PDF download Download Article PDF download Download Article

This wikiHow will teach you how to safely clean the inside of your computer. Dust inside a computer can actually slow it down and cause all kinds of problems that aren't fun to deal with, so it's great that you're taking action now! Cleaning the inside of your computer isn't hard once you've got it open and acquired the right tools, and we'll walk you through the whole process step-by-step below.

  1. You need compressed air and a screwdriver (only needed if you must use a screwdriver to open the computer case). A small vacuum might clean up the mess you make around the computer, but should never be used inside it. A dust mask is suggested because it can save you a bit of sneezing if you need to clean a computer quickly.
  2. Advertisement
  3. If you haven't cleaned your computer in a while, a suitable work area is suggested. While you can clean your computer where it sits, it is not recommended. The job can be very messy and you'll want to work somewhere where you can adequately ventilate dust.
  4. Once you have a suitable work area, open your computer. This will vary greatly depending on your machine. If you have a user's manual, consulting it would be a good idea. Most machines have screws holding a side panel down. After removing these, you can then slip the side off your machine.
  5. After opening the computer, use compressed air. Additionally, you might want to wear a dust mask. Never touch the inside of your computer unless it is absolutely necessary. You may discharge a static shock to vital internal components (such as CPU and RAM) and damage them. If you must touch the inside of your machine, discharge any static by tapping your finger to the computer's metal case before unplugging it.
  6. 7
    Begin dusting. Use your compressed air to blow out the inside of your machine. It is usually a good idea to start on the upper region of the computer, then work your way down. In this manner you can sweep out all the dust that settles on lower components in one run. Do not worry if you cause the blades of internal fans to spin. This is expected and it is important to keep these components clean. Be thorough, but do not press on cords or components. Also keep your air source a moderate distance from the component you're working on.
    • Make sure to hold your can of compressed air upright. If inverted, it can be let out as a liquid which can cause severe damage to your computer.
    • Compressed air is freezing cold when it leaves the can; don't let frost form on your chips.
    • A lot of dust can be raised; try not to breathe it. If the PC is very dusty, take it out of doors before using the compressed air.
  7. The heat sink sits over the processor, and it is a collection of metal ridges that stick up away from the motherboard. If this fan does not function properly, the processor will overheat, resulting in degraded performance or permanent damage.
  8. Once you are sure it is cleaned thoroughly, carefully replace the sides. Do not try to force them into place.
  9. 10
    Clean up your work space. The initial run will churn up a lot of particulates. Depending on your workspace, you may need to get a small vacuum and clean the area around the computer. Do not use a vacuum on the inside of the computer. You might want to consider leaving your machine open while you do this. Airborne dust inside the computer will begin to settle and you can make your effort exceptionally productive if you make a second run.
  10. After you've finished dusting, replace the side of your machine and any screws. Once the machine is tightly shut, return it to its usual spot and reattach the power cord and other cables. (You might consider cleaning this entire area to remove excess materials that can contribute to dust intake.) If you flipped the master power switch on the back of your machine off, be sure to turn it on again or your machine will not start. A clean computer will run significantly cooler and last much longer than a computer clogged up with dust and debris.
  11. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    What can I use to clean a circuit board?
    Luigi Oppido
    Computer & Tech Specialist
    Luigi Oppido is the Owner and Operator of Pleasure Point Computers in Santa Cruz, California. Luigi has over 25 years of experience in general computer repair, data recovery, virus removal, and upgrades. He is also the host of the Computer Man Show! broadcasted on KSQD covering central California for over two years.
    Computer & Tech Specialist
    Expert Answer
    Compressed air cans work! If it's not getting clean with just air, though, do an isopropyl alcohol bath. That will clean a lot of it without disturbing any of the components.
  • Question
    How often should I clean my PC?
    Community Answer
    This depends a lot on how you use your PC and where it is located, but you should consider cleaning it every 1-3 months. If your PC is in an environment with a lot of dust or pet hair, you should clean it more often. If its environment is cleaner, you can let it go a little longer.
  • Question
    What are the steps of cleaning a computer outside?
    Community Answer
    Simply wipe external areas with a washcloth sprayed with an all-purpose cleaner that's safe on plastic.
See more answers
Ask a Question
      Advertisement

      Video

      Tips

      • Cleaning your machine outside can save you a lot of clean-up, if you can ensure a stable and clean spot. An open garage and clean work table would be an excellent cleaning environment. However, be sure that there are no extraneous materials, such as wood chips or twigs, that can enter your machine. Particles such as this can cause major damage. If you deal with a lot of dust or smoke near your computer, buy some floor vent filters. They cost only a few dollars for 10 or more of them and you can cover the vents to your computer with them so that dust is filtered out.
      • Wearing a dust mask can save you a good deal of irritation and sneezing, especially if you have breathing or lung conditions.
      • Carry out the cleaning in a bright open area, preferably outside under the sun. The brighter it is, the better hidden dust will be revealed. Be careful to not do the cleaning when the sky is dark during the day though.
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!
      Advertisement

      Warnings

      • Blowing on the inside of your computer is not recommended. This does very little and you run the risk of accidentally spitting on internal components. You might also churn dust up into your face.
      • Never use a feather duster or vacuum inside your computer. Such tools can generate static charges which have the ability to fry internal components. (Using latex gloves is another way of making sure that you don't fry the computer, also do not work in an area where static charges are frequent such as the carpet or Styrofoam mats.)
      • Depending on the manufacturer, opening the case may void the computer's warranty.
      • Never touch internal components. It is completely unnecessary to touch anything inside your computer while cleaning it. The less contact you make the better.
      • Although the process above is very safe, dusting can still lead to anomalous errors. While rare, dusting can sometimes cause just the wrong particle to settle in just the wrong place. However, the benefits of cleaning out your computer far outweigh the risks. In addition, not cleaning your computer can eventually lead to overheating and component failure.
      • Always hold the can of compressed air upright. An inverted can of compressed air can let out bursts of liquid which can damage electronic components.
      Advertisement

      Things You'll Need

      • Compressed air
      • Suitable workspace with adequate ventilation for dust
      • Screwdriver and any other tools necessary to open your computer

      About This Article

      Thanks to all authors for creating a page that has been read 730,516 times.

      Reader Success Stories

      • Douglas Hall

        Jun 28, 2016

        "Good advice. Thanks."
      Share your story

      Is this article up to date?

      Advertisement