PDF download Download Article PDF download Download Article

Dr. Martens, which are also referred to as Docs and Doc Martens, are a brand of leather footwear with a very distinctive look. Known today for their yellow stitching, cushioned soles, and durability, Dr. Martens actually date back to the Second World War, when the first pair was created by a German doctor who injured himself on leave during a ski trip. Dr. Martens shoes and boots are traditionally leather—though vegan versions are now available—which means they require some extra care to maintain the hide. But cleaning and even polishing your Docs is a relatively simple process, and with regular care your shoes or boots will last for years.

Part 1
Part 1 of 3:

Cleaning Dr. Martens

PDF download Download Article
  1. This will make the cleaning process easier, and give you a chance to clean the laces. [1] Swirl the laces around in some soapy water, and give them a scrub if they're dirty. Rinse them under clean water, ring them out, and hang them to dry.
  2. Watermark wikiHow to Clean Dr. Martens Shoes
    With a shoe brush or old nail brush, carefully brush off dirt, dust, and dried mud from your Docs. Be sure to get into all the hard to reach places as well, such as where the stitching is and inside the tongue. [2]
    • If you don’t have a shoe or nail brush, you can use a clean, damp, lint-free cloth to remove dirt and dust.
    Advertisement
  3. Watermark wikiHow to Clean Dr. Martens Shoes
    If you have any scuffs or polish build-up on your Docs, you can remove both with an acetone-free nail polish remover. Apply some nail polish remover to a clean rag or lint-free cloth. Gently rub at scuffs and polish build up until the scuffs wear away and the polish comes off.
    • When you're finished, rub the shoes down with a damp, clean cloth and allow them to air dry. [3]
    • Don’t rub too hard with the nail polish remover, otherwise you may damage the finish.
  4. Watermark wikiHow to Clean Dr. Martens Shoes
    Because leather was the skin from a living animal, it needs to be moisturized and conditioned (just like human skin) to prevent it from drying, cracking, and losing its durability. Rub your Docs with a cloth or sponge to massage a conditioner into the leather, making sure to get the hard to reach places as well. Let them dry for about 20 minutes afterward. [4] Popular leather conditioners include:
    • Lemon essential oil (not olive oil, which can cause oil damage) [5]
    • Mink oil [6]
    • While saddle soap is often recommended as a conditioner for leather, the lye it contains can actually cause your leather to dry, crack, and deteriorate faster [7]
  5. Fill a small bucket or bowl with warm water and a few drops of liquid soap or dishwashing liquid. Take a dishwashing brush, shoe brush, or toothbrush and scrub the soles with the soapy water to remove dirt, grime, mud, and anything else you’ve stepped in.
    • Wipe the soles off with a damp rag when you're finished.
  6. Advertisement
Part 2
Part 2 of 3:

Polishing Dr. Martens

PDF download Download Article
  1. To polish leather, you want to match the color of the polish to the color of the leather as closely as possible. Choose a neutral polish if you can't find one to match your Docs, or if your Docs are multicolored. [8]
    • Dr. Martens recommends using only wax-based polishes, and just on their smooth leather products.
  2. Choose a location that can get dirty if any accidents occur, and protect the surface you're working on with bags, newspaper, or some other cover. [9]
  3. Watermark wikiHow to Clean Dr. Martens Shoes
    Take a rag or lint-free cloth and run it around in the polish in a circular motion to warm the wax, which will make the polish easier to apply. Apply the polish to the entire shoe, using gentle but firm pressure to get the polish into the leather’s pores. [10] If necessary, use a cotton swab or soft-bristled toothbrush to get polish into the hard to reach places. [11]
    • If your shoes are old and have never been polished, consider applying a second layer of polish. [12]
    • When you're finished, allow the polish to sit on the shoes for 10 to 20 minutes.
  4. Watermark wikiHow to Clean Dr. Martens Shoes
    With a shoe brush, begin to gently buff and polish the leather all over, working the polish into the shoes and removing excess at the same time. [13] If you're looking to achieve a mirror shine, the process is slightly more in depth:
    • Dip your finger into a pot of clean water and allow a couple drops to fall onto a spot on the leather.
    • Dip a cloth into your shoe polish and rub that spot using circular motions. Work in small areas at a time, applying water and working more polish into the leather with a cloth.
    • It will likely take a couple hours to cover the entire boot or shoe, but you should notice the leather getting increasingly smooth. [14]
  5. Watermark wikiHow to Clean Dr. Martens Shoes
    When you’ve finished buffing your Docs with a brush or using the mirror shine technique, rub the leather with a clean piece of nylon to remove dust and extra polish, and to buff the leather to a shine. [15]
  6. To give your Docs the longest life possible, clean and condition them every three months. To keep them looking as new as possible, polish them every time you clean and condition them.
  7. Advertisement
Part 3
Part 3 of 3:

