PDF download Download Article
Control invasive, creeping vines to protect your home and garden
PDF download Download Article

English ivy may be pleasing to the eye, but when it quietly creeps across the ground and up trees and buildings, it can smother or damage anything in its wake. But there are some effective tactics that’ll fend off this creeping invader for good. We’ll show you how to kill and control English ivy growing on trees, walls, or the ground, as well as how to kill it with herbicides for the most effective control.

Things You Should Know

  • If you’re removing ivy from a tree, cut the vines around the base of the trunk, then all the vines on the tree at shoulder height to starve the vines further up.
  • Use clippers to trim ground ivy into large square sections, then use your hands to roll those sections into logs. Or, mow over ivy to mulch it.
  • Mix and spray a 2-5% solution of glyphosate or triclopyr onto ground or wall ivy to control it chemically, and repeat herbicide application as needed.
Method 1
Method 1 of 3:

Killing Ivy on Trees

PDF download Download Article
  1. Walk around the tree and cut through every vine growing up the tree at about ankle height using shears or clippers. Work until the vines on the tree are completely severed from the ground. Even 1 remaining uncut vine can nourish the ivy further up the tree, so make sure not to overlook any tendrils.
    • For very old, thick vines, use a lopper or a handsaw to carefully sever the vine.
    • As you work, avoid making cuts on the tree itself. Ivy weakens trees and makes them more susceptible to disease. Cutting through the bark could cause further damage.
  2. Use the same technique to cut the vines a bit further up. This time, pull the cut sections of vines away from the tree as you go. By making 2 cuts and removing the section of ivy at the bottom of the tree, you block nutrients from reaching the vines higher up on the tree, causing them to wither. Mulch the vines or dispose of them in a plastic bag. [1]
    • As you pull the cut vines from the tree, avoid removing too much bark along with the more stubborn tendrils. Work gently but thoroughly.
    • Use the same method to remove ivy from outdoor walls.
    Advertisement
  3. Use shears to cut a line through the ivy along the ground, from the base of the tree to about 6 feet (1.8 m) away. Cut several more lines radiating from the tree to create sections of cut ivy in a circle around the tree. Then pull up the sections with your hands. Pull up the roots, as well, digging them out as needed. [2]
    • Dispose of the pulled ivy in plastic garbage bags to contain it. Avoid composting it, since the ivy may thrive in the compost heap and spread outward.
    • Check the area around the tree every week, and pull up new tendrils as you see them.
    • This is known as a “Lifesaver cut,” named for the popular circular candy. Imagine you’re cutting the shape of a Lifesaver around the tree.
  4. Advertisement
Method 2
Method 2 of 3:

Killing Ivy on the Ground

PDF download Download Article
  1. Use shears to cut lines through the ivy along the ground, dividing it into large sections. This will make it much easier to remove the ivy from the ground. Pull the sections apart from each other as you cut to separate them. Work carefully around plants and saplings you want to keep. [3]
    • If you're working on a hill, cut vertical lines from the top of the hill to the bottom to create sections to roll downhill.
  2. Ideally, the area from which you’re removing the English ivy is void of any other plants. However, if there are native plants growing through the ivy, be very careful not to disturb or remove them. Use your garden shears/clippers to cut the ivy around the native plant so you can pull away the ivy without pulling out the native plant.
    • Check your provincial or state government websites to determine which plants are native to your area, and avoid killing protected, native species.
  3. Lift the edge of one section of ivy and roll it forward on top of itself. [4] Keep rolling the ivy forward until the entire section has been rolled up into a big log of ivy. Move the log to a separate area and continue rolling up sections until you've cleared the area.
    • Mulching the ivy rolls to dispose of them and ensure they won't take root in the area again.
    • If the ivy isn’t thick enough to make clean, rolled logs, use a flat, square garden shovel to scrape it off the ground after loosening it with your hands. [5]
  4. If you don’t have time or the capability to cut and roll the ivy, simply use a lawn mower . Set the mower as low as you can, then mow over any ground sections slowly and thoroughly. Afterward, cover the mowed ivy with 6–8 inches (15–20 cm) of mulch to stifle it.
    • Afterward, spray the mulch with a foliar herbicide whenever new ivy shoots breach the surface of the mulch.
    • Reapply herbicides every 6 weeks or so to permanently keep the ivy at bay.
  5. If you have a patch of ivy you want to preserve without it spreading, use mulch to discourage new growth. [6] After removing excess ivy, surround the ivy you want to keep with 6–7 inches (15–18 cm) of shredded or wood chip mulch . Add new mulch 1-2 more times during the spring and summer seasons.
    • Note that this method requires some upkeep: monitor the patch and cut away any tendrils that venture across the mulch.
  6. Advertisement
Method 3
Method 3 of 3:

Applying Herbicides

PDF download Download Article
  1. Use herbicides in tandem with physical removal to kill English ivy for good. [7] To combat the vines with just herbicide, however, follow the manufacturer’s instructions to mix a 2-5% solution of either glyphosate or triclopyr . Use a handheld sprayer to apply that solution onto the English ivy. Spray enough so that the ivy leaves are wet, but not dripping with chemicals.
    • Ensure the outside temperature is at least 12 °C (54 °F) and clear on both the day you spray and the following day, to make the herbicide more effective.
    • English ivy leaves have a waxy texture to them, which makes it difficult for other herbicides to soak into and kill the plant.
    • Wear a facemask and rubber gloves when spraying herbicidal chemicals, and keep children and pets away from the area for 2-3 days.
  2. Use these herbicides to better control vines after physical removal. Follow the manufacturer’s instructions to mix either a 25% solution of glyphosate or a 2% solution of 2,4-D amine . Use your garden shears/clippers to remove as many English ivy leaves and vines as possible. Use a handheld sprayer to apply the herbicides onto the cut ivy, making sure to concentrate your spray on the raw ends of the stems and vines. [8]
    • Before using any herbicides, check with your local government to determine if either glyphosate or 2,4-D are legal where you live.
    • For the most effective application, make sure it’s at least 12 °C (54 °F) and clear on the day you spray the herbicide, as well as on the following day.
  3. Herbicides are not selective. When you spray herbicides onto an area, they will kill any and all plants in that area, including native plants. If there are native plants in the same location as the English ivy you want to control, use a non-chemical control method instead. [9]
    • Check your provincial or state government website to identify which plants are native to your area.
    • Be aware that some provinces or states consider it illegal to remove or disturb native plants.
  4. English ivy is extremely hardy and resilient, which is part of why it’s considered invasive. Even herbicide use doesn’t guarantee total eradication, but it’s about as close as you can get. Throughout the year following herbicide application, monitor the ivy that’s been sprayed. If any specific areas are not dying off, spray additional herbicides onto those areas. [10]
    • You don’t need to remove dead or shriveled ivy if you prefer not to. These vines decompose harmlessly into the soil.
    • Be aware that using herbicides in an area may prevent further growth of any other plants in that area.
    • Repeat this process 2-3 weeks later if the first application doesn’t eradicate the ivy.
  5. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    My soil is full of ivy roots. How can I get rid of them?
    Andrew Carberry, MPH
    Food Systems Expert
    Andrew Carberry is a Food Systems Expert and the Senior Program Associate at the Wallace Center at Winrock International in Little Rock, Arkansas. He has worked in food systems since 2008 and has experience working on farm-to-school projects, food safety programs, and working with local and state coalitions in Arkansas. He is a graduate of the College of William and Mary and holds a Masters degree in public health and nutrition from the University of Tennessee.
    Food Systems Expert
    Expert Answer
    Once you have removed the vines, any remaining ivy roots will decompose with time.
  • Question
    Will hot composting kill ivy?
    Community Answer
    No. It will grow roots and spread where you use the compost. It is best to bag it and place it in the garbage.
  • Question
    How do I kill the roots of an Ivy plant?
    Community Answer
    Apply clear plastic solarization and/or heavy/thick mulching. Keep mulch away from the tree base/trunk section at the ground level because it still needs air flow and light to prevent mold/fungus/rot.
See more answers
Ask a Question
      Advertisement

      Video

      Tips

      Show More Tips
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!
      Advertisement

      Warnings

      • Wear protective eyewear to shield your eyes from debris and snapping ivy.
      • Always wear rubber gloves and long sleeves to protect your arms when cutting or pulling ivy, as well as when applying herbicides.
      Advertisement

      Things You'll Need

      Killing Ivy on Trees

      • Pruning shears
      • Protective gloves
      • Protective goggles
      • Disposable garden bags

      Killing Ivy on the Ground

      • Pruning shears
      • Protective gloves
      • Protective goggles
      • Shovel
      • Disposable garden bags
      • Mulcher or mower

      Applying Herbicide

      About This Article

      Article Summary X

      If you need to kill English ivy on a tree, use a sharp pair of garden clippers to cut the vines around the base of the tree, then cut the vines again at about shoulder height. For very old, thick vines, use a handsaw and carefully saw through the vine. Wearing gardening gloves, pull the ivy vines away from the trunk of the tree, pulling gently so you don’t strip too much bark away from the tree. If there is a mat of ivy growing along the ground, cut it away as well so it doesn’t grow back up the tree. For tips from our gardening reviewer on killing ivy that is growing on the ground, read on!

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 617,417 times.

      Reader Success Stories

      • Jim Newcomer

        Apr 24, 2018

        "This is one of the best guides to removing ivy ground cover, which is my interest. My business partner is ..." more
        Rated this article:
      Share your story

      Did this article help you?

      Advertisement