Download Article
Download Article
Many times if you live in a hostel you might have experienced this problem that your friends enter your room and leave without closing the door and you have to walk up to the door every now and then to close and that is way too annoying. Here is a simple DIY guide to solve this problem. You can do this within a few minutes.
Steps
Download Article
-
Make sure you have everything you need. See the list below. -
Make a hole on the cap of the water bottle with the nail and the hammer.Advertisement -
Make a knot on one end of the wire. -
Insert the other end of the wire into the hole made in the cap. Guide the wire through the cap up to the knot and ensure that the knot doesn't pass through the hole. If it passes, then make a bigger knot. [1] X Research source -
Close the bottle with the cap. -
Hammer a nail on the upper part of the door frame near the tower bolt. [2] X Research source -
7Tie the spare end of the wire to the nail.
-
Change the angle of clamp to about 135°. -
Fix the pulley/bobbin to the clamp with a bolt/metal wire. [3] X Research source -
Secure the clamp to the upper middle part of the shutter with nails. [4] X Research source -
11Put the hanging wire and bottle setup over the pulley.
-
Open the water bottle and fill it with water. [5] X Research source -
When you fill the bottle with water it pulls the door and shuts with a bang. To avoid it cut some thermocol pieces or eraser or sponge pieces according to the door rebate where the door hits and stops. -
Your automatic door shutter is ready!
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- You can use any weight instead of a bottle of water.Thanks
- Use a thick strong wire (like the one used for spiral binding).Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Ensure that the bare part of wire doesn't come in contact with any other part except the pulley. Otherwise it will lead to wear of wire and eventually the wire would give away.Thanks
- Make sure that whatever you're doing is not in conflict with the policy of where you liveThanks
- Do not use stones as weight because it may hurt someone if it falls on their feet in case of failure.Thanks
- Ensure that the pulley is rotating freely on the clamp. This adds to the efficiency of the setup.Thanks
- You may have to change the thermocol pieces as they may get pressed in long run and won't be effective thenThanks
Advertisement
Things You'll Need
- A water bottle
- A strong wire of about 1–2 meters (3.3–6.6 ft)
- A pulley/bobbin or anything which can act as a pulley
- A small angle clamp
- Few bolts and nails
- Hammer
- Sponge/Thermocol// Any compressible soft material
References
About This Article
Thanks to all authors for creating a page that has been read 74,436 times.
Advertisement
