Here’s What to Do
      How to
      Repair a Chipped Quartz Countertop + Prevent Future Damage
      How to
      Install Quartz Countertops
      How to
      Cut Countertops
      How to
      Hide Pipes in the Kitchen
      How to
      Recaulk Kitchen Counter Where It Meets the Backsplash
      How to
      Measure Countertops
      How to
      Cover Laminate Countertops with Tile
      Advertisement

      References

      1. ↑ https://www.homemadehints.com/how-remove-garbage-disposal/
      2. ↑ https://www.homemadehints.com/how-to-remove-a-kitchen-sink/
      3. ↑ https://www.rotorooter.com/blog/plumbing/how-to-turn-off-the-main-water-shut-off-valve/
      4. ↑ https://www.lowes.com/n/how-to/how-to-install-a-kitchen-sink
      5. ↑ David Balkan. Professional Plumber & CEO of Balkan Sewer & Water Main. Expert Interview. 29 April 2021.
      6. ↑ https://www.homemadehints.com/how-to-remove-a-kitchen-sink/
      7. ↑ David Balkan. Professional Plumber & CEO of Balkan Sewer & Water Main. Expert Interview. 29 April 2021.
      8. ↑ https://www.homemadehints.com/how-remove-garbage-disposal/
      9. ↑ https://www.familyhandyman.com/kitchen/replace-a-sink/
      1. https://www.familyhandyman.com/kitchen/replace-a-sink/view-all
      2. https://www.bobvila.com/articles/install-kitchen-sink/#.VFE3Z75H0y4

      About This Article

      Article Summary X

      With a little plumbing experience and an extra pair of hands, you can remove your kitchen sink in about half an hour. You’ll also need a screwdriver, pipe wrench, and utility knife. First, shut off the valves that supply water to your sink and disconnect the supply lines from the faucet. Then, remove the drain pipe by loosening the nut and slipper nut with a wrench. If you have a garbage disposal unit, unscrew the connections to the drainpipe and remove the drain pipe and unit. Once you’ve removed all the pipework and garbage disposal unit from the sink, cut the caulking around the top of the sink. If your sink is under-mounted, you’ll also need to unscrew the clips holding it in place. Get someone to hold the sink while you do this so it doesn’t fall on you. You should then be able to lift the sink freely out if its frame. For more tips, including how to adjust the lengths of the pipes under the sink, read on!

      Did this summary help you?
      In other languages
      Thanks to all authors for creating a page that has been read 231,681 times.

      Reader Success Stories

      • Elmer Hatfield

        Nov 23, 2016

        "My sink was leaking from somewhere and I could not find it. I was needing to replace my sink, but did not know how ..." more
      More reader stories Hide reader stories
      Share your story

      Did this article help you?

      Advertisement