How to Clean Driftwood

PDF download Download Article
PDF download Download Article

Driftwood can be used for a wide variety of purposes. Aquarium hobbyists use it to add character to their fish tanks. Crafters use it as a base for do-it-yourself home décor projects. Woodworkers build unique furniture pieces from it. Whether you are using driftwood found in the wild or bought from a store it is important to clean it thoroughly before putting it to work. Start by getting rid of any exterior debris. For an extra layer of protection, soak the wood or expose it to heat.

Method 1
Method 1 of 3:

Cleaning & Treating Driftwood Using Water Solutions

PDF download Download Article
  1. Hold your wood underneath a steady stream of water until you feel as if it is clean. Monitor this process carefully as too strong of a water stream can start to strip away the wood. You can also break off finer wood details if you are not careful. Allow the wood to dry outside when finished.
  2. ‘Curing’ driftwood is the most popular cleansing method amongst aquarium users. Place the wood inside a large container. Slowly pour distilled water into the container until the wood is completely covered. Soak for one to two weeks. Remove the wood and allow it to dry in a cool location.
    • You will notice the water darkening over time. This is normal. It is the result of tannins being released. Leaching all tannins from your wood will keep your aquarium water clear. For maximum effectiveness, replace the soaking water if it takes on a ‘tea-color.’
    • When the distilled water appears clear and is no longer noticeably discolored, it is time to remove the driftwood.
    • This is also a good, chemical-free way of diminishing the buoyancy of your driftwood. Ideally, you want your wood to sit on the bottom of an aquarium without floating to the top. [1]
    Advertisement
  3. Get a large container, mix bleach and distilled water together, and place your driftwood under the water. Use 2 teaspoons of bleach per gallon of distilled water. Soaking in a bleach solution will help to kill off any spores or bacteria that are lingering on the wood and help preserve it . Keep the driftwood submerged for a minimum of 15 minutes. [2]
    • If you plan to use your driftwood in an aquarium, it is best if you follow-up a bleach soak with a straight-distilled water soak. For the safety of your fish, all traces of bleach need to be out of the wood.
  4. Woodworking artisans often prefer to use a soda bath to clean their driftwood. Buy a cleansing soda, such as Arm & Hammer Super Washing Soda. Get a large container and mix hot water and the soda together. Keep adding soda until it stops dissolving into the water easily. Then, lower your driftwood into the mixture. Soak for 48 hours minimum.
    • If your driftwood keeps rising to the surface when soaking, you may need to place a rock or other heavy object on it to hold it down and keep it submerged.
    5. Advertisement
Method 2
Method 2 of 3:

Cleaning & Treating Driftwood Using More Aggressive Measures

PDF download Download Article
  1. This is one of the quicker ways to sterilize driftwood found in nature. Place the driftwood in a pot filled with boiling water. Keep the driftwood boiling for 1-2 hours. You may need to refill the water as it boils away. When the time is up, drain the water out, replace it, and repeat the process. [3]
    • Many aquarists like this method as it is virtually guaranteed to kill any fungal spores found on the driftwood.
  2. Get out a cookie sheet and cover it with foil. Place your driftwood pieces on the foil, not overlapping. Bake the wood at 200 degrees for 2-4 hours. You will want to closely monitor this process to ensure that the wood does not start to singe or burn. When finished, set the wood aside and allow it to cool. [4]
  3. If you don’t want to bother with extensive cleaning methods and if you plan to use your wood for a project, you might consider simply applying a varnish or coating to the wood as is. Any grains present on the wood will lead to an uneven finish, but the coating itself will sanitize the wood to some extent.
    4. Advertisement
Method 3
Method 3 of 3:

