PDF download Download Article PDF download Download Article

Kitchen curtains add a decorative touch to the over-the-sink picture windows commonly found in many kitchens. Because they are located in an area where they might possibly be exposed to moisture, heat and flame, kitchen window treatments require special design considerations. Their location places certain restrictions on their fabric, length and bulk, making kitchen curtains less complex to create than the more ornate window treatments used in living areas. You do not need to be a seamstress to sew curtains for your kitchen. Just follow these steps for how to make kitchen curtains.

  1. Watermark wikiHow to Make Kitchen Curtains
    You have a few choices when it comes to kitchen window treatments.
    • Curtains. These are 2 gathered panels that hang from top to bottom, framing the window on both the left and right sides.
    • Valances. A valance is a panel that spans horizontally over the only the upper portion of the window, leaving the lower part of the window undressed.
    • Privacy tiers. Tiers are single-panel window treatments designed to block only the lower 1/2 or 2/3 of the window. They are often used in combination with a valance.
  2. Watermark wikiHow to Make Kitchen Curtains
    Record the measurements for your window's length and width. If you want to create a privacy tier, also measure the distance from the vertical center-point to the bottom of the window. [1]
    Advertisement
  3. This will determine how much fabric you need to purchase. Generally speaking, the fuller the curtain, the more opulent it feels. A fullness of 1 1/2 equates to a flat panel and a fullness of 3 is a luxuriously gathered panel.
  4. Follow these guidelines to calculate the yardage of fabric that you will need. [2]
    • Multiply your fullness (1 1/2 to 3) by the width of your window. For example, if your window is 2 foot (0.6 m), then you will need a 4 foot (1.2 m) length of fabric for each full-sized panel you intend to create.
    • Remember that a valance and a privacy tier are each one full-sized panel.
    • If you are planning to sew curtains, your panel length will be 1/2 of the full-sized panel length and you will need 2 panels per window.
    • Add at least 2 inches (5 cm) to the width and 6 inches (15 cm) to the length of your valance, tier or curtain design to account for seams, rod pockets and hems. You may adjust that number, depending on your design and the size of your rod.
  5. When you make kitchen curtains, you must keep in mind the practicality factor. You should not use any fabric that will shrink or fade easily, or that cannot be washed. It is also a good idea to choose a flame-retardant fabric, just in case of cooking mishap. [3]
  6. Watermark wikiHow to Make Kitchen Curtains
  7. Watermark wikiHow to Make Kitchen Curtains
  8. Watermark wikiHow to Make Kitchen Curtains
  9. Watermark wikiHow to Make Kitchen Curtains
    [4]
    • Fold the lower edge of your panel up 0.5 inch (1.25 cm), wrong side in, and press.
    • Fold the clean edge up, facing the wrong side of the fabric, to the desired hem amount (keeping in mind the amount you allotted when you cut your panel) and press again.
    • Stitch the top folded edge of the hem to secure it in place.
  10. Watermark wikiHow to Make Kitchen Curtains
    • Fold the vertical edges 0.5 inch (1.25 cm) on each side, wrong side in, and press.
    • Double the fold to conceal the rough edge and press again.
    • Sew along the edge of the fold to secure the hem.
  11. Watermark wikiHow to Make Kitchen Curtains
    [5]
    • Fold the upper edge of your panel in 0.5 inch (1.25 cm), wrong side in, and press.
    • Fold the clean edge under (wrong side in) again, allowing enough room to compensate for the width of the rod you will be using, and press again.
    • Stitch as near to the folded edge as possible to finish the rod pocket. Once you finish this step, your panel is complete.
  12. Advertisement

Community Q&A

Search
Add New Question
  • Question
    How can I make a privacy kitchen curtain?
    T. Chinsen
    Top Answerer
    Fabric stores sell sheer and lace curtaining fabric, which allow light in and prevent anyone seeing inside. A tension rod can hold the curtain in place if you do not want to install curtain rods. Sheer curtains can also be purchased ready to hang from various stores that carry household items.
Ask a Question
      Advertisement

      Tips

      • You have room to be creative with your valance design. Search online for valance ideas. More often than not, variations apply solely to the shape and only require that you cut your pattern differently.
      • For greater ease, use a sewing gauge to measure hems.
      • If you choose to make privacy tiers, be sure to decide whether you want your tiers to rest on the windowsill or if you want them to fall below it when planning your design.
      Show More Tips
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Thanks for submitting a tip for review!
      Advertisement

      Warnings

      • Do not attempt to sew the rod pocket before the hems. Doing so will result in you stitching both ends shut and you will have no way of inserting the rod pockets when you are done sewing your kitchen window treatments.
      Advertisement

      Things You'll Need

      • Tape measure
      • Straight edge
      • Fabric
      • Fabric scissors
      • Iron
      • Fabric marker
      • Sewing machine
      • Thread
      • Rod pocket
      • Sewing gauge

      About This Article

      Thanks to all authors for creating a page that has been read 114,659 times.

      Reader Success Stories

      • Mary Hersz

        Oct 3, 2018

        "I am trying to teach a total non-sewer to make a kitchen window covering. Your explanation is the best help; it is ..." more
      Share your story

      Did this article help you?

      Advertisement