How to Clean Polishing Pads

PDF download Download Article
PDF download Download Article

Keeping your polishing pads clean will extend their life and ensure a good, even polish each time you use them. You can use a bristle brush or spur buffer to tidy-up foam or wool pads mid-way through polishing, but you’ll also need to give them a deeper cleaning after you’re done polishing for the day.

Things You Should Know

  • To keep your polishing pad in good condition, stop and clean the pad when it gets saturated or matted with polish.
  • If you're using a foam pad , hold a bristle brush against the pad and turn on the polisher.
  • For wool buffing pads , use a buffing spur , then clean it the same way, by holding the spur against the pad, then turning on the polishing tool.
  • Keep moving the brush or spur so you clean the inner and outer portions of the pad evenly.
  • To deep-clean your polishing pad, spray it with buffing pad cleaner , let it soak for 3-5 minutes, then rinse the pad while scrubbing it gently with your thumbs.
Method 1
Method 1 of 2:

Keeping Wool or Foam Pads Clean during Polishing

PDF download Download Article
  1. If the polishing pad is completely saturated with polish, it’s time to stop and clean it. For wool pads, you’ll need to do a quick cleaning when the wool appears matted down with polish. [1]
    • If you’re polishing a car, a pad should be cleaned after doing 2 sections (each section being roughly the size of a trunk lid).
    • If you’re polishing floors, the pad should be quick-cleaned when you notice that the most recent floor section doesn’t look as polished as previous sections.
  2. You don’t need to remove the pad from the electric polishing tool. Cleaning your polishing pad between polishing sections of the car or floor will ensure it works evenly and effectively. [2]
    • Make sure you’re more than a few feet away from the vehicle so the dust from the pad doesn’t get onto the freshly polished paint.
    Advertisement
  3. Gently push down with the brush to apply light pressure to the pad while it spins. Using a scrub brush will help remove residue without harming the pad. [3]
    • Avoid applying too much pressure with the brush because it might damage the foam on the pad.
    • If you’ve already removed the pad from the polisher, hold it in one hand and scrub the pad back and forth with a plastic bristle brush with your other hand. [4]
    • Note that this procedure is only recommended for foam polishing pads.
  4. If you’re cleaning wool buffing pads, you’ll need to use a buffing spur to loosen bits of dirt and debris from the wool. Hold the spur to the wool pad with a light pressure and turn on the buffing tool so the pad spins around. [5]
    • You can purchase buffing spurs at any automotive or hardware store.
  5. If you start by placing the brush toward the outer rim of the spinning pad, move it into the center part and back out again to ensure the scrubber has covered all areas of the pad. Do this for about 1 or 2 minutes or until the polishing side of the pad is back to its original color. [6]
    • If you’re using a buffing spur for a wool pad, move the spur all over the surface of the pad until the wool is no longer matted with polishing product.
    • Make sure to hold the polisher firmly in one hand while you’re doing this. You can also hold it in place on a work table or other flat surface.
    6. Advertisement
Method 2
Method 2 of 2:

Deep-Cleaning Pads after Polishing

PDF download Download Article
  1. Cut the power to the polishing tool so you don’t accidentally turn it on while you’re trying to remove the pad. Use an outlet or power strip that you can easily get to so you can unplug it when you’re not using it. [7]
    • Note that this deep-cleaning procedure will work for foam, wool, and microfiber polishing pads.
  2. Unlock your polisher’s locking mechanism that holds the buffing pad in place. Once it’s unlocked, spin the buffing pad to the left until it falls off on its own. [8]
    • Refer to your buffer’s user manual to see how to remove buffing pads for your particular model.
  3. Make sure to place the pad polishing-side up before you spray it. Spray at least 6 or 7 times until the entire surface of the pad is wet but not completely soaked or dripping. You may want to place the pad in a utility sink while you spray it (i.e., a sink that isn’t used for dishes, cooking, or other food-related purposes). [9]
    • You can purchase cleaner made especially for buffing pads online or at any automotive or hardware stores.
    • Some manufacturers make specific cleaning solutions for wool and foam polishing pads, and some focus on car or floor pads, so get the one that best suits your needs.
  4. Allow the cleaning solution some time to soak down into the pad and loosen bits of dirt and debris. Leave the pad sitting in the utility sink while the formula soaks in (don’t turn on the water yet). [10]
    • Most polishing pad cleaning sprays have a pungent smell, so take this time to open a door or window if you like.
  5. Hold the pad over the sink with both hands and massage the solution into the surface of the pad with your thumbs. Make sure to massage the entire surface of the pad. [11]
    • Start with your thumbs together and move them apart before circling them back together again (think of it like a rolling, kneading motion).
  6. Turn on the faucet and hold the pad in both hands with the polishing side facing upward. Then, gently massage it with your thumbs while the water penetrates the pad. [12]
    • You should see dirty water coming out of the pad as you massage it.
  7. Do a final rinse of the pad by holding it under the faucet until it’s completely saturated with water. Then, turn off the faucet and squeeze as much water as you can out of the pad. [13]
    • If you see areas with lingering dirt or residue, repeat this rinsing process again, massaging those sections until the dirt is gone.
  8. Place the pad with the polishing side down so the water doesn’t seep into the glue that holds the foam to the backing. Let the pad sit for 12 to 24 hours or until it’s fully dry. [14]
    • It may help to wrap the pad in a microfiber towel and squeeze it to remove excess moisture.
    • You can also attach the damp pad to a polisher and set it to a medium speed for 20 to 30 seconds to help it dry faster. Hold the machine head down into the sink so water doesn’t sling everywhere.
    • As an alternative, you can put the damp pad in the dryer on low or no heat for 10 to 20 minutes, but just know that it might cause shrinkage.
    9. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    Are there any other ways to clean polishing pads?
    Andrew Outman
    Cleaning Expert
    Andrew Outman is a Cleaning Expert based in Jacksonville, Florida. He is the Founder of Salty Veterans Services LLC, a cleaning company based out of Jacksonville. Previously, he held the role of Director of Operations at SVS Cleaning Services, a trusted partner for residential and commercial cleaning needs throughout Northeast Florida. Andrew has extensive experience in the cleaning industry and a deep understanding of effective cleaning practices and customer service. His cleaning businesses have all held 5-star review ratings on both Google and Facebook. Andrew received a BA in Interdisciplinary Studies from Central Washington University.
    Andrew Outman
    Cleaning Expert
    Expert Answer
    To clean polishing pads, alternatively, create a solution using a gentle laundry detergent like Oxyclean. Submerge the pads in warm water mixed with the detergent, allowing them to soak for 15–30 minutes. Rinse thoroughly and optionally apply a fabric sanitizer such as Clorox or Lysol before air drying completely.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 0 Helpful 0
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Tips

