Q&A for How to Plane Wood

Return to Full Article

Search
Add New Question
  • Question
    What degree of smoothness is achieved by a planer? Can it be related to sandpaper grit?
    Jimbooi
    Community Answer
    If you use a hand plane properly set up and with a correctly-sharpened blade and you plane with the grain of the wood, it is possible to get a very smooth result. When sandpaper is used, the smoothness of the finish is dependent on the size of the grit. Each piece of grit scratches the surface. The scratches can be so small that they are not visible with the naked eye. A plane blade has a smooth edge & cuts the fibers.
  • Question
    How do I plane the end grains in wood?
    Community Answer
    This is much the same as planing the sides of a plank. However, the things to note are; 1. you need the iron as sharp as you can get it, 2. end grain is about 3 times harder to plane, so you probably need to set the iron the a very thin shaving and 3. plane from the edges to the middle to avoid splitting the back edge of the board.
  • Question
    Can I plane a round piece of wood like a section of a log?
    Jimbooi
    Community Answer
    Yes, you can. The round piece of wood must first be fastened securely and held immobile. After that, you can use a finely set hand plane (with a sharp blade) and a slicing action across the end grain section to plane the wood.
  • Question
    Do I need to plane a board that's bowed (mostly in the middle) with the bow "up?"
    Community Answer
    Bow up. You want the ends to touch the plates of the joiner/planer so you remove a little from the ends of each face with each pass. As you plane, the area planed gets larger until you get cutting all the way down the board, then you have a flat surface. If the bow was down, the piece will rock form side to side as you machine it, not leaving a flat face.
  • Question
    Can wood be too dry to plane?
    Community Answer
    Not really. In temperate climates, even kiln-dried boards will vary in moisture content quite markedly from winter to summer if stored in a barn. Experienced woodworkers can tell what season some items were made in based on the current time of year and the fit of a joint.
  • Question
    How does one plane small pieces say around 9 in long?
    Donagan
    Top Answerer
    Using a vise is the easiest way. It's also possible to hold the piece on a work surface with one hand and carefully plane it with the other hand.
  • Question
    Can you plane the end of a plank?
    Donagan
    Top Answerer
    It's almost impossible to do that. Cutting a plank with a power saw should give you a pretty good end surface. The careful use of a power sander could give you good results, too.
  • Question
    Does the plane iron have the bevel up or down?
    Community Answer
    The plane iron needs to have the bevel up.
  • Question
    Can I use candle wax or beeswax to make planing easier?
    Donagan
    Top Answerer
    No, that wouldn't help much. Using a sharp plane blade and a well-anchored piece of wood is your best bet.
  • Question
    How can you plane the top of a door that hits against the frame?
    Donagan
    Top Answerer
    Planing will work fine if you can plane with the grain of the wood. If not, using a belt sander might be best. It's easiest if you remove the door and place it on sawhorses or protruding from a workbench.
Ask a Question

      Return to Full Article