Q&A for How to Clean a Front Load Washer

The best thing you can do is preventative maintenance. Clean the filter monthly. After you use the washing machine, always leave its door a little bit open, so that you don't give the water time to sit in there, build up, and create that mildew. If it's too late for that, you can use vinegar: pour a good amount of vinegar down in there and run a cycle to hit the mildew. Then open it up, wipe out the lid area that you can access with a microfiber or rag, and then leave the door open to let it air out.

It could be that the washer is not leveled, dispenser is clogged, or the washer is getting low water pressure. If your washer is getting low water pressure, check the inlet hose screens for a blockage. To check the screens, turn the water off at the water valves. Remove the hot and cold water hoses from the back of the washing machine. Use a pair of needle-nose pliers or a suitable tool to remove the filters. Clean the filters and reinstall them, and then reattach the hoses.

Yes - the seal is manufactured in such a way as to provide a serviceable component.

The filter will be located in front of pump, which is underneath the drum. Usually 3 screws secure the front bottom cover. Block up your machine and you'll have easier access.

Remove the panel that is at the bottom corner on the front; there is a small drain hose in there. Take and twist the plug out and drain. There is a lot of water that will come out, so have a bucket ready.

Use a disinfectant wipe to wipe the drum, seal and door and let air dry. Do this in between wash days. Also, be sure to drain the tub if there is a drain tube; the water left in the bottom does and will build mold.

You may wish to try one or more fabric softener products, which also protect fabrics and garments. If that doesn’t work, consider using either 1) less; or, 2) a gentler or “free”/“clear” detergent.

No! Have a tray ~1” deep handy, though: you’ll first need to let a few cups of water drain out of a tube next to the filter. This gets most of the water out, but leave that tray under it because the filter will still trickle some water once opened. Fear not, however–it’s a very simple process.

Follow the instructions above regarding maintenance. You’ll need to use a bleach solution(s). It’s probably best for you to first hand-clean the “slime” (ideally 10% bleach solution, but any household cleaner will work), and then run a hot cycle with ~1-2 cups bleach, as above.

You may want to contact your manufacturer to troubleshoot before spending money. Plus, it could be under warranty, depending on your situation. Otherwise, they can also provide you "their" pricing for any parts. Third party repair companies may also provide a free estimate.

Call LG directly: all manufacturers sell their parts, or they’ll direct you to the vendor to be used. Alternatively, contact a local repair person–s/he may be cheaper than an OEM part.

Call a technician or your manufacturer. You may need a new part and/or repairs.

You may use any standard cleaning solution, even if it’s branded for the kitchen or bathroom. However, if you need to remove mold or mildew, you should use a bleach solution. Dilute to approximately 10%-20% and scrub the mildew with a toothbrush. Wipe with a rag as you go. Once clean, wipe completely with warm water alone to remove all particles and to remove the bleach.