How to Make a Sparkler Bomb

PDF download Download Article
PDF download Download Article

Sparklers can be a fun and safe way to celebrate birthdays, holidays, and special occasions. When bound and lit together, you can create a sparkler bomb. Sparkler bombs can explode and can produce a very large flame. The more sparklers you combine, the more dangerous the flame. Whether creating homemade sparklers or buying from the store, make sure to exercise extreme caution and safety procedures. Pyrotechnics can lead to serious harm and should not be attempted without proper supervision and precautions. Be sure to check with local authorities to ensure you are following all safety and legal guidelines in purchasing and detonating your pyrotechnics.

Ingredients

Purple Sparklers

  • 60 milliliters hot water
  • 36 grams potassium nitrate (KNO3) – Use stump remover
  • 24 grams sugar or sucrose – ordinary granulated table sugar is fine
  • cotton yarn (not yarn made from a synthetic, like acrylic)
  • clothespins, alligator clips, or tongs to hold the sparkler (or you can dip the ends in wax

Red Sparklers

  • 200 grams strontium nitrate
  • 120 grams steel powder
  • 32 grams aluminum flakes
  • 6 grams boric acid
  • 2 grams charcoal
  • ~100 milliliters rubbing alcohol or a mixture of 25% alcohol in water
  • 40 grams dextrin
  • wires or sticks
Method 1
Method 1 of 3:

Using Store Bought Sparklers

PDF download Download Article
  1. Sparkler bombs can be extremely dangerous if taken to extreme lengths. Binding enough sparklers together can result in a blast as strong as dynamite. Sparkler bombs can hurt or severely harm individuals who do not take the proper precautions set by their local authorities. [1]
  2. If you are planning to make a Sparkler Bomb in the U.S. and use more than 50 milligrams of flash powder, you are breaking the law under the ATF regulations for consumer fireworks.
    Advertisement
  3. Many areas prohibit the use of pyrotechnics of any kind. Do not set off your sparkler bomb indoors or any location without proper exits, ventilation, and fire safety equipment. [2]
  4. Depending on the time of year, sparklers can be bought in many locations. Sparklers can be found in various sizes with the larger sizes lasting longer and giving off more effect. Sparkler bombs are usually made from the 10 inch sparklers.
    • Sparklers are wires that are coated in pyrotechnic material and iron fillings. Once lit, they emit a tiny amount of sparks that move down the wire for about 20 seconds. [3]
  5. As you increase the number of sparklers you tape together, you will create a greater effect; however, each sparkler you add increases your risk for harm and danger. Do not exceed an amount that you have already seen tested by a professional or tested yourself.
    • Supervise your children so that they do not exceed a safe limit. 72 sparklers are enough to make a dangerous bomb blast. Read the labels and keep well below 50 milligrams of flash powder, the explosive content in firecrackers that is illegal under the Bureau of Alcohol, Tobacco, Firearms and explosives. [4]
    • Arrange them so that they are all facing the same way and tape them at the bottom where the is no longer any pyrotechnic material.
    • Wrap the bundle in tape 2-3 times, leaving an inch or so of the coated end exposed. It should now look like a cone.
  6. Do not hold the sparklers in your hand while lit. Many people have suffered severe burns and injuries for being too close to the flame. Plant the sparklers in the ground so that you can easily observe from a safe distance.
    • Make sure there is nothing flammable around the detonation area.
    • Make sure all pets and toddlers are secure and accounted for because you do not want them suddenly darting onto the scene.
  7. Using a single sparkler, light the rest of the sparkler bomb. Light the single sparkler, with matches or a lighter, away from the sparkler bomb. You want to be able to move to a safe distance as quickly as possible.
    8. Advertisement
Method 2
Method 2 of 3:

Creating Homemade Purple Sparklers

PDF download Download Article
  1. Pour 36 grams potassium nitrate and 24 sugar into 60 milliliters hot water. Stir the mixture until the potassium nitrate and sugar dissolve. [5]
    • This mixture can be very smokey. Add aluminum or titanium flakes to the mixture for a more distinct glow.
  2. Soak about 3 meters of yarn with the water, potassium nitrate, and sugar mixture. Using a cookie sheet, arrange the yarn so you can dry them out into lines. [6]
    • Do not use acrylic yarn.
  3. Air dry the yarn by keeping the cookie sheet in a dry area that won’t be disturbed by pets or children. [7]
    • If you do not have time to air dry the yarn, dry the yarn in your oven at 300 °F (150 °C) for about 20 minutes. Remember to watch the yarn. Open the oven and use tongs to shuffle the yarn off the pan after 5-10 minutes to prevent them from sticking.
  4. Once completely dry, cut the yarn into straight pieces to make sparklers. You can make them as long or as short as you want but don’t make it too short because it can quickly burn your hand. [8]
  5. Use a glove to hold these homemade sparklers. You can also use a clip, clothespin, or anything else to keep the sparkler away from your fingers and hand. [9]
    6. Advertisement
Method 3
Method 3 of 3:

Creating Homemade Red Sparklers

PDF download Download Article
  1. Most of these chemicals may be difficult to find so order them online. Check with your local delivery service to ensure that they are legal to obtain in your area. [10]
  2. Add 200 grams strontium nitrate, 120 grams steel powder, 32 grams aluminum flakes, 6 grams boric acid, 2 grams charcoal, and ~100 milliliters rubbing alcohol or a mixture of 25% alcohol in water together. [11]
  3. Stir dextrin into about 25 ml of alcohol solution. Keep stirring to break up any lumps until you create a paste. [12]
  4. Create a mixture by adding the solid ingredients and dextrin paste with between 50 and 75 milliliters of alcohol. Keep stirring until the mixture is smooth. [13]
  5. Dip wire into the mixture. Just like store bought sparklers, leave enough room on the wire for you to be able to hold it. Partially dip the wire, leaving a few inches for your hand. to be at a safe distance. Dry the sparkler and dip it again for a second coat. Do not light the sparkler until it is completely dry. [14]
    • You may need another sparkler or butane torch to light these sparklers so be sure to wear the proper safety equipment and take the proper precautions.
    6. Advertisement

Community Q&A

Search
Add New Question
  • Question
    How do I make a sparkler bomb that's not dangerous?
    Community Answer
    Unfortunately, pyrotechnics are, by nature, dangerous. Exercise caution and you will minimize harm.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 19 Helpful 16
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Video

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!
      Advertisement

      Warnings

      Advertisement

      You Might Also Like

      3 DIY Guides for Creating Fireworks from Home
      How to
      Make a Flamethrower
      How to
      Make a Signal Flare
      How to
      Store Fireworks
      How to
      Dispose of Fireworks
      How to
      Make a Fireball
      How to
      Get a Federal Explosives License
      How to
      Use Eco‐Friendly Alternatives to Fireworks
      Advertisement

      References

      1. ↑ https://www.wsj.com/articles/SB10001424052748704699604575343214252663030
      2. ↑ https://www.wsj.com/articles/SB10001424052748704699604575343214252663030
      3. ↑ https://www.wsj.com/articles/SB10001424052748704699604575343214252663030
      4. ↑ https://www.wsj.com/articles/SB10001424052748704699604575343214252663030
      5. ↑ http://sciencenotes.org/how-to-make-a-homemade-sparkler-2-simple-recipes/
      6. ↑ http://sciencenotes.org/how-to-make-a-homemade-sparkler-2-simple-recipes/
      7. ↑ http://sciencenotes.org/how-to-make-a-homemade-sparkler-2-simple-recipes/
      8. ↑ http://sciencenotes.org/how-to-make-a-homemade-sparkler-2-simple-recipes/
      9. ↑ http://sciencenotes.org/how-to-make-a-homemade-sparkler-2-simple-recipes/
      1. ↑ http://sciencenotes.org/how-to-make-a-homemade-sparkler-2-simple-recipes/
      2. ↑ http://sciencenotes.org/how-to-make-a-homemade-sparkler-2-simple-recipes/
      3. ↑ http://sciencenotes.org/how-to-make-a-homemade-sparkler-2-simple-recipes/
      4. ↑ http://sciencenotes.org/how-to-make-a-homemade-sparkler-2-simple-recipes/
      5. ↑ http://sciencenotes.org/how-to-make-a-homemade-sparkler-2-simple-recipes/

      About This Article

      Article Summary X

      To make a sparkler bomb, start by buying a box of sparklers and reading any warning labels on the box. Then, tape some together with electrical tape, starting with just a few and working your way up to avoid a large explosion. To stay within ATF restrictions, check how much flash powder is in each sparkler, and add the sparklers up to stay under 50 milligrams of powder. Cover them in tape and leave about 1 inch of the coated end of the sparklers exposed. Next, place the taped bundle in the ground facing away from you. Once they are securely placed, use a single sparkler to light the bomb, and run far away before it explodes. For tips on how to stay safe while making and lighting your sparkler bomb, read on!

      Did this summary help you?
      In other languages
      Thanks to all authors for creating a page that has been read 318,569 times.

      Did this article help you?

      Advertisement