PDF download Download Article PDF download Download Article

Tractor driving is different from the standard family transportation. You'll be handling a vehicle that is large, powerful and potentially dangerous if not handled properly. [1] This article will provide some assistance in knowing how to drive a tractor with care.

Part 1
Part 1 of 2:

Starting the engine

PDF download Download Article
  1. Sit in the seat. If recommended, put on the seat belt.
  2. Advertisement
    • If it is a cold start, inject ether into the fuel lines.
    • If the tractor has glow plugs, turn the key to warm them, for an easier start up.
  3. Hold for approximately 8 seconds before letting go and trying again.
  4. If the tractor continues failure to start, it is recommended to spray starting fluid into the lines. [2]
  5. Advertisement
Part 2
Part 2 of 2:

Driving the tractor

PDF download Download Article
  1. Now that your tractor has started, depending on the year, it may have a steering wheel hand clutch, which will be located on the right of your steering wheel. This is usually found in John Deere 4020's. [3] Locate your shifter, and most tractors follow the same procedure for taking off.
    • If it has a hand foot clutch, the shifter will be in between your legs, near the foot petals.
    • If your shifter is on your right hand side, and is located on the side of the throttle, it is most likely a power shifter.
  2. The tractor has labeled gears between first to the last one, including reverse. Push in the clutch, which is your left foot and push the shifter into first gear. Throttle the tractor up slowly to increase the RPMs. Slowly release your foot off the clutch and you will feel the tractor begin to move. throttle the RPMs again to increase speed, and power.
  3. Now that your tractor is moving, in order to shift gears, locate second, or the next gear you need. [4] Press in the clutch and shift the gear. Slowly release the clutch and you will feel a small kick or since of power. The gear has locked and you are now in that desired gear.
  4. Now you have learned to shift a tractor, and take off, you need know how to stop. To stop the tractor, depress the clutch, find neutral in the gear shifter. Let off the clutch, and depress the break with your right foot. The tractor should come to a halt, and you have successfully drove a tractor. Throttle the RPM down to the lowest setting, and this is the tractor's idle.
  5. Advertisement

Community Q&A

Search
Add New Question
  • Question
    I have a Case 5250, it starts but is not driving when the engine is engaged. Could this be due to low fuel?
    Community Answer
    No. If it were low on fuel, then the engine wouldn't start. Since the engine starts, your problem is somewhere else.
  • Question
    What do I do when a tractor doesn't have a seat belt?
    Community Answer
    Many older tractors do not have seat belts. If yours does not have a seat belt, skip this step. Consider having a ROPS and seatbelt installed on the tractor, or discuss it with your farm's manager.
  • Question
    Where is the throttle?
    Community Answer
    On most tractors, the throttle is on the floor. Some of the bigger tractors may have a throttle similar to the one in your car. Just be careful not to go to fast with the throttle.
See more answers
Ask a Question
      Advertisement

      Video

      Tips

      • Before getting in the tractor, you should do a mandatory walk around. Check the oil, hydraulic fluids, tires, radiator, air filter, ROPS and "roll cages".


      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!
      Advertisement

      About This Article

      Article Summary X

      To drive a farm tractor, start by locating the shifter, which will either be on the right of the steering wheel or between your legs, near the foot pedals. Next, use your left foot to push the clutch down to the floor and shift the tractor into first gear before slowly releasing your foot from the clutch. Repeat this process to shift the tractor into second, third, or other gears. Finally, stop the tractor by depressing the clutch, pushing the gear shift into neutral, and releasing the clutch before using your right foot to press on the brake. To learn more about how to drive a farm tractor, like how to start a tractor with glow plugs, keep reading!

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 80,964 times.

      Did this article help you?

      Advertisement