How to Change Headlight Bulb on a Chevrolet Silverado

PDF download Download Article
PDF download Download Article

This set of instructions will show you how to change a headlight bulb on the 1999-2007 Chevrolet Silverado, the GMC Sierra, the Suburban 99-06, and the Yukon/Tahoe of the same years. Different models will vary.

Part 1
Part 1 of 2:

Removing the Old Bulb

PDF download Download Article
  1. Set the emergency brake and release the hood by pulling the lever located at the far left side of the driver’s footwell.
    • Check to ensure the headlights and the key switch are both off.
  2. Open the hood by inserting your hand in the gap between hood and grill. Locate the lever assembly, and slide leftward slightly. You should be able to lift the hood fully upward. [1]
    Advertisement
  4. Rotate the headlamp retainer pins until they are free of the headlamp housing.
    • If the pins are difficult to dislodge from road dirt, the flat blade screwdriver may be useful. Insert between headlight housing and pin, and twist gently to dislodge pin.
  5. Make sure to note which location the pin came from, as they are not interchangeable.
    • Do not pull quickly . There is a wiring harness connected to the back that is easily damaged.
  7. While holding the headlamp housing, disconnect the harness from the bulbs by squeezing the connector and pulling it straight away from the bulb. [2]
    • This can be difficult; sometimes it can be useful to set the housing on a stand while you do this.
    • Ensure the surface you are working on is soft enough to not mar the headlamp surface.
  9. [3]
    11. Advertisement
Part 2
Part 2 of 2:

Installing the New Bulb

PDF download Download Article
    • Do not touch the glass part of the bulb with your fingers. The oil on your fingers will cause the bulb to prematurely fail. Handle bulb with clean gloves only.
  2. [4]
    • You should hear an audible “click” as the connector fully seats. Tug slightly on the connection to ensure the harness is connected fully.
  5. Make sure you haven’t trapped or pinched any wires. Try to loosely line up the pin holes.
    • If it doesn’t seem to be lining up, take two steps back and look at it. You should be able to see what side isn’t correct.
  6. Make sure they are in the same position they came from.
    • If you have them mixed up, shorter one goes closer to center of vehicle.
  8. Turn headlamps on, and return to front of vehicle. [5]
    11. Advertisement

Community Q&A

Search
Add New Question
  • Question
    Does my whole light have to be replaced, or can I just change the bulb?
    Community Answer
    It depends on the situation. If your light isn't working, it is most likely the bulb that just needs to be replaced. If that doesn't work, check that there is power running to the bulb by checking the socket with a multi-meter. If it reads that there is no voltage, then the problem is with the housing unit of the light instead of the bulb.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 0 Helpful 2
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Video

      Tips

      • If the bulb burns out again quickly, check that you haven’t touched the glass part, and your housing has maintained a good seal and isn’t letting in water.
        Thanks
        Helpful 2 Not Helpful 0
      • If both headlights burn out simultaneously, check your headlight switch and wiring. Suspect an electrical fault.
        Thanks
        Helpful 0 Not Helpful 0
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!
      Advertisement

      You Might Also Like

      How to
      Remove and Install a Transmission in a 1998 Chevy Truck
      How to
      Switch Your Jeep From 2-Wheel Drive to 4-Wheel Drive
      How to
      Use Car Defrosters: A Guide to Mastering the Defrost Button
      How to
      Install a Rear View Camera
      How to
      Open a Gas Tank
      How to
      Replace the Batteries in a Mercedes Key Fob
      How to
      Turn on Your Car Heater in 3 Easy Steps
      Effective Methods to Make Your Car Roar
      How to
      Live in Your Car
      How to
      Identify a Ford Motor
      How to
      Get a Tire Off a Rim
      Why Is Your Car Making Noises When You Start It?
      How to
      Adapt a Mousetrap Car for Distance
      How to
      Fight a Rental Car Damage Claim
      Advertisement

      References

      1. ↑ https://www.dummies.com/home-garden/car-repair/how-to-raise-your-vehicles-hood/
      2. ↑ https://www.youtube.com/watch?v=4dsoNWsULDs
      3. ↑ https://www.youtube.com/watch?v=eUn8Demzp9s
      4. ↑ https://www.youtube.com/watch?v=kVTDlv0R_hA
      5. ↑ https://www.military.com/off-duty/autos/how-to-change-headlight-bulb.html

      About This Article

      Thanks to all authors for creating a page that has been read 55,419 times.

      Did this article help you?

      Advertisement