PDF download Download Article PDF download Download Article

If you have the right tools, cutting a boy’s hair can be easy and certainly less expensive than going to the salon every month. There are a few different methods you can use to cut hair, depending on the style the boy wants and the texture and length of his hair. A typical boy’s haircut uses electric clippers on the sides of the head and then scissor work on top. However, boys have different ways of cutting their hair, depending on their style and hair texture.

Method 1
Method 1 of 3:

Using Electric Clippers

PDF download Download Article
  1. As you cut, hair will fall onto his neck and shoulders. These stray hairs can be itchy and messy. [1]
  2. Typically, the lower the number, the shorter the haircut. Each number clipper corresponds to the length of hair that will be left after you use the electric clippers. For example, zero is a skin level, and number two is a sort of shorter medium length. Look on the instructions to your clippers to determine which clipper extension corresponds to which hair length. [2]
    • If the boy has thin or fine hair, you probably do not want to use clippers. Toddlers, unless they have thick, dark hair, probably also should not get a haircut with electric clippers.
    • If the boy has thick hair or dark hair, clippers are probably a good choice for him.
    Advertisement
  3. Many traditional boys’ haircuts are cut with clippers on the sides and then scissors on top. However, some haircuts use clippers on the entire head. This will be a more uniform look than clipping around the sides and scissoring on the top.
    • If you plan to use scissors on the top, choose the place where you want to stop clipping. Pick a point where you want the clipper cut to transition into a scissor cut. Right above the occipital bone is a common place. [3] Be consistent about how high on the head you want to stop clipping.
    • Mark the place where you will stop using the clippers with a washable marker, or just be careful to go to the same height every time.
    • It is also possible to use different clipper settings to create a fade.
  4. Place the clippers at a ninety degree angle from the boy’s head. Clip from the base of the neck straight up. You always cut from the bottom up. [4]
  5. Make sure that you’re using smooth, even cuts and are not missing any little strips along the way. Start from the bottom of the head and move upwards, still holding the clippers at a 90 degree angle.
  6. You can now use the attachment-less clippers to “clean up” the area around the boy’s hair. You can use the clippers now on the stray hairs on his neck and around his ears and sideburns. [5]
  7. Advertisement
Method 2
Method 2 of 3:

Using Scissors

PDF download Download Article
  1. You should start with a small amount. You can always take off more if you still think it’s too long.
    • A good amount to start with, unless the boy has really long hair, is probably about an 1/8th of an inch. When using scissors you should go slowly and not cut off too much too fast.
    • Make sure that the hair is dry when you cut it. Cutting wet hair is more challenging, and cutting with dry hair will ensure that you know exactly what it will look like while you’re cutting it.
  2. This cut determines how long you want the rest of the hair to be. Comb the front most part of the boy’s hair back, about enough to hold between two fingers, with the comb and then transfer the hair to between the index and middle fingers of your nondominant hand.
  3. Try to make the cut even, but you can always go back later and trim unruly hairs. This should leave the front-most section of the boy’s hair a little bit shorter than the rest.
  4. Include a little bit of the guide cut to show you how much hair to cut. Continue this process, working back towards the back of the head. Always include a little bit of the cut you just did to guide you. [6] You should be able to make your way all the way to the back of the head with this process.
    • If you are cutting with scissors on the sides, too, use this same method. Start from the front and move backwards, using your guide cut. However, if you would rather make your guide cut in the back, you can also start in the back and gradually move to the front. [7] Always grab a little bit of the cut you just did in your new cut so that you know how much you should cut off.
  5. Fold the right ear down (or have him hold it down for you) as you cut around the ear, as if you were tracing it. Repeat on the left side. This is an alternative to using the clippers.
  6. Advertisement
Method 3
Method 3 of 3:

Blending a Clipper Cut with a Scissor Cut

PDF download Download Article
  1. You should be combing it out to the side, so that the comb is perpendicular to the floor. Incorporating both the section done with the clippers and the section with the scissors, comb the boy’s hair out to the side with your nondominant hand.
    • On the boy’s haircut right now, there should be the clipper cut on the bottom and the scissor cut on the top. There will be a line where the clipper cut ends and the scissor cut begins. The middle of your comb should be at this line.
  2. Transfer the hair from the comb to between your nondominant middle and index fingers. Pull the hair out to where the longest hair is about even with your finger. [8]
  3. Extra hair is hair that is beyond your fingers. Put the scissors vertically, parallel to your fingers, and cut this extra hair. This process will blend the clipper cut into the scissor cut.
  4. Advertisement

Community Q&A

Search
Add New Question
  • Question
    How can I cut my teenage boy's hair? He doesn't want a haircut, but he needs one desperately, and I want him to have a buzz cut. Should i just force him?
    Community Answer
    No. It's his hair and he should have some kind of say in it. If he wants long hair and you want him to have a buzz cut, try to compromise on something in between.
  • Question
    How do I give teen boys a shave?
    Community Answer
    If it is on the face, just use a razor and make sure you use plenty of shaving cream. If you don't use enough or any at all, it can cause irritation and sometimes a dry, uncomfortable rash.
  • Question
    My son is 11 years old and has had an undercut for most his life. He wants to grow his hair out to medium length. Should I let him?
    Community Answer
    I think you should let him. It is his form of self-expression, and it may make him feel more confident in his look. If he doesn't like it, he can cut it off again.
See more answers
Ask a Question
      Advertisement

      Video

      Tips

      • It is useful to invest in a pair of high quality sheers and clippers, as they will yield better results and making styling easier.
      • Many boys’ haircuts use a mixture of scissor work and clipper work. Have both at your disposal to maximize the amount of hair styles you can do.
      • If you are unsure about length, always start off cutting hair longer and then going shorter until you reach the desired look.
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!
      Advertisement

      Warnings

      Advertisement

      About This Article

      Article Summary X

      The easiest way to cut a boy’s hair is to use electric clippers set to the length you want. Once you have your clippers adjusted, start from the bottom of the hairline and shave in smooth cuts all around the head, moving from the bottom to the top. If the boy has thinner hair, you should only clip the sides and trim the top of his head with scissors. To trim the top, comb the front of his hair back, hold it between 2 fingers, and cut parallel to your fingers. Then, pull back the section of hair right behind that cut and use your first cut as a guide. Repeat this process as you work your way to the back of the head until his hair is at an even length. For more help, like how to blend the top and the sides, read on!

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 436,661 times.

      Did this article help you?

      Advertisement