Download Article
Download Article
You probably use your headphones or earbuds almost every day, but can you remember the last time you cleaned them? Your headphones build up ear wax, dirt, and sweat over time that can affect sound quality and carry bacteria, but you can fix that in just a few minutes at home. Whether you have an over-ear headset or in-ear headphones, we've got the most simple and effective ways to clean them out. Keep reading for everything you need to know to make your headphones look and sound great!
Steps
-
Unplug or turn off your headphones or headset. Since you don’t want to damage any of the electronics, disconnect any devices you’re plugged into. If you have a Bluetooth headset or pair of headphones, turn them completely off before you start working. [1] X Research source- If you have a battery-powered headset, take the batteries out if you can.
-
Take off the ear pads if they’re removable. Try lightly pulling on the edge of your ear pads to loosen them from your headphones or headset. [2] X Research source The bottom edge of the ear pads will slip off of the headphones and expose the speaker underneath. That way, it’ll be easier to deep-clean the headphones and the pads.- If you’re having trouble removing the ear pads, check the instructions that came with your headphones.
- It’s okay if you can’t remove the pads from your headphones. You can still clean them while they’re attached.
Advertisement -
Wipe the headphones and pads with a damp lint-free cloth to remove loose dirt. Wet a lint-free cloth in warm water and wring it out as much as possible. Gently wipe the entire surface of your headphones, including the headband and wire, with the cloth. Use the same cloth to clean the ear pads around the outer edges so you can lift up the dirt and grime.
- Avoid using the cloth when it’s dripping wet since it could damage the electrical components inside your headphones.
-
Tackle stubborn wax or dirt with soapy water and a lint-free cloth. If you notice any of the dirt is really stuck on your headphones, put a drop of liquid dish soap onto your damp cloth and lather it in. Gently rub the soap into any spots that are extra sticky or dirty to break them apart and get your headphones clean. Then, rinse the cloth, wring it out, and wipe off any of the leftover soap residue.
- Avoid getting soapy water near the electronic components of your headphones so you don’t damage them.
-
Disinfect your earphones with rubbing alcohol. Use a 70% rubbing alcohol solution and wet the corner of a small lint-free cloth. Gently wipe the surface of the ear pads, wires, and headband of your headphones or headset to kill any germs or bacteria living on the surface. The alcohol will evaporate off the surface, so you don’t have to dry it off.
- Be sure to wipe down the microphone on a headset since it can get dirty being so close to your mouth.
-
Clean out small nooks and crannies with a soapy cotton swab. Dip a cotton swab into soapy water and squeeze out the excess liquid. Use the cotton swab to clean off any small holes, vents, and tight corners on the headphones. Then, run a cotton swab around the inside edges of the ear pads. Follow up with a dry cotton swab to remove any soapy residue. [3] X Research source
- Replace the cotton swab once it looks dirty so you don’t spread around the old dirt and grime.
- To disinfect, you can dip the swab in rubbing alcohol instead of water.
-
Pat the headphones with a towel and let them air-dry. Take a dry towel and wipe up any residual liquid that you still see on the surface. Then, leave your headphones out and let them dry off completely for about 30 minutes before you use them again. [4] X Research source
Advertisement
-
Turn off or unplug your earbuds. Make sure there’s no power connected to your earbuds so you don’t risk any electrical shock or damage to your electronics.
-
Remove and wash silicone ear tips in soapy water. The ear tips are the silicone pieces over the speakers. Pull them gently off of the speakers to remove them. Wet a lint-free cloth with warm water and rub the ear tips with it until you clean off all of the wax and dirt. Then just pat them dry with a towel.
- If you have foam ear tips, dirt and wax can build up and make them difficult to clean. Replace them with silicone ear tips so they’re easier to clean next time.
-
Wipe your earbuds with soapy water and a damp lint-free cloth. Use a few drops of liquid dish soap in a bowl of water and mix it together. Soak your cloth in the solution and wring it out completely. Then, wipe the surface of the earbuds with the cloth. Any dirt or wax will break down and lift off of the surface so your earbuds are clean. [5] X Research source
- Avoid using your cloth while it’s soaking wet since the moisture could damage the speakers or electronics.
- You can clean off the earbud wires using the same cloth and soapy water.
-
Clean stubborn dirt and wax with rubbing alcohol and a lint-free cloth. Wet the corner of a lint-free cloth in your rubbing alcohol and let the excess drip off. Gently wipe your entire earbuds, including the wires, with the damp cloth to break down any grime that’s still left on the surface.
-
Scrape any wax from around the meshes with a toothpick. Run a toothpick around the outer edge of the speaker mesh to remove all of the waxy buildup. Wipe the toothpick off on a clean cloth before using it on your earbuds again.
- Avoid pushing the toothpick in against the mesh since you could poke through it.
- You can instead use an earbud cleaning tool with a sharp point to scrape out the wax.
-
Scrub the speaker meshes with a dry toothbrush. Use a dry toothbrush and make sure you only use it for cleaning. Hold the earbud so the mesh is angled down and gently run the toothbrush bristles over it. Any loose dirt or wax will fall out of the mesh. [6] X Research source
- Removing the buildup in the speaker meshes can improve your earbuds’ sound quality and volume.
- If there’s dirt or wax still stuck in the mesh, rip off a fingertip-sized piece of adhesive mounting putty and gently press it onto the speaker mesh.
-
Wipe down a wireless earbud case with rubbing alcohol. If you’re cleaning AirPods or any other wireless earbuds, their charging case can get dirty too. Wet the corner of your cloth with rubbing alcohol and clean off any residue you see on the outside of the case. If you notice any dirt or wax on the inside of the case, dip a cotton swab into your rubbing alcohol and gently wipe the mess up. [7] X Research source
- Avoid sticking anything in the charging port when you clean the case so you don’t damage it.
-
Let the earbuds dry for 30 minutes. Wait until all the moisture has dried up on your earbuds before you use them again so you don’t accidentally damage any of the electronic components. [8] X Research source
Advertisement
Community Q&A
Search
-
QuestionCan ear wax ruin the headphone and earbud?Community AnswerNot really, but if you don't clean them and they become coated in wax, you won't be able to hear out of them, just like you can't hear well out of your ears when they are clogged.
-
QuestionCan I use regular soap and water? How does the earwax come out?Community AnswerUsing regular soap should be fine. It is weaker than dishwashing soap, which will make it safe to use. the earwax will come out on the earphones as you wipe them.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- Try to clean your headphones once a week so they never get too dirty.Thanks
- Store your headphones in a case or bag when you’re not using them.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Avoid completely submerging your headphones or earbuds in water since they could get damaged.Thanks
Advertisement
Things You’ll Need
Over-Ear Headphones
Earbuds
References
- ↑ https://www.thespruce.com/how-to-clean-ear-buds-4177162
- ↑ https://assets.sennheiser.com/global-downloads/file/5357/M2_AEBT_EN_A05_1.pdf
- ↑ https://youtu.be/rTjEtKvNmgM?t=161
- ↑ https://youtu.be/rTjEtKvNmgM?t=179
- ↑ https://groups.etown.edu/its/2018/03/21/tech-tip-how-to-clean-your-earbuds/
- ↑ https://groups.etown.edu/its/2018/03/21/tech-tip-how-to-clean-your-earbuds/
- ↑ https://youtu.be/cMM7IChUbwQ?t=44
- ↑ https://youtu.be/rTjEtKvNmgM?t=124
About This Article
Thanks to all authors for creating a page that has been read 130,029 times.
Advertisement
"Using soapy water really worked!"
