Download Article
Download Article
If your Xbox game disc isn't working properly, it may need a good cleaning. Smudges, dirt, and scratches can prevent the Xbox's laser from reading the disc's data. Cleaning the disc will only take a few moments if you have the right materials, and you can even remove light scratches using household products.
Steps
-
Mix a solution of even parts isopropyl (rubbing) alcohol and water. Isopropyl alcohol is a powerful cleaning agent, and you can get it for cheap from most grocery stores.
- If you don't have isopropyl alcohol, window cleaner will work as well.
-
Hold the disc by the hole in the middle and the outer edges. Avoid touching any of the disc surface.Advertisement
-
Dip a microfiber cloth into the mixture. Microfiber is very tightly-woven, and is soft to the touch. It will pick up dirt and dust without scratching the disc's surface. [1] X Research source
- Don't use tissue, paper, towels, or cotton to wipe the disc. These materials all pose a scratching risk.
-
Wipe the disc from the center straight out to the edge. Rotate the disc and wipe again from the center to the edge. Keep rotating until the entire disc has been wiped.
- Wipe straight from the center instead of in circles. Wiping in circles around the disc can increase the risk of scratching. [2] X Research source
-
Place the disc bottom-up for a few moments to dry. Allow the disc to air dry, but don't place it in direct sunlight. Isopropyl alcohol should only take a few seconds to dry; window cleaner may take a little longer.
- Avoid drying with a dry cloth, as this can promote scratching.
Advertisement
-
Get a non-bleaching toothpaste. Since toothpaste is slightly abrasive, you can use it to polish off light scratches on the surface of your disc. Make sure that it is not a whitening or bleaching toothpaste, as these contain chemicals that can damage the disc. [3] X Research source
- Baking soda toothpaste will give the best results. Avoid gel-based toothpastes.
-
Put a small drop of toothpaste on the disc surface. You don't need much, a little smaller than a pea should be sufficient.
-
Add a small amount of water. Just a drop or two should be enough, you want to be able to make a paste with the toothpaste, but not turn it too runny.
-
Use your finger or a microfiber cloth to buff out scratches. If you're using your finger, make sure that you've cleaned it first to remove excess oils. Apply gentle pressure and rub back and forth over the scratch to polish it out.
- Rub from the center towards the edge, not in a circular motion.
-
Rinse the disc with warm water when you're finished. Make sure that all of the excess toothpaste has been removed from the disc surface. Allow the disc to air dry after rinsing it off.
-
Consider professional resurfacing. If the scratches are too much for toothpaste to handle, your only other option may be professional resurfacing. This is usually a pretty expensive process, and if the game is older it may be cheaper to just buy a new copy.
- Check your local used video game, music, or movie stores to see if they offer disc resurfacing services.
Advertisement
Community Q&A
Search
-
QuestionHow do I get a disc working after it's been in a house fire?Jackson QuesinberryCommunity AnswerIf the plastic is melted in any way it is irreparable.
-
QuestionOne of my games always freezes at a certain point. What should I do to fix this?Community AnswerClean the disc with toothpaste, and also clean your console's laser lens with a dedicated lens cleaner.
-
QuestionHow do I clean the laser lens on my Xbox?Community AnswerYou can buy a laser lens cleaner. You may to give it a few tries as it tends not to load at first.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
Submit a Tip
All tip submissions are carefully reviewed before being published
Thanks for submitting a tip for review!
References
About This Article
Thanks to all authors for creating a page that has been read 125,180 times.
Advertisement
