Download Article
Download Article
While catching a fish can be as simple as casting out a line with bait and being patient, filleting a fish takes a little more finesse. Knowing the correct process to fillet a fish can make the difference between getting barely enough meat for a side dish and harvesting enough for a fish feast. Plus, freshly cut fish fillets taste much better than pre-cut.
Steps
-
Bleed out the fish, if it is a fresh catch, to preserve the meat. Make a shallow incision with your knife or scissors under the fish's gills, and snap its head backwards to break the spinal cord. Thread a rope through the fish's mouth and out of its gills and let it bleed out into the water for a few minutes. [1] X Research source- Bleeding
a freshly caught fish is vital to preserving its taste and texture. A fish that is caught but not bled out will be much messier on the cutting board and, in its final moments, the stress and struggle of death can make the meat taste acidic. [2]
X
Expert Source
Michael Reynolds
Professional Fishing Instructor Expert Interview. 26 February 2021. [3] X Research source - Put the fresh catch on ice after you have thoroughly bled it out, to further preserve its freshness. You should keep it on ice until you are ready to scale and clean the fish . [4] X Research source
- Bleeding
a freshly caught fish is vital to preserving its taste and texture. A fish that is caught but not bled out will be much messier on the cutting board and, in its final moments, the stress and struggle of death can make the meat taste acidic. [2]
X
Expert Source
Michael Reynolds
-
Descale the fish with the back of a knife. You can scrape the scales off of a whole fish by using long strokes from the tail to the head of the fish with the back of a knife. Alternatively, skinning the fish also removes its scales, and can be done after you have successfully filleted it.- You can also ask your fishmonger to descale the fish for you upon purchase.
- Descaling the fish is recommended but not essential — if you like scales with your fish fillet, leave them on!
Advertisement -
Cut the fish's stomach open to remove its guts . Starting from the tail, run your knife all the way along the fish's body towards the head and open the fish up. [5] X Expert Source Michael Reynolds
Professional Fishing Instructor Expert Interview. 26 February 2021. Remove the guts with your hands, wearing gloves, and use cold water to rinse out any left over insides. You should have a completely clean fish at this point, save for the skin.- This can also be done with fresh fish at the body of water you caught it at, making it much easier to handle its guts and stomach contents. The smell of the guts can attract bears, eagles, and other fish-loving animals, though, so be aware of the wildlife in the area and take the necessary precautions, such as bringing a gun and having a place to retreat to.
- Gutting can be a nasty process, so be sure to have a trash bin nearby that you can throw them into if not at the riverside. Be sure to wipe down your counter afterwards, as the risk of cross-contamination is high when removing guts.
-
Chop off the head at the gills. Lay the fish on one of its sides, and cut the head off with a chef's knife right where it meets the gills. Cut through the fish's spine, which can take a little extra pressure, and follow through to sever the head from the body. You can discard the head, or keep it on ice to use in making fish stock.
Advertisement
-
Cut away fins along the sides, top, and underside with scissors. This should be done before you make cuts to make your work more precise and remove parts of the fish that might get in the way. [6] X Research source
- This can be done at the same time as de-scaling, but must be done before you begin to cut away the fillet.
-
Run your fillet knife down the fish's spine from tail to head. Start your cut at the base of the tail, and use the fish's backbone to guide your cut. Don't cut roughly or saw it away; instead, use a smooth and gentle slicing motion.- As you slice the fillet from the fish, lift the flesh to make sure your cut is still moving in a straight line across the backbone. [7] X Research source
-
Run your fillet knife over the rib cage rather than through it. Delicately work with the shape of the rib cage instead of sawing through the bones. You can remove these bones with tweezers at a later time. [8] X Research source -
Repeat the cut for the other side of the fish. Turn the fish over so the spine is touching the cutting board, and run your knife once again down the backbone from the tail to the head. Because the fish is lighter and does not have as much to grasp onto as before, the second side can be much trickier than the first. You should have two large fillets at this point.
- Watch out for the fish slipping off of the cutting board, as it may be slicker after the first fillet is cut away.
-
Consider cutting each fillet into "steaks" for grilling. If you plan on grilling or barbecuing your fish, it is much easier to work with if it is cut into steaks. Measure out slices about 1.5 in (3.8 cm) thick on each fillet, and cut with your chef knife. [9] X Research source Keep the leftover meat for smaller steaks for kids or to use in fish stock. This is especially effective with large fish such as salmon.
- If you decide to turn your fillet into steaks, do not remove the bones or the skin, as it maintains the structure of the flesh on the grill or barbeque.
Advertisement
-
De-bone the filets with a large set of tweezers or boning knife. There is no way to totally avoid getting bones in your fillet, but you can remove them once the flesh is cut away from the spine. Feel along the middle of your fillet from the head to the tail end for bones, and use your tweezers to carefully remove them. [10] X Research source -
Skin the fillet with a fillet knife. Place the fillet skin-side down and make a cut where the skin meets the flesh. Slowly move your knife towards the opposite end, being sure to firmly grasp the skin and pull it away as you slice. [11] X Research source
- Similarly to de-scaling the fish, it is recommended to remove the skin before preparing a fillet to eat, but if you like the skin on your fish, go ahead and leave it on. The chewy skin is unappealing to some, but it does contain additional nutrients and vitamins.
