PDF download Download Article
Follow these best practices to keep your keys clean
PDF download Download Article

If you spend a lot of time at a computer, you may have noticed that your keyboard doesn’t look as clean as when you first started using it. Dust, food particles, and oils from your fingers may have left the keys looking pretty grimy. If you’re using a mechanical keyboard, it's easy to clean the keycaps. We'll show you the best—and easiest—way to clean your keys, below.

Quick Tips for Washing Keycaps

  • Disconnect your keyboard and use a wire keycap puller to remove the keys. Spray the keyboard with compressed air to remove debris.
  • Soak the keycaps in warm, soapy water for 30 minutes. Add 2 denture tablets if your keys are really dirty. Put the keycaps in a strainer and rinse them.
  • Air dry the keycaps for at least 24 hours before popping them back in their correct positions. Dust your keyboard weekly and deep clean once a month.
1

Remove the keycaps.

PDF download Download Article
  1. Take a photo of your keyboard to remember where each key goes before proceeding. For wired keyboards, unplug the wire from the USB port. Purchase a keycap puller to pinch and pull the keys from their slots. [1] Avoid removing large keycaps, like the spacebar, enter, and shift.
    • Wire keycap pullers are less likely to scratch the keys than plastic ones. [2] Place the wire loops diagonally on the key and gently wiggle back and forth while pulling up.
    • A keycap puller can be substituted for a tweezer, flathead screwdriver, butter knife, or bent paperclip.
    • Remove keycaps without a tool by pinching the sides of each key with your finger and pulling up.
    • If you can’t take a picture of your keyboard, look up an online image of the same or similar keyboard.
  2. Advertisement
3

Soak the keycaps in soapy water.

PDF download Download Article
  1. Fill a bowl or container with warm water and a few drops of mild soap. Mix it until bubbles form. Place the keycaps in the solution, ensuring they’re fully submerged. You can also add 2 denture tablets to help remove oils from the caps. [5]
    • Avoid using hot, boiling water or bleach, which can cause the keys to fade.
    • Some users say to let the keycaps soak for 5 to 6 hours, while others say 30 minutes is sufficient. Start with 30 minutes, then check the keys and decide how much longer you want to soak them. [6]
  2. Advertisement
6

Reassemble your keyboard.

PDF download Download Article
  1. Ensure all the keys are placed back in their respective spots and facing correctly. To pop the keycaps back on, push them straight down over the switch with your fingers. Plug the board back in when you’re ready, and test each key to ensure everything is working properly. [10]
    • Clean your keyboard once a week without removing the keycaps. Use a handheld vacuum, a damp microfiber cloth, or compressed air. Perform a deep clean once a month.
    • Disinfect your keycaps with hydrogen peroxide or alcohol wipes.
    • Avoid eating or drinking near your keyboard to prevent crumbs and other build-ups.

Expert Q&A

Ask a Question
      Advertisement

      Video

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!

      About This Article

      Thanks to all authors for creating a page that has been read 81,764 times.

      Reader Success Stories

      • Bob G.

        Sep 19, 2020

        "So, I was cleaning my keyboard and then I found this. So I used it or something an now my keyboard is cleaned, ..." more
      Share your story

      Did this article help you?

      Advertisement