Download Article
Understanding what causes the VSC light to come on
Download Article
If the VSC light on your car’s dash has recently lit up, you may wonder what it means and what you need to do about it. If so, you’ve come to the right place! This light is part of your car’s electronic stability system, which helps keep your car safely on the road, even in hazardous conditions. Read on to find out how to fix a VSC light, what it means, and if it’s safe to drive with the light on.
How to Deal with a VSC Warning Light
- If your car’s VSC lights up while driving, stop the car and try to reset it as directed in your owner’s manual.
- Alternate methods include disconnecting and reconnecting the battery or using an OBD-II scanner to clear the error.
- If the VSC light reappears after resetting, take your car to a reputable mechanic.
Steps
Section 1 of 6:
Fixing a VSC Light
-
Stop the car and press the stability control system reset button. If the vehicle stability control (VSC) light comes on, pull over and put your car in park. Locate the VSC button. It’s usually near the shifter or steering wheel.
- Press VSC button and hold for a few seconds until the TRAC OFF and VSC OFF indicator lights come on. The traction control and vehicle stability systems are now off.
- Press the VSC button again to reset both systems.
- Refer to your owner’s manual for specific instructions to reset the VSC light in your vehicle. [1] X Research source
-
Disconnect the battery and then reconnect it. Disconnecting the battery will reset your car’s computer and clear any error messages. [2] X Research source Loosen the nut with a socket wrench and remove the negative battery terminal. Wait 15-30 seconds, then reconnect the terminal.
- Always turn your car off before disconnecting the battery to help prevent electrocution.
- Pro tip: This solution will only work in older vehicles (mostly those made in the pre-2000s). Newer vehicles with VSC systems have memory codes stored in the ECM, so disconnecting the battery won't do anything to fix the problem.
Advertisement -
Use an OBD-II scanner to read and clear the error code. OBD-II scanners are available at most auto parts stores. Hook the OBD-II reader into your car’s diagnostic link connector (DLC). [3] X Research source Follow the scanner’s instructions to scar your car’s OBD codes and reset the VSC light.
- Resetting the codes will not repair any underlying issues with the system.
- If the VSC light turns on again, your stability control system is malfunctioning and needs to be repaired.
-
Take your car to a mechanic to fix the underlying problem. If the VSC light comes back on again after you’ve tried to reset it, there may be a malfunction with the system or a glitch with your vehicle’s computer. A mechanic will be able to run a more in-depth diagnostic scan to identify the problem. They can then repair the problem and clear the error codes.
- The cost for repairing a VSC system can vary depending on your car’s make and model. [4] X Research source
Advertisement
Section 3 of 6:
What causes the VSC light to come on?
-
System Failure The VSC light turns on when your car’s stability system fails. The VSC light is on your dashboard to warn you when there’s an issue with the VSC system. If the light is off or only comes on briefly when you start your car, the VSC system is working correctly. [8] X Research source
-
Anti-lock Brake Malfunction The VSC and anti-lock braking system (ABS) in your car work together, so if there’s a problem with one, it can affect the other. This includes a malfunction in any of the ABS sensors in the wheels of your car.
- The VSC and traction control lights can turn on at the same time. These two safety features use some of the same systems, including your car’s ABS. When you see the VSC and the TRAC OFF lights come on, it indicates a problem with the components these systems share. [9] X Research source
-
Wheel Misalignment A wheel going out of alignment is a common reason the VSC light turns on. Hitting a pothole or not slowing down for a speedbump can cause one or more wheels to go out of alignment, which can affect the VSC system. [10] X Research source Regular wheel alignments are often part of recommended vehicle maintenance schedules.
- If your VSC light comes on and you suspect it’s due to your car’s wheel alignment, pay attention to how it handles.
- Signs of a misaligned wheel are a crooked steering wheel while driving straight, a sensation of being pulled to one side, squealing tires, and uneven tire wear.
