How to Unblock a Clogged Washing Machine Drain

PDF download Download Article
Clean your washing machine’s drain so that you can get back to cleaning clothes
PDF download Download Article

Have you noticed water on the floor of your laundry room, or a drum full of soap suds? Chances are, these issues are caused by soap residue and dryer lint, along with grease and oils that come off your clothes. Cleaning out your washer’s drainage hose or filter is the key to solving this problem—and we’re here to help show you how. Read on to learn how the access your washer’s drain hose and clean it out, as well as how to locate and clean your washer’s filter. Before you know it, your washer will be ready to tackle laundry day like a champ.

Things You Should Know

  • Shut off the water and disconnect the drain hose from the back of the machine to inspect it.
  • Remove any blockages you find with a drain auger or commercial drain cleaner.
  • For filter blockages, pop the compartment on the front of your machine open and wash the mesh filter.
  • Be sure to remove the drain hose before clearing the blockage. Otherwise, you may end up pushing the blockage even deeper into the machine or damaging the hose.

Get Product Support Solve Any Problem

wH
Hi there! Do you have a question about how to use or repair your home appliance? I’ve read the manuals so you don’t have to. Select your product, brand, and model, then ask away!
*
*
Method 1
Method 1 of 4:

Accessing the Drain

PDF download Download Article
  1. This is unlikely to be a perfectly dry operation, so grab a stack of towels or rags. You’ll probably need a few buckets, too. On the wall behind your washing machine, there should be a set of red and white valves. These supply water to your washing machine. Shut the valves by turning them clockwise as far as they’ll go. [1]
    • You may need to slide the washer out from against the wall first to access the supply lines.
  2. See the plastic hose coming out of the back of your washing machine? That’s the drain hose. It either leads to a wall, where the water drains into a pipe, or it leads to a sink next to your washing machine. [2]
    • When identifying where the drain is, you will need to differentiate it from the hot and cold water lines coming into the washer. The hot and cold water lines should be half the size of the drain pipes. They’ll also have valves on them, which won’t be true of the drain pipe and hose.
    Advertisement
  3. Use pliers or channel locks to unlock the round clamp at the base of the hose where it connects to the machine. Then, wiggle the hose out of the machine to remove it. If there’s a zip tie holding the hose to the sink, cut that off to free the hose. [3]
    • You should be able to look inside of the hose with a flashlight now to see if there’s a blockage. If there isn’t, the problem is either your filter or the drain pipe.
    • If the hose drains directly into a sink, the problem is almost certainly the hose. You’ll snake or use drain cleaner on the hose, not the pipe.
  4. The hose may be attached to the pipe with a clamp or connector, depending on how it’s set up. Unscrew or release whatever bracket there is. If there is no bracket or connector, simply pull the hose out of the drain. [4]
    • If the hose drains into a pipe in the wall, the blockage may be in either the hose or the drain pipe. Snake and use drain cleaner on both.
    • If, after cleaning the drain hose and/or the drain pipe, you still have drainage issues, the problem is likely in the drain filter.
    5. Advertisement
Method 2
Method 2 of 4:

Drain Cleaners

PDF download Download Article
  1. If your washing machine is draining slowly but it is not completely clogged, try simply pouring boiling water down the drain to clear it out. This can release soap buildup and scum that is narrowing your drainage pipe. [5]
    • If you run your washer on hot most of the time, then this may not work for your drainage problem, as you have been doing this repeatedly. However, if you only run cold cycles, then pouring hot water down the drain may be worth a try.
    • In areas that freeze during the winter, drainage pipes can freeze and get blocked up with ice. If your area is frozen and you think you have a clogged drain, try pouring hot water down the drain to get rid of any ice that may have accumulated.
  2. Pour some boiling water down the drain or hose, then sprinkle some baking soda inside the drain or hose. Pour a cup of white vinegar down the drain wait 5-10 minutes. Then, reconnect everything and run a test cycle to confirm the blockage is gone. [6]
    • This probably won’t work with larger blockages, but it’ll certainly get soap buildup and scum out!
  3. Opt for a commercial drain cleaner for a stronger solution. Follow the direction on the label to pour an appropriate amount of cleaner into the drain or hose. Wait for 30-45 minutes to give the cleaner time to break down the blockage. Then, run a test cycle to confirm the problem is gone. [7]
    • When buying a commercial drain cleaner, be sure to get one that is safe to use with your specific type of pipes and your type of drainage system. Some strong products that contain sulfuric acid can actually damage PVC pipes and they are generally not good for the environment as well.
    4. Advertisement
Method 3
Method 3 of 4:

Snaking

PDF download Download Article
  1. Place a drain auger at the opening of the drain or hose. A drain auger, aka a “snake,” consists of a long, sturdy wire that goes down a pipe to unclog it. There’s a handle at the end that rotates the coil to clear blockages. Place the end of the coil in the opening of the hose or the drain (depending on where you found the blockage). [8]
    • The average snake is about 50 to 75 feet (15 to 23 m) long. They work well for a variety of clogs, since they can clear clogs that sit far down in a pipe.
    • For this job, you shouldn’t need to go more than 4–5 feet (1.2–1.5 m) if you’re snaking the drain in the wall. Blockages almost always occur at the J-trap, which is pretty close to the opening in the wall.
  2. Turn the handles of the snake to extend the coil. Keep going until you feel a blockage. Turn the coil a few more times, then pull it out to manually remove whatever you caught on the snake. Do this repeatedly until you no longer feel any resistance where you previously did. [9]
    • If you get a lot of resistance from the blockage, it’s okay to use a good bit of force. The snake shouldn’t damage your pipes.
  3. Once you’re sure that the clog is gone, put everything back together and reattach the hose to the machine. Attach the drainage hose to the machine, as this is a spot that tends to leak on a washing machine. Run a cycle to confirm the blockage is gone. [10]
    • Look at the connection point between the machine and the drainage hose for any leaks.
    4. Advertisement
Method 4
Method 4 of 4:

Filter Cleaning

PDF download Download Article
  1. Pull your washing machine out away from the wall a little. Then, look around the bottom of the machine on the front and the sides for a panel. This panel contains the pump that pushes water out through the hose, and the filter that blocks large debris from going into the hose. Pry the compartment out to access the filter and the pump. [11]
    • On some machines, the filter compartment is on the inside of the machine.
  2. Every make and model looks different, but you should see a thick, round mesh item inside of the compartment. Pull it out of the machine and physically pry out any debris stuck in the mesh. Then, rinse the filter thoroughly under running water to remove all the other debris and gunk. [12]
    • You can replace the filter entirely if you prefer, but you can get by with a simple cleaning if the filter isn’t broken.
  3. The problem should be resolved, so put the filter back over the pump where you found it and close the compartment. Reassemble the hose and the drain if you haven’t already and run an empty wash cycle to confirm you’ve resolved the problem. [13]
    • If this doesn’t work, you almost certainly need to replace your filter’s pump. This isn’t a DIY job, so contact an appliance repair person near you.
    4. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    How do you remove the washing machine filter?
    Gevorg Grigorian
    Appliance Repair Expert
    Gevorg Grigorian is an Appliance Repair Specialist and the Owner of G and R Appliance Repair in Los Angeles, California. With over 15 years of experience, Gevorg specializes in residential and commercial appliance repairs as well as heating, ventilation, and air conditioning (HVAC) services. Gevorg holds a BS in Business Administration and Management from California State University-Northridge.
    Gevorg Grigorian
    Appliance Repair Expert
    Expert Answer
    You'll need to open the latch on the side of your washing machine, empty the water in the small black hose, then twist the filter counterclockwise to remove it.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 3 Helpful 6
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Video

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!

      You Might Also Like

      Fixing a Clogged Bathtub Drain without Calling a Plumber
      How to
      Install a French Drain System in Your Yard
      Effective Ways to Deodorize Stinky Drains (Plus, How to Prevent Smells)
      How to
      Unclog a Drain or Garbage Disposal with Baking Soda & Vinegar
      How to
      Install a Kitchen Sink Drain
      How to
      Remove a Shower Drain
      How to
      Use a Chemical Drain Cleaner
      The Best Ways to Clean Your Kitchen Sink Drain
      How to
      Make a Pop up Drain Stay Closed
      How to
      Install a Sink Drain
      How to
      Install a Tub Drain
      How to
      Unclog a Septic Leach Field
      How to
      Clean a Drain Pipe
      How to
      Clean a Bathroom Sink Drain
      Advertisement

      References

      1. ↑ https://www.thisoldhouse.com/plumbing/reviews/washing-machine-hoses
      2. ↑ Gevorg Grigorian. Appliance Repair Expert. Expert Interview. 30 July 2020.
      3. ↑ https://youtu.be/dns6Gt3yIKk?t=30
      4. ↑ Gevorg Grigorian. Appliance Repair Expert. Expert Interview. 30 July 2020.
      5. ↑ https://www.insider.com/guides/home/how-to-unclog-a-sink
      6. ↑ https://www.insider.com/guides/home/how-to-unclog-a-sink
      7. ↑ Gevorg Grigorian. Appliance Repair Expert. Expert Interview. 30 July 2020.
      8. ↑ Gevorg Grigorian. Appliance Repair Expert. Expert Interview. 30 July 2020.
      9. ↑ Gevorg Grigorian. Appliance Repair Expert. Expert Interview. 30 July 2020.
      1. ↑ https://www.thisoldhouse.com/how-to/clear-any-clogged-drain
      2. ↑ Gevorg Grigorian. Appliance Repair Expert. Expert Interview. 30 July 2020.
      3. ↑ Gevorg Grigorian. Appliance Repair Expert. Expert Interview. 30 July 2020.
      4. ↑ Gevorg Grigorian. Appliance Repair Expert. Expert Interview. 30 July 2020.

      About This Article

      Article Summary X

      To clear a clog from a washing machine, try unhooking the drain pipe and pouring hot water down the drain to release the soap and scum. For stubborn clogs, push a plumbing snake down the drain. As it goes down, turn the handle clockwise anytime you feel a clog, which will grab the debris and allow you to pull it out. To check if the drain is clear, pour some water down the pipe. With the clog gone, reattach the hose to the machine and run the machine with no clothes in it to make sure it’s fixed and there are no leaks. For more help, like how to clean your washing machine drain with a commercial cleaner, scroll down.

      Did this summary help you?
      In other languages
      Thanks to all authors for creating a page that has been read 554,898 times.

      Reader Success Stories

      • Lee Smith

        Nov 1, 2022

        "My husband passed away a little less then a year ago. He was very handy and fixed everything. When the washer first ..." more
      More reader stories Hide reader stories
      Share your story
      If you buy through links on our site, we may earn a commission .

      Did this article help you?

      Advertisement