Download Article
In-depth guide to power 2 speakers with a 1 channel amp
Download Article
Do you want to pair two speakers with one amp? This wikiHow article walks you through using a one-channel amp to power two speakers.
Steps
-
If you connect the speakers in series, you're adding the speaker impedances together. Example: You have two 4 ohm speakers you want to connect to an amplifier with an output impedance of 8 ohms. For this case, you want to put your speakers in series, so the total impedance of the speakers will be 4+4=8 ohms, matching the amplifier. [1] X Research source -
Plug the negative terminal (-) of the amplifier into the negative terminal of the first speaker.Advertisement -
Connect the positive terminal of the first speaker to the negative terminal of the second speaker. -
Connect the positive terminal of the second speaker to the positive terminal of the amplifier.
Advertisement
-
For a parallel connection of two speakers, the resulting impedance is half of the impedance of the amplifier (assuming the speakers have the same impedance). Example: You have the same two speakers, but the amplifier has a 4 ohm output. For this case, you want to connect the speakers in parallel because the impedance would be 8/2=4 ohms, again matching the amplifier. [2] X Research source -
Plug the negative terminal (-) of the amplifier to the negative terminal of speaker 1. -
Hook the negative of speaker 1 to the negative on speaker 2. -
Plug the positive terminal (+) of the amplifier to the positive terminal of speaker 1. -
Hook the positive of speaker 1 to the positive on speaker 2.
Advertisement
Community Q&A
Search
-
QuestionHow do I add rear surround speakers to my stereo receiver if it only has connections for 2 speakers?Community AnswerA stereo receiver will only play stereo (two channels) no matter how many speakers you hook up. You have to have a surround sound system to have rear speakers that actually work properly.
-
QuestionHow can I connect 2 8 ohm speakers so they remain 8 ohm?Community AnswerThe best way is to wire them in series, but make sure that you have a powerful enough amplifier to power them, with an output rating of 16 ohms or more.
-
QuestionHow do I add subs to a Sony surround system?Community AnswerYour amp probably has a line level (like a headphone jack) sub output, so you can just buy any active subwoofer and plug it in through that.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- You can also connect more than two speakers in parallel. If they have the same impedance, then the resulting impedance is the impedance of one speaker divided by the number of speakers. So the impedance of three 8 ohm speakers connected in parallel is 2.7 ohms.Thanks
- You can connect more than two speakers in series--and the impedance will also add. So the impedance of one 8 ohm speaker and two 16 ohm speakers connected in series is 40 ohms.Thanks
- You never join 2 wires together at the amp, e.g. pos (+) of speaker 1 and pos (+) of speaker 2 both to same pos (+) of the amp or the same with neg (-) connection.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- If the impedance of the speakers is too low, you could damage the amplifier trying to drive them.Thanks
- Please consult your amplifier manual for exceptions, variations and warnings, or you may have an expensive lesson.Thanks
Advertisement
References
About This Article
Thanks to all authors for creating a page that has been read 368,016 times.
Advertisement
