Download Article
Download Article
Riding jet skis in the summertime can be an absolute blast. In order to ensure that next summer will be as fun as the one that's recently passed, you'll need to winterize your jet ski properly. Otherwise, your jet ski may become damaged and/or fail to run. Winterize your jet ski by draining it, cleaning it, filling it with gas, lubricating it, and storing it correctly.
Steps
-
Remove your jet ski from the water. When you're done with the last ride of the season, get your jet ski out of the water as soon as possible. With your trailer securely attached to the back of your vehicle, slowly back your vehicle down the ramp until most of the trailer is underwater. Then get onto your jet ski, drive it up onto the trailer, and hook it to the trailer. Get back into your vehicle and slowly drive forward to safely remove the jet ski from the water.- If possible, have a friend assist you with this so that one of you can drive the vehicle and the other can drive the jet ski.
-
Reposition the jet ski for draining. The bow (front) needs to be higher than the stern (rear) of your jet ski so it can be drained properly. Secure your jet ski on the trailer so that the back of it is lower than the front.Advertisement -
Turn the throttle back and forth to drain the water. Turn the jet ski on and alternate between moving the throttle back and forth in short bursts. Do this in 30 second intervals to prevent overheating. Continue this until water is no longer being expelled from the jet ski. -
Mix water and antifreeze in a bucket. Use RV antifreeze only! It is much less harmful to the environment. Do not use regular automotive antifreeze. The antifreeze will prevent any fluids from freezing in the exhaust system while the jet ski is stored. Mix one gallon (3.8 L) of RV antifreeze and one gallon (3.8 L) of water in a five gallon (18.9 L) bucket. -
Flush the mixture through the exhaust system. Hook a hose or water pump up to the flush outlet while keeping the other end submerged in the antifreeze mixture. Turn the engine on and off once the entire mixture has gone through the exhaust system.
Advertisement
-
Wash the exterior with car safe soap. Fill a bucket with warm water and add in a few squirts of car safe soap. Soak a scratch-free cloth in the soapy water and wipe down the exterior of your jet ski with it. Pay close attention to the bottom of the jet ski, where algae and slime tend to accumulate.- Don't use dishwashing liquid or hand soap.
-
Rinse and dry your jet ski. Thoroughly rinse off your jet ski with clean water. You can do this with a hose or by filling and dumping buckets of water onto the jet ski. Afterwards, let the jet ski air dry completely.- If you want to, you can then use a high-shine protectant car wax to buff and shine your jet ski.
-
Put stabilizer in your gas tank. Get a bottle of fuel stabilizer and add it to your gas tank as the product label instructs. This will prevent fuel contamination and will also keep residue from building up in the carburetor, fuel injection system, and gas lines. -
Fill up your tank with gas. After putting the stabilizer in, top off your gas tank with premium gas. This will prevent condensation from forming on the inside of the gas tank. [1] X Research source -
Lubricate your jet ski's moving parts. Spray lubricant on the areas of your jet ski that are often rotating and turning. Some of these areas include the steering nozzle pivot points, the reverse mechanisms, and the brake mechanisms.- It's also a good idea to spray the engine as well as the electrical components to rid them of any traces of water.
Advertisement
-
Remove the battery. Batteries lose their charge over time, so it's necessary to remove the battery from your jet ski and charge it while your jet ski is stored. First disconnect the negative terminal and then disconnect the positive terminal. [2] X Research source -
Charge the battery. Attach the battery to an automatic battery charger. Make sure to do this on a secure surface that's away from anything flammable. Also be sure to charge the battery in a location where the temperature won't drop below freezing. -
Store your jet ski in a secure garage. It's ideal to store your jet ski on its trailer in a garage, but you can also store it in a shed, a barn, or outside. Remove the tires from the trailer or put blocks of wood underneath them to prevent dry rot and corrosion.- Remember to keep your jet ski stored away from any flammable substances, since it's full of gas.
-
Cover your jet ski. Either cover your jet ski with a tarp or cover to keep it protected. Also plug the exhaust outlets and air intakes with rags to keep rodents from getting inside the jet ski.- If you store your jet ski in a shed, a barn, or outside, it's important to protect the jet ski a little more. Cover it with a second tarp or cover.
Advertisement
Community Q&A
Search
-
QuestionDo I need to winterize if it was summerized but never went in the water?Neil Rutiger WhiteCommunity AnswerIf the engine is liquid-cooed, get a hydrometer and check the strength of the antifreeze/coolant. If it needs to be drained, just the drain cock on the rad would be enough, then top it off with the proper coolant.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- This is a good time to do any repairs that your jet ski needs. Take the time to fix any dings or cracks that you notice before you cover it and store it for the winter.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Never run the jet ski engine for more than 30 seconds when it is out of the water.Thanks
- Do not store your jet ski in the house. It emits hazardous fumes.Thanks
Advertisement
Things You'll Need
- Jet ski trailer (and vehicle to pull it)
- Antifreeze
- Bucket
- Water
- Hose or water pump
- Care safe soap
- Scratch-free cloth
- High-shine protectant car wash
- Fuel stabilizer
- Premium gas
- Lubricant spray
- Automatic battery charger
- Safe storage area
- Cover or tarp
- Wooden blocks (optional)
- Rags
References
About This Article
Article Summary
X
To winterize a jet ski, start by removing it from the water and making sure the stern is higher than the bow so it can be drained. Next, turn the throttle back and forth to drain the water. Once it’s fully drained, mix water and antifreeze in a bucket and flush the mixture through the exhaust system. Then, wash the exterior with car-safe soap, rinse the jet ski with water, and let it air dry. Additionally, add fuel stabilizer to your gas tank to prevent residue from building up, then top the tank off with gas to keep condensation from forming. To learn how to store your jet ski after cleaning it, keep reading!
Did this summary help you?
Thanks to all authors for creating a page that has been read 220,316 times.
Reader Success Stories
- "A great trick, using a bilge pump to get the water/antifreeze mixture into the ski."
Advertisement
93%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"A great trick, using a bilge pump to get the water/antifreeze mixture into the ski."
"Thorough, detailed step-by-step instructions, much appreciated."