-
Trim away excess belly fat and other fat. Depending on the type of fish you have, it may have a lot or hardly any belly fat. Salmon, lake trout, and mackerel are known for being high in fat content. [12] X Research source Using your fillet knife carefully cut this away as you would with a steak — after all, these fillets are essentially fish steaks!- If you like fat on your food, by all means leave it on, but generally fish fillets are served as lean as possible.
-
Rinse the fillet with water, then store it on ice for later use. Run water over the fillet then dry it with a paper towel, being careful not to leave any fibers on the flesh. If you won't eat the fish within two days, you should wrap it tightly in plastic wrap, put it into a ziplock bag, and keep it in the freezer. [13] X Research source The fish will stay good for 2 to 3 months in the freezer.
- If you plan on eating it within two days, fill a container large enough to hold the fish halfway with crushed ice, place the fish on top, cover the container, and store it in the fridge.
- You should rotate ice if it melts before you eat the fish. Keep in mind that fish will rot in the refrigerator if not kept on ice.
Advertisement
Expert Q&A
Search
-
QuestionWhere do I cut a fish when I gut it?Michael Reynolds is a Professional Fishing Instructor and the Owner of Long Beach, California Fishing Lessons by Michael Reynolds. In his over 40 years of fishing experience, Michael has become very knowledgeable about the variety of fishing methods and techniques. He is passionate about sharing his knowledge with beginners to experienced anglers. Michael has been guiding and teaching fishing for over five years and is licensed and bonded with the Department of Fish and Wildlife (DFW).Start at the back of the fish by the tail and slice up along the belly up to the gills.
-
QuestionCan I use butter when cooking a fillet fish?Community AnswerYes, but there are better options, as dairy and fish don’t mix well. Consider olive oil, it is hailed as a perfect base when seasoning/cooking fish. Certain fish are good for frying, others are best grilled. Do some research on the fish you have.
-
QuestionDoes taking the skin off make a fish a fillet?Community AnswerNo. Fillet refers to the slab of meat on either side of the center bone. A fish fillet can have skin.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- Make sure to clean your hands and your working surfaces/areas. Wear gloves if you want to reduce the risk of cross contamination.Thanks
- Use the sharpest filet knife you have available - the duller the knife, the higher the risk of hurting yourself.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Don't use more fish than you need. Remember that one big fish yields 2 big filets.Thanks
- If you would like to have a side dish with your fish filet, be sure to prepare it before the fish to avoid cross contaminationThanks
Advertisement
Things You'll Need
- Filleting knife
- Chef's knife
- Cutting board
- Scissors
- Tweezers
- Fish
References
- ↑ https://www.fix.com/blog/hooking-and-cooking-a-fish/
- ↑ Michael Reynolds. Professional Fishing Instructor. Expert Interview. 26 February 2021.
- ↑ http://sushieveryday.com/why-bleeding-fish-important/
- ↑ http://sushieveryday.com/why-bleeding-fish-important/
- ↑ Michael Reynolds. Professional Fishing Instructor. Expert Interview. 26 February 2021.
- ↑ https://www.waitrose.com/home/recipes/step_by_step/how_to_fillet_a_fish.html
- ↑ https://www.waitrose.com/home/recipes/step_by_step/how_to_fillet_a_fish.html
- ↑ https://www.weber.com/US/en/blog/tips-techniques/the-butchers-guide-to-how-filleting-a-fish/weber-29773.html
- ↑ https://www.weber.com/US/en/blog/tips-techniques/the-butchers-guide-to-how-filleting-a-fish/weber-29773.html
- ↑ https://www.weber.com/US/en/blog/tips-techniques/the-butchers-guide-to-how-filleting-a-fish/weber-29773.html
- ↑ https://www.dummies.com/sports/fishing/filleting-your-fish/
- ↑ https://www.weber.com/US/en/blog/tips-techniques/the-butchers-guide-to-how-filleting-a-fish/weber-29773.html
- ↑ https://www.myrecipes.com/how-to/cooking-questions/can-freeze-fish
About This Article
Article Summary
X
To fillet a fish, lay the fish horizontally on a cutting board. Hold a long, sharp fillet knife directly behind the fish’s gills and cut down toward the fish’s head, then flip the fish over and repeat the cut to remove its head. Cut off the tail as well, then run the knife along the fish’s ribcage near its backbone to separate the meat from the ribs. Continue cutting along the bones until the fillet ends at the tail, then pull the fillet away from the ribcage and slice it off. Turn the fish over and repeat the process to get the second fillet. To learn how to remove the pin bones and trim the fish, read on!
Did this summary help you?
Thanks to all authors for creating a page that has been read 471,108 times.
Reader Success Stories
- "The videos showing the fish, I liked it better than drawings, preps you for what it actually looks like when doing it!" ..." more
Advertisement
"The videos showing the fish, I liked it better than drawings, preps you for what it actually looks like when doing it!"
..."
more
"I want to learn how to fillet fish. Your pictures make it easy to understand."
"Made it look simple, not too over loaded with confusing details."
"Many doubts about filleting fish got cleared."
