Download Article
Download Article
Potholes or other damage to an asphalt driveway can often be filled in with cold asphalt filler. Here are some steps to help you have a successful project repairing your driveway.
Steps
-
Measure or estimate the amount of filler material you will need to execute your repairs. A small pothole, less than two feet square can be repaired with about 50 pounds of cold mix asphalt filler.
-
Select the asphalt filler you want to use for your repair. Cold asphalt filler (a mixture of asphalt tar and rocks) is sold in plastic bags similar in size to cement bags weighing 50 pounds, and buckets ranging from one gallon to five gallons.Advertisement
-
Clean loose dirt and debris out of the hole with a garden shovel, a trowel, or other suitable tool. If the material in the hole is dry soil, you may want to use a garden hose to dampen it because the tar will not stick to dry dirt. [1] X Research source
-
Let the hole dry in the sun if there is water in it because the tar will not stick to the wet dirt. You can also use a fan or blow dryer if you are in a hurry.
-
Fill in holes that are more than three or four inches deep with a material that can be compacted tightly, such as clay, crushed concrete, or crushed limestone. For repairs where the material underneath the patch is not capable of being compacted with normal methods, you may want to over-excavate the hole and pour concrete to about two inches below the finished pavement grade to stabilize the area. [2] X Research source
-
Fill the hole with the asphalt filler to about one half an inch above the adjacent paving. This will leave the finished patch level with the pavement after it is packed. [3] X Research source
-
Pack it down with a hand tamp, a gasoline powered plate compactor, or even a hammer for very small holes. Make sure the cold asphalt mix is packed firmly into the hole or you will find the patch will fail quickly when it is exposed to traffic. [4] X Research source
-
Cover the patch if possible. You can put a board or piece of plywood over the fix for a few days to ensure that it hardens more but this is optional. If you packed it down tightly, it can be driven over immediately. [5] X Research source
-
Clean up your tools and any spilled material around your patch and admire your handiwork.
-
Finished.
Advertisement
Community Q&A
Search
-
QuestionWhat should the outside temperature be to use a coldpatch?Community AnswerAbove 65F, but I caution that really warm weather would keep it soft for a long time. A lot of people have an issue with it not setting up for a long time.
-
QuestionWhat if the patch doesn't harden? Ours is still sticky and soft after two weeks.Community AnswerYou can use Aquapatch, which provides a permanent repair and hardens within an hour.
-
QuestionShould I apply a sealer coat after packing/tamping it down?Community AnswerYou could. However, the asphalt in cold patch needs time to set up -- sometimes up to six months. Read the curing time on the package before applying a sealer on top of it. It is not necessary to put sealer on top of a patch, though.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- For repairs larger than two square feet, a plate compactor is very useful.Thanks
- If you want, you can undermine the pavement adjacent to the patch so the new patch material will support edges weakened by the event that caused the original pothole.Thanks
- Tar will wash off of your hands with a good mechanic's hand cleaner, be careful using solvents like mineral spirits, lubricants, or other chemicals as they can be harmful to your skin.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Big holes will sag a little when cars drive over them so don't be afraid to fill the hole 1 ⁄ 4 inch (0.6 cm) higher in the center. The cars driving over will lower the filler with time.Thanks
Advertisement
Things You'll Need
- Shovel or other digging tools
- Plate tamp or plate compactor
- Asphalt mix
- Material to stabilize the base underneath the patch if needed
- Rubberized Work Gloves
- Respirator (If area is poorly ventilated)
Expert Interview
Thanks for reading our article! If you’d like to learn more about building tips, check out our in-depth interview with Sina Kamran .
References
- ↑ https://www.thisoldhouse.com/how-to/how-to-repair-asphalt-pothole
- ↑ https://www.asphaltsealcoatingdirect.com/info/how-repair-blacktop-asphalt-driveway-diy-homeowner
- ↑ https://www.asphaltsealcoatingdirect.com/info/how-repair-blacktop-asphalt-driveway-diy-homeowner
- ↑ https://www.craftfoxes.com/blog/diy-home-fixing-a-pothole-or-sinkhole-in-your-drive
- ↑ https://www.familyhandyman.com/smart-homeowner/diy-home-improvement/how-to-fix-a-sinking-driveway/
About This Article
Thanks to all authors for creating a page that has been read 237,553 times.
Advertisement