-
Faulty Steering Angle Sensor The steering angle sensor is designed to detect how far the wheels have turned. Since the VSC system uses the tire angle to determine whether the car is heading in the direction you’re steering, any damage to this sensor can cause the light to come on. [11] X Research source
- When you’re driving, if the steering seems “loose” or unresponsive, it can signal that there’s a problem with the steering angle sensor. [12] X Research source
- The check engine or traction control lights may also light up when there’s an issue with the steering angle sensor.
- A faulty sensor can also cause your car to pull to one side.
-
Faulty Wiring Your car uses wires to send information from the sensors to the computer. If one of those wires is broken, you may see the VSC light come on. Improperly installed wires and blown fuses can also cause a warning light to illuminate.
- Unless you have extensive experience dealing with automotive electrical systems, it can be difficult to track down a wiring issue. [13] X Research source
- When you’ve ruled out other problems, take your car to a mechanic to determine whether the wiring is faulty.
- Keep in mind: A blown symptom is typically a symptom of something else that's causing the fuse to overload.
-
Engine Issues If you have issues with the engine, like a misfire or other mechanical problems, they can also cause the VSC light to come on. A misfire can cause the engine to shake, triggering the VSC light. If you see the Check Engine and VSC lights come on at the same time, it’s a sign that there’s an engine problem.
- If the engine misfires, you may notice your car accelerates slowly or shakes during acceleration. It can also have a rough idle.
- Engines misfire for various reasons, including a clogged fuel injector, faulty oxygen sensor, or bad spark plug. [14] X Research source
-
Accidentally Pressing the VSC Button Most cars are equipped with a button that allows you to turn the VSC system off. If you accidentally bump the button while driving, the system will turn off, and the light will come on. If you suspect this is what happened, all you have to do is turn the system back on by pressing the button again.
- Refer to your owner’s manual for the exact placement of your VSC system’s reset button.
- If the light comes back on after you have turned the system back on, try to rule out other causes or take your car to a mechanic.
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
References
- ↑ https://youtu.be/JsWLVemqiaI?t=16
- ↑ https://youtu.be/XKqotZjqbBQ?t=64
- ↑ https://www.nyvip.org/PublicSite/OBDII/diagnostic-link-connector.html
- ↑ https://www.kbb.com/car-advice/electronic-stability-control/
- ↑ https://fixautousa.com/blog/must-know-about-electronic-stability-control-light/
- ↑ https://www.nhtsa.gov/document/final-regulatory-impact-analysis-electronic-stability-control-systems-0
- ↑ https://www.motortrend.com/features/traction-control-vs-stability-control/
- ↑ https://fixautousa.com/blog/must-know-about-electronic-stability-control-light/
- ↑ https://www.chicagotribune.com/2015/12/02/what-is-the-difference-between-stability-control-and-traction-control/
- ↑ https://argonautgarage.com/5-common-causes-of-the-electronic-stability-control-light-coming-on/
- ↑ https://argonautgarage.com/5-common-causes-of-the-electronic-stability-control-light-coming-on/
- ↑ https://youtu.be/2S1N66PyA8w?t=151
- ↑ https://www.synchrony.com/blog/automotive/8-common-electrical-problems.html
- ↑ https://www.cars.com/articles/what-is-a-misfire-and-what-causes-it-437350/
- ↑ https://www.iihs.org/news/detail/life-saving-benefits-of-esc-continue-to-accrue
- ↑ https://www.kbb.com/car-advice/electronic-stability-control/#esc-problems
- ↑ https://www.motortrend.com/features/traction-control-vs-stability-control/
- ↑ https://www.capitalone.com/cars/learn/finding-the-right-car/what-is-traction-control-what-is-stability-control/1287
- ↑ https://www.kbb.com/car-advice/traction-control/
- ↑ https://www.autoblog.com/article/what-is-traction-control/
About This Article
Thanks to all authors for creating a page that has been read 13,287 times.
Advertisement