How to Make a Henna Cone

Download Article

Your complete guide to make and fill your own henna cone for henna tattoos and art

Co-authored by Moushami Iyer

Last Updated: December 20, 2024 References

Download Article

Cutting & Rolling the Cone

|

Taping & Filling the Cone

|

Video

|

Expert Q&A

|

Tips

In ancient times, henna body art was typically applied using specially-shaped sticks, which required much training to use properly. Nowadays, most artists have made the switch to hand-rolled henna cones. Cones have several advantages over sticks and other traditional application methods—they’re easy to put together, produce more precise lines, and place less strain on the artist’s hands. Making your own henna cone is as simple as rolling a sheet of cellophane or a similar material to the size that suits you best, then taping it up and filling it with your henna paste.

How to Make Henna Cones

Cut out a 6-7 inch (15–18 cm) square from a sheet of Mylar or cellophane.
Cut the square in a diagonal line to create two separate triangles.
Take one triangle and put your finger on the longest side to hold it down.
Use your other hand to start tightly rolling the triangle from corner to the other.
Keep rolling until the sheet is in a cone shape.
Secure the cone with a piece of tape on the outside.
Fill with henna and use.

Part 1

Part 1 of 2:

Cutting Your Material and Rolling the Cone

Download Article

1
Cut a 6–7 in (15–18 cm) square from a sheet of cellophane or Mylar. Using a pair of scissors, snip inward from the outer edge of the sheet, using one of the corners to gauge the size of the finished square. Then, turn the sheet 90 degrees and make a second cut all the way across to the edge opposite your starting point. Your sheet doesn’t need to perfectly square—just do the best you can. ^{[1]
X
Research source}
- You'll find rolls of cellophane and Mylar at most arts and crafts shops, as well as some office supply stores. Pre-cut sheets are also available from online retailers who specialize in henna accessories.
- The thicker the material you use, the better, as it will help the bag keep its shape once it’s been filled. ^{[2]
  X
  Research source}
- To make a larger cone, simply cut your initial square a bit bigger. You can also begin with a smaller square if you prefer a more compact cone with an ultra-fine stream of ink.
Tip: You could cut your starting square out of any kind of sturdy plastic you happen to find lying around if you don’t have any cellophane or Mylar on hand. Be aware, though, that soft, flexible plastics will be harder to shape than more rigid ones.
2
Cut the square in half diagonally to form 2 triangles. Run your scissors along from the point of one corner to the point of the opposite corner. Picture a straight line running down the center of the square, and do your best not to deviate from your imaginary guide. ^{[3]
X
Research source}
- 1 triangle will make 1 cone. You can either discard the second triangle or hold onto it and use it for your next henna cone.
- Some henna artists recommend leaving your material as a square or rectangle, claiming that the extra material provides additional support and helps prevent leaks. You’re welcome to try any of these methods to see which one works best for you. ^{[4]
  X
  Research source}
Advertisement
3
Place your index finger at the appropriate point on your starter sheet. Find the midpoint of the longest side of the triangle you just cut and pin it down with the pad of your finger. If you opted to leave your sheet as a square, your finger can go at or around the center of any of the sides; for rectangular sheets, position it about 1/3 of the way from the edge of one of the longer sides. The spot where your finger is located will become the tip of the finished cone. ^{[5]
X
Research source}
- You can use whichever hand you prefer to pin down the soon-to-be tip of the cone while you shape the surrounding material. However, you may find it easier to do the actual rolling with your dominant hand.
- The basic rolling technique will be the same whether you’re working with a triangular, square, or rectangular sheet.
4
Take hold of the corner adjacent to your anchor finger and fold it over on itself. Curl the corner up, back, and down again in a tight loop. You’ll notice that the material forms a thin cone-like shape. This will serve as the basic structure for the rest of your cone. ^{[6]
X
Research source}
- If you’re right-handed, start with the corner to the right of your finger. If you’re left-handed, start with the corner on the left side.
5
Continue rolling the material without lifting your anchor finger. Pull the material inward towards your finger using a pinching, twisting motion. Don’t worry about the size of the cone too much yet—you’ll be able to adjust it later. Just focus on creating a neat roll with a consistent taper from the open end to the tip. ^{[7]
X
Research source}
- It may help to pick up your anchor finger after each twist just long enough to allow the material to roll without resistance.
- If your cone starts to lose its shape, calmly smooth out the square and start over. It’s more important to do it right than to do it quickly.
6
Adjust the size of your cone by sliding the outer layer of material. Secure the tip of the cone with your non-dominant hand while you tighten or loosen the roll to your desired dimensions. Your cone can be whatever size you like, but it’s recommended that you limit the diameter of the tip opening to about the size of a pin hole to ensure maximum line precision and control. ^{[8]
X
Research source}
- It’s better to end up with a tip that’s a little too narrow than one that’s a little too wide.
- One strategy that may be helpful is to roll the tip of the cone as tightly as possible, then snip off the excess material little by little until it’s exactly the size you need. ^{[9]
  X
  Research source}

Part 2

Part 2 of 2:

Taping and Filling Your Henna Cone

Download Article

1
Place a strip of tape along the seam on the outside of the cone. Tear off a strip of tape approximately 1–2 inches (2.5–5.1 cm) in length and press it into place over the line created by the overlapping material. Run your finger back and forth over the tape a few times to make sure it stays put. ^{[10]
X
Research source}
- Any variety of tape could work, but clear tape tends to be the most forgiving to work with, since it tears and smooths easily and can be peeled off and reapplied if you happen to make a mistake.
- If you like, you can also cover the seam on the inside of the cone with a second strip of tape to be doubly certain that it will hold.
2
Tape around the tip of the cone to reinforce it (optional). Tear another 1–2 in (2.5–5.1 cm) piece of tape and slowly wrap it around the area where the cone comes to a point, make sure to leave the bottom ¹ ⁄ ₄ in (0.64 cm) of the tip exposed. Smoothe the tape carefully when you’re done to avoid crushing and deforming the tip opening. ^{[11]
X
Research source}
- Taping the tip separately will help ensure that it doesn’t split or come apart once you start squeezing the bag.
3
Fill your cone about 1/2 or 2/3 of the way up with henna paste. Once you’ve mixed your henna paste , use a spoon to scoop it into the open end and shake the cone gently to help it settle. Be careful not to overfill your cone. Doing so will make it harder to seal, and could result in an unexpected mess. ^{[12]
X
Research source}
- Henna stains very easily, so be sure to pull on a pair of rubber gloves before you begin handling your homemade henna paste. It may also be a good idea to cover your work surface with a layer of paper towels or newsprint.
- Always use natural henna powder to make your paste, which you can find online or at an ethnic store. Be careful, as there are lots of artificial varieties out there. ^{[13]
  X
  Expert Source
  
  Moushami Iyer
  Henna Artist
  
  Expert Interview. 12 July 2021.}
- Mix your henna powder with water and essential oils to form a paste. ^{[14]
  X
  Expert Source
  
  Moushami Iyer
  Henna Artist
  
  Expert Interview. 12 July 2021.}
- Let your henna paste rest for 4-6 hours before you start using it. ^{[15]
  X
  Expert Source
  
  Moushami Iyer
  Henna Artist
  
  Expert Interview. 12 July 2021.}
Alternative: Add your henna paste to a plastic carrot bag first, then insert the bag into the cone and pipe in the ink for a clean and effortless transfer. ^{[16]
X
Research source}
4
Seal your cone with a rubber band or tape to begin designing. Grab the material around the open end and give it a twist to close it off. Then, slip a rubber band over the bunched material and cinch it down 2-3 times until it’s nice and secure. You’re all set to start creating! ^{[17]
X
Research source}
- If you don’t have a rubber band, wrap a 2–3 in (5.1–7.6 cm) strip of tape around the top of the open end. Use additional tape as needed to cover any visible gaps or cracks. ^{[18]
  X
  Research source}

Expert Q&A

Search

Add New Question

Question

What Colour is pure henna powder?

Moushami Iyer
Henna Artist
Moushami Iyer is a Henna Artist and the Owner of Pastel Zenna, an art store in Chicago featuring Moushami's specialty in blending Zentangles and Henna. With over five years of experience, Moushami specializes in Henna tattoos, Henna-inspired art, woodwork, and offers Henna parties.

Moushami Iyer

Henna Artist

Expert Answer

If you are looking for pure and natural henna powder, buy one that is greenish in color.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 2 Helpful 11
Question

Can I use tin foil?

Community Answer

No, it is not advisable to do so as it will not work well.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 11 Helpful 13
Question

How do you seal the cone to make it look like the professional cones you buy from shops?

Community Answer

Just use tape. You could glue it as well.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 14 Helpful 16

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

Tips

Be sure to store your leftover henna paste in the refrigerator or freezer when you’re not using it to keep it fresh and prevent it from drying out. ^{[19]
X
Research source}

Thanks
Helpful 0 Not Helpful 0
Plastic applicator bottles are also available for artists who don’t want to go to the trouble of rolling their own cones. Just scoop in your henna paste, screw on the top, and give it a squeeze.

Thanks
Helpful 4 Not Helpful 0
If you find hand-rolling your own henna cones too difficult, you also have the option of buying pre-rolled and sealed plastic or paper cones online, or from any art supply store that sells piping materials.

Thanks
Helpful 6 Not Helpful 1

Show More Tips

Submit a Tip

All tip submissions are carefully reviewed before being published

Name

Please provide your name and last initial

Submit

Thanks for submitting a tip for review!

[1]

[2]

[3]

[4]

[5]

[6]

[7]

[8]

[9]

[10]

[11]

[12]

[13]

Expert Source

Moushami Iyer
Henna Artist

[14]

[15]

[16]

[17]

[18]

[19]

Log in

How to Make a Henna Cone

How to Make Henna Cones

Steps

Cutting Your Material and Rolling the Cone

Taping and Filling Your Henna Cone

Expert Q&A

Video

Tips

You Might Also Like

References

About This Article

Reader Success Stories

Did this article help you?

Quizzes

You Might Also Like

Featured Articles

Trending Articles

Featured Articles

Featured Articles

Watch Articles

Trending Articles

Quizzes

Explore Categories