Q&A for How to Repair a Crochet Blanket

It sounds like you are using a knot to join the yarn together. Instead, use a darning needle to thread the unused wool into the work on the wrong side.

This depends on the kind of stitching used. If you have a basic stitch like only single crochets, double crochets, etc., you unravel until you reach the end of the last partly intact row and crochet from there as if this side is the bottom of your project. Nobody will notice if the last few rows are upside-down. You could even do this for a simpler stitch out of the category of textured stitches like the moss stitch. For anything more complicated, whether it can be done depends on the type of stitching. You could unravel further until the last intact row and tie off there as if this was the intention, but that depends on what kind of project you have (a sweater would end up too short).

If the squares have separated where they were sewn together, you'll have to find some matching yarn and sew them again. Be sure to leave a "tail" that can be woven back into the squares for added security against coming undone.

Weave some yarn through each row to make the loops less obvious. Then, just keep on crocheting normally. It should straighten out on it's own.

It requires a good knowledge of the pattern if you wish to tear out the base rows. If the upper rows are dependent on those base rows, you may need to start over. Consult with a local knit/crochet group at your local yarn store. If they offer classes, then there is someone who can advise you on how to proceed.

Option one is to, with a matching thread on a yarn needle, carefully weave a strand following the path of where the cut thread would go. Leave at least 2"/5 cm at the beginning and at the end to prevent it slipping out. You could also tie matching sewing thread about 1/2"/1.2 cm from the cut end. Secure it with a knot and a little glue. Go over to the opposite cut end and repeat. If possible, overlap the ends and knot and secure the thread in the middle. This method reduces the bulk of a yarn thread repair.

If this blanket is a child's favorite and is starting to fall apart, consider applying a patch. Make it a shared project with the child. Have the child select ribbon, lace or fabric (or a combination) and stitch them over the damaged areas or to connect larger separated pieces. With small defects, yarn embroider a shape like a flower. To maintain the blanket pattern, ask at your local yarn store for help.

If the hole is relatively small, use matching yarn and cinch it tight. For a larger hole, a crocheted applique patch can be sewn on to make it a part of the design. Ask an instructor of knitting or crochet for assistance if neither solution is appealing.

Create the rows you wish to replace. Use the next row to connect it by slip stitching into place. You can also follow where the next row connects and carefully hook the stitch through a stitch for an "invisible" repair.

If some of your stitches have fallen apart/gotten ripped, you can try a few things. Try buying the same yarn and making small patches to sew on the blanket. Another option (much more time consuming) is taking apart the blanket and recrocheting.

Ripping (also called frogging) back to where the rows are at the right number of stitches is always an option, if time consuming. An alternative is to add a crochet edging, which can disguise some unevenness. If it is a major unevenness and the blanket is a trapezoid, blocking can help if it is cotton or wool yarn.

If the thread is the same thickness as the yarn or material used to crochet the tablecloth originally, yes you can use thread. Make sure that you keep the weight (thickness) the same so you don't cause discontinuities and bumps in the thickness levels.

You can insert the hook into the yarn and twist it around and crochet another half double crochet. But make sure that you are keeping the stitch in front of it secure, then you loop it though like a regular stitch.

Unfortunately, if you want to cut a crochet blanket into smaller pieces, the pieces will most likely unravel. If you want to prevent this, you can cut it one stitch at a time, and tie the yarn together so it won't unravel. Otherwise, it will definitely unravel over time.

No, that would cause the afghan to fall apart. If you want to shorten it, try removing rows from the top instead. Find the ending knot, undo it, and gently pull the yarn to unravel stitches. Once you're happy with the amount you've removed, just fasten off and tuck in the yarn end.

Since the pattern is still the same, simply attach your yarn to the corner that would be the same as if you were turning to start a new row. It will make it less obvious that it was extended from the starting edge. Continue in pattern until you get to your desired length.

Stitch blanket binding along what will become the new edges of the blanket piece. You do not specify if the blanket is a single piece or made up of several pieces. It is possible to use a sewing machine to stitch (double row of stitching) the yarn together before cutting with scissors. Fusible material from a fabric store can do the same but you will need to fuse both sides to prevent the yarn unraveling. If there are pieces that are sewn then simply locate the seam and cut. Any local knitting/crochet group will have someone who can help you choose how to portion out the afghan.

If you keep pulling on the yarn, then multiple stitches should come out. It will go stitch by stitch, but just keep pulling and more will loosen.

If the tension is loose, it is possible to hook the knot into the back of the piece. Use a smaller hook size to pull the knot into the solid part of a stitch. Remove the hook when the knot becomes hidden by the surrounding yarn. Pull and stretch the area to make sure that the knot remains hidden. Repeat the technique if the knot pops back out.

Create your crochet patch and place over the desired location. Look at the closeness of the yarn in the patch and the afghan. You can then use matching yarn to sew it into place. If it is multicolored, you can use invisible thread and sew it into place. Make loose stitches to maintain the flexibility of the afghan. Using fabric or any other glue will cause a lumpy texture and this also tends to come apart with wear and tear.

For small holes, use a needle and matching thread or yarn to stitch up the area. For a large area replicate the missing area if possible and sew in place. An expert crocheter can probably make a seamless repair. If this is not an attractive choice, add a crochet patch. Use of crocheted floral motifs can cover the holes yet maintain the overall crochet look.

Begin by strengthening the fabric area with interfacing or fabric gluing on a matching fabric to the damaged area. Reshape and secure the crochet stitches to the fabric by machine or hand-sew the two materials together. Use invisible thread to attach the crochet material to hide the repair.