Removing Solid Debris from Driftwood

PDF download Download Article
  1. If you picked up your driftwood from a natural location, such as a lake, you might see particles of dirt sticking to the wood’s surface. Grab the piece by the end and give it a good shake. Perhaps tap it gently on the ground a few times to loosen any additional grains.
    • This also helps to remove any pests, like ants, from the wood.
  2. If you are working with ‘outside’ wood then you may need to get more serious about removing the grime. Grab a sturdy brush and scrub the wood. Try to go over as much of the surface area as you can. You may want to repeat the scrubbing process after the soaking the wood as well.
    • If you plan to use the driftwood for a craft or furniture project, you may want to carefully consider your choice of brush. A soft-bristle brush will not scratch the wood whereas a wire brush will clean more effectively but can also leave scrub marks behind. It is generally a good idea to scrub with the grain.
    • A wire brush is a good option if you need to remove bark.
  3. Driftwood often contains small nooks that are hard to fully clean. Use a screwdriver or knife to dig into these areas. Carefully apply pressure so that you don’t splinter the wood. [5] If you want a gentler method, push into crevices using the edge of a slightly damp toothbrush. This is especially effective at removing sand. [6]
    • You can also use an air compressor to shoot concentrated bursts of air into deeper holes. This is less damaging then picking and often equally effective.
  4. Removing the outer layer of the wood is one way to get it clean. Use a garnet sandpaper with a light grit. This type of sandpaper works well with handcrafted projects and will not overly scratch the wood. If you want to dig deeper into the wood (perhaps in a rotten area), upgrade to a higher grit.
    • If you are unsure about what your driftwood project requires, go to your local home improvement store to feel your various sandpaper options firsthand.
  5. No one wants driftwood that is infested by insects. Shaking it off will remove some pests, but to get extra reassurance seal your driftwood in a plastic bag and leave it for a few days. Check back for evidence of dead bugs.
    • A more aggressive way to kill off insects is to spray an insecticide into the bag before sealing it. Be warned that the chemical residue from this method could prove potentially fatal to fish if the wood is intended for an aquarium. This is best used in crafting or woodworking situations. [7]
    6. Advertisement

Video

Tips

  • If you are interested in adding driftwood to your aquarium, seriously consider purchasing your wood from a reputable retailer. And, be sure to buy wood intended for water settings, not terrariums. You will still want to soak it in distilled water, but it will be far safer for your fish than wood found outside.
    Thanks
    Helpful 1 Not Helpful 0
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Submit
Thanks for submitting a tip for review!
Advertisement

Warnings

  • Be very cautious using chemicals of any kind when working with aquarium driftwood. The chemicals can leach into the tank water and result in illness, or even death, to your plants and fish.
    Thanks
    Helpful 2 Not Helpful 0
  • When working with bleach or even when boiling water, be very careful. Use protective goggles and gloves when needed and use caution around hot substances.
    Thanks
    Helpful 3 Not Helpful 2
  • Hardwoods are the best driftwood options for both terrariums and fish tanks. Soft woods, such as cedar, are more prone to leaching resin. [8]
    Thanks
    Helpful 1 Not Helpful 0
Advertisement

You Might Also Like

How to
Control an Algae Bloom
How to
Repair a Leaky Aquarium
How to
Install an Undergravel Filter (UGF)
How to
Do a Partial Freshwater Change for Stable Water Chemistry
How to
Clean an Old Fish Tank
How to
Change the Water in a Fish Bowl
How to
Clean a Fish Bowl
How to
Clean a Fish Tank
How to
Clean Fish Tank Rocks
How to
Sanitize a Fish Tank
How to
Keep Aquarium Water Clear
How to
Clean Aquarium Gravel
How to
Clean Aquarium Glass
How to
Remove Fish from an Aquarium to Clean
Advertisement

Expert Interview

Thanks for reading our article! If you’d like to learn more about aquarium maintenance, check out our in-depth interview with Luke Leskovisek .

References

  1. ↑ http://thegoldfishtank.com/goldfish-care/tank/aquarium-driftwood-adding-driftwood-tank/
  2. ↑ http://fishgeeks.com/driftwood-cleaning/
  3. ↑ http://www.thriftyfun.com/tf/Crafts/Nature/Driftwood-Craft-Ideas.html
  4. ↑ http://www.thriftyfun.com/tf/Crafts/Nature/Driftwood-Craft-Ideas.html
  5. ↑ http://www.northwestdriftwoodartists.org/lesson-center/lets-do-some-work-finally/cleaning-your-wood-2/
  6. ↑ http://www.thriftyfun.com/tf/Crafts/Nature/Driftwood-Craft-Ideas.html
  7. ↑ http://blog.minwax.com/01/19/making-a-driftwood-sculpture/
  8. ↑ http://www.aquariadise.com/aquarium-driftwood/

About This Article

Article Summary X

To clean driftwood, start by scrubbing it with a sturdy brush to remove the grime from the surface. Then, use a screw driver to remove loose debris from the nooks, and rub the outside with fine-grit sandpaper to remove the outer layer of wood. If you want to be sure there are no insects in the wood, seal it in a plastic bag and leave it for a few days to kill off any bugs. Alternatively, submerge the driftwood in a tub of distilled water for up to 2 weeks to allow the tannins and dirt to leach out of the wood. For tips on how to bake or boil driftwood to clean it, read on!

Did this summary help you?
In other languages
Thanks to all authors for creating a page that has been read 246,599 times.

Reader Success Stories

  • Kris L.

    Apr 16, 2023

    "I found some driftwood at the beach that I can't wait to make wind chimes out of. This article was very ..." more
More reader stories Hide reader stories
Share your story

Did this article help you?

Advertisement