How to Use a Guitar Pedal

PDF download Download Article
PDF download Download Article

Guitar pedals, sometimes called effects pedals or stomp boxes are small electronic units that alter your guitar's sound. Traditionally, guitar pedals are used to produce special effects such as wah-wah, delay, overdrive, and distortion. However, it is also possible to use effects pedals to control volume, equalization, and other basic aspects of your guitar's tone. To use a guitar pedal, connect the pedal to your amp and guitar, then experiment with different notes and settings to achieve the sound that you want.

Method 1
Method 1 of 3:

Hooking up a Pedal

PDF download Download Article
  1. Remove the screws on the sides or bottom of the pedal by turning them counterclockwise. Then, slide off the faceplate to gain access to the 9-volt battery hook up on the bottom of the pedal. Connect the negative and positive ends of the battery hook up with the negative and positive ends of the battery to power your pedal. [1]
    • If you use batteries, you don't have to plug the pedal into a power source.
    • Some pedals have a red warning light that turns on when the batteries are low.
    • Refer to the instruction manual that came with the pedal if you're unsure of how to access the battery hookup for your specific pedal.
  2. If you don't want to run the risk of your batteries dying while you play, you can also connect your effects pedal directly into an AC outlet in your home. The 9-volt power cord input is usually found on the top or side of the pedal. [2]
    • Purchase a 9-volt power cord online or at a guitar store.
    Advertisement
  3. Most pedals and amps use a 1 ⁄ 4 inch (6.4 mm) guitar cord. Insert one end of the cord into the output jack on your pedal. [3]
    • This cord must be long enough to connect from the pedal to your amp.
    • It doesn't matter which end of the cord you plug into the pedal.
  4. You can hook up multiple pedals by connecting them with a guitar cord. Plug the cord coming from the output jack of one pedal and plug it into the input jack of the second pedal. You can string together as many pedals as you want using this method. [4]
    • Using more than one pedal at the same time will mix the effects together.
  5. Take the same cord that's connected to the output jack on your pedal, and plug the other end of the cord into the input jack on the amp. The wire should run from the pedal to the amp. [5]
    • If you are using multiple pedals, connect the last pedal in your lineup to the amp.
  6. Use another, separate guitar cord, and plug it into the input jack on your pedal. This guitar cord must be long enough to reach from the pedal to your guitar. [6]
  7. The jack for the cord on your guitar can usually be found on the body of the guitar. Take the opposite end of the cord that's inserted into the input jack on your pedal and put it into the single jack on your guitar. Your effects pedal is now set up. [7]
    8. Advertisement
Method 2
Method 2 of 3:

Playing Guitar with an Effects Pedal

PDF download Download Article
  1. Effects pedals like overdrive and boost may greatly increase the frequency, volume, and gain when playing your guitar. Turn down the volume on your amp so that you don't blow out the speakers once you start playing notes. [8]
  2. Flip the switch on the front of the amp to the on position. Play a note on your guitar. It should sound the same way that it would if you connected the guitar directly to the amp because the pedal isn't engaged yet.
    • If no sound is coming out of your amp, make sure that the cords connecting the pedal to the guitar and amp are correctly plugged in and are in good working order. [9]
  3. Pressing down on the pedal will engage the effects and should distort and change the way that the guitar sounds coming out of the amp. Try playing something that you'd normally play and take notice of the different sound. [10]
    • You can play an entire song with the effects pedal or hit it on during a specific part of a song to change the sound of your guitar.
  4. Each pedal will come with different knobs that affect the sound of the distortion, volume, and intensity of the distortion. Experiment with the knobs by turning them up and down as you play notes to see how it changes the sound of your guitar.
    • Turning the tone knob up will increase the sound of treble in your guitar, while turning it down will increase the bass of the guitar. [11]
    • Turning up the drive knob on an overdrive pedal will increase the distortion.
    5. Advertisement
Method 3
Method 3 of 3:

Choosing the Right Pedal

PDF download Download Article
  1. A boost pedal increases the signal of your guitar for a louder sound and more sustained gain. Gain is the buildup of sound that occurs after you strike a note. If you're using a lower voltage amp or just want to boost the volume and gain of your guitar, you should use this pedal. [12]
    • Boost pedals are often used in conjunction with overdrive or distortion pedals.
  2. Overdrive and distortion pedals add sustain and a “crunch” to the sound of your guitar. These pedals are often used when playing heavy metal or punk songs that contain power chords. Use this pedal if you want a distorted rock sound. [13]
  3. You can adjust the bass and treble of your guitar with an equalizer or EQ pedal. Adjust the knobs or sliders up and down to change the frequency of your guitar. [15]
    • Unlike distortion or overdrive pedals, EQ pedals allow you to change multiple frequencies when playing your guitar.
  4. Compressors typically have tone, attack, and sustain knobs which let you control different aspects of your guitar's sound. Compressors even out the sound as you're playing, which makes for more consistent volumes and sustain. [16]
    • Compressors allow you to set a range so that your guitar is never at too high or low of a frequency.
    • A high attack will highlight the initial plucking of the string.
    • Sustain controls how long the note rings out after you play it.
  5. A wah-wah pedal fluctuates the frequency of your guitar up and down as you play. Rock your foot back and forth on the pedal to achieve the “wah-wah” sound. [17]
    • Pressing down on the pedal with your toes will increase the treble and frequency of your notes, whereas pressing down on the pedal with your heel will increase the bass.
  6. A delay will repeat the notes that you played back in an echo over time. With a delay pedal, you can adjust the delay time and frequency to achieve different sounds. [18]
  7. If you want a wide range of effects, you can get a single multi-effect pedal that includes a variety of different effects. Multi-effects pedals don't offer the same level of customization as using individual pedals because they come with preset effects that you can't swap out. However, if you plan on using multi-effects in your play, they can save you money in the long run. [19]
    8. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    How can I change the tone of my guitar?
    Carlos Alonzo Rivera, MA
    Professional Guitarist
    Carlos Alonzo Rivera is a guitarist, composer, and educator based in San Francisco, California. He holds a Bachelor of Arts degree in Music from California State University, Chico, as well as a Master of Music degree in Classical Guitar Performance from the San Francisco Conservatory of Music. Carlos specializes in the following genres: classical, jazz. rock, metal and blues.
    Carlos Alonzo Rivera, MA
    Professional Guitarist
    Expert Answer
    Alter the pedal signal chain. This is the order of the pedals in between the guitar and the amplifier, and it can drastically affect the sound you produce. A common signal chain order would be the guitar, then the compressor pedal, the volume pedal, wah pedal, overdrive, chorus, tremolo, delay, reverb, and then the amplifier. Always put the compressor pedal right after the guitar.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 0 Helpful 1
  • Question
    I've been to a bunch of rock concerts and I've never noticed pedals being used, and the guitar players seemed to be able move all around the stage while maintaining their FX sounds. Does a player have to keep his foot on the pedal at all times in order to achieve the desired effect?
    Community Answer
    There are certain pedals that can act a like a light switch, and others act a lot like a sewing machine pedal were you have to apply pressure constantly. Usually at rock concerts they tend to use the pedal as a looper (meaning you loop a certain sound you have to play and sound sequence); the pedal acts as a switch to record it when you hold and when you let go it plays for you and just sit back and watch or the pedal can be used to filter sound as the desired effect.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 1 Helpful 10
  • Question
    Are the pedals already programmed with the effects, or do I have to program them?
    Community Answer
    Some pedals have just one effect, like a distortion pedal, and some have more than one. In general, only a multi-effects unit needs any kind of programming, but this is really just turning knobs and saving the sound once you're happy with it. There are many different levels of complexity for this kind of thing, but most are pretty accessible and easy to figure out.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 0 Helpful 1
See more answers
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!

      Things You'll Need

      • Guitar pedal
      • Guitar cords
      • Amp
      • Guitar

      You Might Also Like

      How to
      Attach a Strap to an Electric or Acoustic Guitar
      How to
      Use a Guitar Whammy Bar
      4 Ways to Hold a Guitar Pick
      How to
      Make Homemade Guitar Picks
      How to
      Make a Guitar Pickup
      How to
      Make a Custom Guitar Strap
      How to
      Use a Guitar Tuner
      The Best Ways to Personalize Your Acoustic or Electric Guitar
      How to
      Make a Capo with Office Materials
      How to
      Make a Guitar Case
      How to
      Install Schaller Strap Locks
      How to
      Install Guitar Pickups
      How to
      Reduce Guitar String Noise
      How to
      Build a Talk Box
      Advertisement

      References

      1. ↑ https://youtu.be/cV3i6tCyK18?t=46
      2. ↑ https://youtu.be/2bOtI1sFW_8?t=32
      3. ↑ https://youtu.be/cV3i6tCyK18?t=112
      4. ↑ https://youtu.be/-B2vgpaztD0?t=212
      5. ↑ https://youtu.be/cV3i6tCyK18?t=99
      6. ↑ https://youtu.be/cV3i6tCyK18?t=113
      7. ↑ https://youtu.be/cV3i6tCyK18?t=114
      8. ↑ https://theproaudiofiles.com/how-to-get-great-guitar-tone/
      9. ↑ http://www.myrareguitars.com/guitar-troubleshooting-bad-connection
      1. ↑ https://youtu.be/f74SASpBm_E?t=250
      2. ↑ https://www.quora.com/What-do-the-tone-and-drive-knobs-do-on-a-distortion-overdrive-OS-2-pedal-for-an-electric-guitar
      3. ↑ http://truefire.com/blog/guitar-gear/16-guitar-effects-pedals-you-must-have/
      4. ↑ http://truefire.com/blog/guitar-gear/16-guitar-effects-pedals-you-must-have/
      5. ↑ Carlos Alonzo Rivera, MA. Professional Guitarist. Expert Interview. 27 August 2019.
      6. ↑ https://youtu.be/ATynpvRHMs0?t=162
      7. ↑ https://ledgernote.com/columns/guitar-guru/types-of-guitar-pedals/
      8. ↑ https://ledgernote.com/columns/guitar-guru/types-of-guitar-pedals/
      9. ↑ https://www.sweetwater.com/insync/guitar-pedal-buying-guide/
      10. ↑ https://www.sweetwater.com/insync/guitar-pedal-buying-guide/

      About This Article

      In other languages
      Thanks to all authors for creating a page that has been read 142,336 times.

      Reader Success Stories

      • Marco Angeles

        Feb 13, 2017

        "Everything in this article helped because I do not have a guitar pedal, but I am getting one soon and I do not know ..." more
      More reader stories Hide reader stories
      Share your story

      Did this article help you?

      Advertisement