Removing Stubborn Stains From Dr. Martens

PDF download Download Article
  1. With a scraper, spoon, or credit card, remove as much of the gum as possible. Take a hair drier and heat the remaining gum until it becomes tacky. Then apply the sticky side of a piece of tape to gum and peel it off. Press the tape on again and peel it off a few more times. If necessary, reheat the gum with the hair drier and repeat until the gum is gone. [16]
    • After removing any stubborn stains from your boots, proceed with regular cleaning to remove excess residues and cleaning products.
  2. Watermark wikiHow to Clean Dr. Martens Shoes
    The best thing to remove paint from your Dr. Martens is mineral spirits. Mineral spirits is a petroleum-based solvent that works well at dissolving paint. Because it’s oil-based, it’s safe to use on leather.
    • Take a clean rag and dip it in some mineral spirits. Rub the affected area with the rag, adding more mineral spirits as needed. Continue rubbing until the paint dissolves and comes off. [17]
  3. For this DIY project you will actually need a penetrating oil like WD-40. Apply the oil to the glue and a small area of the boot surrounding the glue. Let it sit until the glue becomes soft, then scrape the glue with a butter knife or plastic scraper. If necessary, repeat these steps again until the glue is gone. Wipe away the excess oil when the glue has been removed. [18]
  4. Watermark wikiHow to Clean Dr. Martens Shoes
    Use a scraper or credit card and scrape off as much of the sticky substance as possible. Take a clean rag and dip it in some acetone, nail polish remover, or even peanut butter. [19] After rubbing the cleaner into the shoe, take the scraper to it again. Repeat as necessary.
    • Wipe the area with a clean damp cloth and allow it to dry.
  5. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    What do you clean Doc Martens with?
    Marc Sigal
    Shoe Care Specialist
    Marc Sigal is a Shoe Care Specialist based in Los Angeles. Marc has over 19 years of experience working in the world of e-commerce, with extensive experience with the care of luxury goods. He is currently the VP of Strategic Partnerships at Blutag, an e-commerce platform helping consumers find products. Prior to Blutag, he founded ButlerBox, a dry cleaning and shoe care service based in Los Angeles, California. ButlerBox reinvented amenity services by placing custom-designed, wrinkle-resistant lockers in luxury apartment buildings, class A office buildings, shopping centers, and other convenient locations. The company got acquired by Rinse.com in 2021. Marc has a BA in Global and International Studies from the University of California, Santa Barbara.
    Shoe Care Specialist
    Expert Answer
    Wonder Balsam, which is a product made by Dr. Martens that contains coconut oil, beeswax, and lanolin, and which is designed to help protect against water and salt.
  • Question
    Can you machine wash Dr Martens?
    Marc Sigal
    Shoe Care Specialist
    Marc Sigal is a Shoe Care Specialist based in Los Angeles. Marc has over 19 years of experience working in the world of e-commerce, with extensive experience with the care of luxury goods. He is currently the VP of Strategic Partnerships at Blutag, an e-commerce platform helping consumers find products. Prior to Blutag, he founded ButlerBox, a dry cleaning and shoe care service based in Los Angeles, California. ButlerBox reinvented amenity services by placing custom-designed, wrinkle-resistant lockers in luxury apartment buildings, class A office buildings, shopping centers, and other convenient locations. The company got acquired by Rinse.com in 2021. Marc has a BA in Global and International Studies from the University of California, Santa Barbara.
    Shoe Care Specialist
    Expert Answer
    No. You really don't want to get leather shoes wet, since moisture causes leather to shrink. You're much better off cleaning your Dr. Martens by hand.
  • Question
    What do I do when my Docs get wet?
    Community Answer
    You really don't have to do anything! Most recommend a water-protectant spray, which does work, but Dr. Martens are honestly very durable, and look even better with age/wear.
See more answers
Ask a Question
      Advertisement

      Video

      Tips

      • Conditioning new Docs right away will help soften the leather, which will let you break them in faster.
      • If your boots are brand new, you do not need to use balsam to condition them yet, just the water protection, because they're new, and there's nothing to polish.
      • If your shoes get wet, allow them to air dry naturally.
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!
      Advertisement

      About This Article

      Article Summary X

      To clean your Dr. Martens, start by scrubbing the soles with a solution of dish soap and water. When you’re finished, wipe the soles with a damp rag to remove any soap. Swirl the laces around in some soapy water if they’re dirty. Then, use an old nail brush to remove the dirt or mud from your shoes. If you’re trying to get rid of scuffs or old polish, apply an acetone-free nail polish remover to a wet rag and wipe them away. Rub the shoes with a damp rag when you’re done and leave them to air dry. For tips on how to polish your Dr. Martens, read on!

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 433,039 times.

      Reader Success Stories

      • Oliver Iphe

        Dec 16, 2017

        "The entire article was very helpful, especially the polishing part and suggesting to take off the laces, which has ..." more
      Share your story

      Did this article help you?

      Advertisement