Blanket binding gives you an attractive way to finish a blanket. A satin or ruffled binding gives a "finished" look to a blanket you have made. You can find blanket binding in the crafts section of discount stores or in specialty crafts and hobby stores. Follow the steps below to learn how to apply blanket binding.

Steps

    • You can also determine the amount of binding by multiplying the length of one side by 2 and the width by 2. Add the results to find out how much binding you need.
  1. Use a 1/4-inch (6.35 mm) seam allowance, reducing the amount of bulk by sewing the seam diagonally.
    Advertisement
    • Pin the binding close to a corner and leave about 1/2 inch (1.27 cm) as a tail to tuck under. Catch the front and back of the binding as you are pinning it to the blanket.
    • Extend the blanket binding past each corner so you can make a diagonal fold.
    • Turn the corner and look at the underside of the blanket to make sure the corner of the binding looks neat.
    • Push the extra blanket binding with the head of a pin to get the extra binding inside the mitered corner. Pin both mitered edges on the top and bottom of the blanket. Repeat this step for the remaining 3 blanket corners.
    • Use a straight stitch, zig-zag stitch or a decorative stitch.
    • Keep your stitching as straight as you can. Stitch slowly to ensure that you sew a straight line and catch the top and bottom edges of the blanket binding.
  2. Advertisement

Community Q&A

Search
Add New Question
  • Question
    I'm sewing binding on two sides, not four. How do I end, tuck it in or what?
    Community Answer
    Yes, just fold about one inch of the binding inside. It's up to you whether or not to sew the ends closed.
  • Question
    How do I avoid my blanket binding ruffling up?
    Robin Browning Wiles
    Community Answer
    If you're applying the binding to something stretchy, it could be you need to use a zigzag stitch. If you're not using stretchy materials, be sure to pin the binding in place. If that isn't it either, I would wonder if the tension is set properly. Try stitching on scrap material - are the stitches nice and flat without pulling? Next, try applying a small piece of binding to scrap fabric; if it's not ruffled, then maybe you are using too much pressure when applying your blanket binding. There are a lot of variables, so you may have to test out a few different solutions to find the right one.
Ask a Question

      Advertisement

      Video

      Tips

      • Backtack the mitered edge on the sewing machine. You will need to stop stitching, cut the threads (both the bobbin thread and upper thread), reposition the blanket and begin stitching again due to the length and width of the blanket. Stop, cut the threads and reposition the blanket as you approach the remaining 3 corners.
      Advertisement

      Things You'll Need

      • Measuring tape
      • Sewing machine
      • Blanket binding
      • Straight pins
      • Thread

      Expert Interview

      Thanks for reading our article! If you’d like to learn more about sewing blankets, check out our in-depth interview with Shaelynn Haning .

      About this article

      Thanks to all authors for creating a page that has been read 68,538 times.

      Reader Success Stories

      • Robin Browning Wiles

        Jun 14, 2017

        "I'm adding binding to a store bought knitted blanket for my granddaughter. I never figured out if corners were ..." more
        Rated this article:

      Did this article help you?

      Advertisement