Download Article
Download Article
Before you recycle those cans, you might want to pull off those tabs and make something new from them, like a simple pop tab bracelet or, if you have plenty of tabs, one of these unique wristbands.
Steps
Download Article
-
Configure the alignment of the tabs. If you alternate placing the tops back to front so that the backs of the top layer and the backs of the bottom layer are facing, it will reduce irritation on your skin. -
Cut two pieces of long cord, string or ribbon. They must be at least 24 inches (61cm) long to provide enough length for you to tie knots at the ends.Advertisement
-
Tie the two cords together with approximately 2 inch (5cm) tails.
-
Thread one cord up through the top hole in a tab. Take the second cord and thread it up through the bottom hole.
-
Lay a second tab half on top of the first tab so that the coinciding holes overlap.
-
Thread the top cord over the left edge of the second tab and down through the first tab's top hole.
-
Do the same with the bottom string, through the bottom hole.
- Pull the cords tightly through the tabs––this gives it the layered look.
-
Turn the tabs over. Overlap a third tab on the second one (touching the first tab)
-
Thread the top cord over the first and third tabs, through the third tab's top hole and down through the second tab's top hole.
-
Do the same with the bottom string, through the bottom holes.
-
Continue with this pattern until the bracelet is as long as you need it, alternating back and forth between threading the cords from the back and front.
-
End with a top tab (one that lies on the top layer) by threading each cord up through the corresponding hole.
-
Tie a knot to secure. Cut the ends to approximately two inches (5cm).
-
Tie the ends together in a double knot.
Advertisement
Community Q&A
Search
-
QuestionHow many tabs do I need?Community AnswerIt depends on what size you want the wristband to be.
-
QuestionHow much does it cost to make?Beth H.Community AnswerIt costs as much as a 12 cans of soda.
-
QuestionHow many pop tabs do I need?Community AnswerI used 19 (I have small wrists), but anywhere from 17 to 23 should be fine.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- To make the bracelet even more involved, try adding different elements, such as colored tabs or stones, beads, etc.Thanks
- Cut down on scratching by facing the backs of the tabs into the interior of the bracelet. This keeps the shiny smooth side on the outside. It also makes the entire bracelet reversible because both sides will have the shiny smooth side on the outside. One side will have Xs, one will have lines!Thanks
- Add a bead on one end and tie a loop on the other for an easily-removable bracelet.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Be careful when wearing the bracelet or sliding it on and off. The backs of the tabs can scratch. To prevent this you can cover the back with sports tape to protect your skin from the sharp edges.Thanks
Advertisement
Things You'll Need
- String, cord, ribbon, etc.
- Scissors
- Several pop can tabs (25+)
About This Article
Thanks to all authors for creating a page that has been read 359,315 times.
Advertisement
84%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
