Download Article
Download Article
Bulkhead (Headache rack) A strong wall-like structure placed at the front of a flatbed trailer (or on the rear of the tractor) used to protect the driver against shifting cargo during a front-end collision. A bulkhead may also refer to any separator within a dry or liquid trailer (also called a baffle for liquid trailers) used to partition the load.
Building a headache rack is not an extremely hard task and is relatively cheap. All you need is 25 feet (7.6 m) of 1 1 ⁄ 2 inch (3.8 cm) square tubing, 2 feet (0.6 m) of 1/4 x 1 1/2 inch strip of metal, a welder, and a chop saw.
Steps
Download Article
-
Cut the top of the crossbar to the length of the top of your cap or on a 1991 Ford cut at 58 inches (147.3 cm). [1] X Research source -
Cut two sides at 35 degrees at both ends going opposite directions at 23 inches (58.4 cm) in length. [2] X Research sourceAdvertisement -
Tack where the sides angle out. Take and check how it fits on the pickup truck. -
Cut two more pieces (21 inches long) to place on each side of your slider window. If there's no slider window, go 1/3 of the way in from each side. -
Tack and check once more. -
Cut your 1 1 ⁄ 2 inch (3.8 cm) x 1 ⁄ 4 inch (0.6 cm) flat strap into 4 x 6 inch pieces. -
Tack the end pieces on to run with the bed flush to the front of the rack. Take the other two pieces, center, and tack them running with the cab. -
Drill your hole in both rack bases and bed to line up and bolt. [3] X Research source
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- Take your time, use common sense, and don't worry if pieces don't fit. Try make larger pieces and go a little smaller each time until they fit.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
References
About This Article
Thanks to all authors for creating a page that has been read 98,494 times.
Advertisement
89%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"It gave me the angles and format to work to, thanks."