      • Clean polishing pads immediately after you’re done polishing for the day so dirt and dust don’t settle in.
        Thanks
        Helpful 0 Not Helpful 0
      • You can also toss microfiber polishing pads in the washing machine and wash them with warm water and unscented detergent.
        Thanks
        Helpful 0 Not Helpful 0
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!
      Advertisement

      Warnings

      • Don’t massage or squeeze foam or wool pads too harshly because it might distort their shape.
        Thanks
        Helpful 1 Not Helpful 0
      Advertisement

      Things You'll Need

      • Bristle brush (for foam pads)
      • Buffing spur (for wool pads)
      • Commercial buffing pad cleaner
      • Microfiber towel (optional)

      You Might Also Like

      How to
      Use a Ratchet Strap
      How to
      Use a Light Timer
      Homemade Dawn Powerwash: Easy Recipe for Refills
      Moving a Vehicle’s Electric Power Seat Forward or Back Manually
      5 Ways to Reset Any Maytag Washing Machine
      How to
      Make a Smokeless Fire Pit
      How to
      Fix a Leaky Sink Trap
      How to
      Make a Drone
      Safe & Effective Ways to Clean & Unclog Any Sink Drain
      How to
      Clean a USB C Charging Port
      How to
      Paint on Plastic
      How to
      Adjust a Lazy Susan
      How to
      Adjust a Furnace Gas Valve
      How to
      Disassemble and Clean a Honeywell Quietset Tower Fan
      Advertisement

      Expert Interview

      Thanks for reading our article! If you’d like to learn more about cleaning, check out our in-depth interview with Andrew Outman .

      References

      1. ↑ https://meguiarsonline.com/forums/showthread.php?56553-Pad-Cleaning-quot-On-The-Fly-quot
      2. ↑ https://www.detailedimage.com/Ask-a-Pro/pad-cleaning-during-and-after-polishing/
      3. ↑ https://www.detailedimage.com/Ask-a-Pro/pad-cleaning-during-and-after-polishing/
      4. ↑ https://youtu.be/B01zu7wuGA0?t=51
      5. ↑ https://meguiarsonline.com/forums/showthread.php?56553-Pad-Cleaning-quot-On-The-Fly-quot
      6. ↑ https://www.detailedimage.com/Ask-a-Pro/pad-cleaning-during-and-after-polishing/
      7. ↑ https://youtu.be/AXvWYA4Z6r4?t=21
      8. ↑ https://youtu.be/AXvWYA4Z6r4?t=38
      9. ↑ https://www.detailedimage.com/Ask-a-Pro/pad-cleaning-during-and-after-polishing/
      1. ↑ https://www.detailedimage.com/Ask-a-Pro/pad-cleaning-during-and-after-polishing/
      2. ↑ https://www.detailedimage.com/Ask-a-Pro/pad-cleaning-during-and-after-polishing/
      3. ↑ https://www.detailedimage.com/Ask-a-Pro/pad-cleaning-during-and-after-polishing/
      4. ↑ https://www.detailedimage.com/Ask-a-Pro/pad-cleaning-during-and-after-polishing/
      5. ↑ https://www.detailedimage.com/Ask-a-Pro/pad-cleaning-during-and-after-polishing/

      About This Article

      Thanks to all authors for creating a page that has been read 36,123 times.
      If you buy through links on our site, we may earn a commission .

      Did this article help you?

      Advertisement