Download Article
Download Article
Do you have a trade paperback that has fallen on hard times? If you've got loose or torn pages, a detached cover, broken binding, or dirty smudges all over your book, don't fret. It's fairly simple to resurrect the book for a few more years of good reading. Depending on what you're looking to fix, you can get your book up and running again with some glue or tape, an eraser, patience, and a steady hand.
Steps
-
Open the cover on a flat surface. Place the cover open on a flat surface in front of you.- If the cover of your book is extremely loose, but not fully detached, you can gently peel it away from the textblock, the part of the book that's contained within the cover.
-
Brush archival glue onto the spine of the textblock. Using a small paintbrush, evenly apply archival glue along the spine of the textblock and let it dry for ten minutes. [1] X Research sourceAdvertisement
-
Apply a thin coat of archival glue along the spine of the cover. Using your paintbrush, evenly apply glue along the spine of the cover's inside.
-
Place the textblock back into the cover. Aligning the textblock spine and cover spine with one another, place the textblock back into the cover of the book.
- You can place wax paper between the cover and the first and last pages of the book to prevent any oozing of glue.
-
Close the book and place weights on top of it. Securely close the book, making sure everything is aligned correctly. Then place a heavier book on top to weigh it down while it dries.
-
Leave the book to dry for 24-48 hours. While archival glue will dry within a few hours, it's best practice to leave the book for at least 24 hours to set. [2] X Research source
Advertisement
-
Open the book where the binding is broken. Open your book to where the glue binding has broken. You'll know this has happened because your book will fall easily open to the break, and you'll be able to see the binding glue. Repairing this will ensure that pages or segments of pages don't fall out of your binding. [3] X Research source
- The glue binding of thick paperbacks, in particular, are notorious for partially breaking while you're reading.
-
Apply a thin line of archival glue along the seam. Carefully apply archival glue along the interior seam of the book where the old glue is exposed.
- You can use a small brush if you'd like to more evenly apply the glue.
-
Close the book and use rubber bands to secure it. Close the book securely and put two rubber bands around it to keep it stable. Place one rubber band towards the top of the book and another towards the bottom. [4] X Research source
-
Leave the book to dry for 24-48 hours. While archival glue will dry within a few hours, it's best practice to leave the book for at least 24 hours to set. [5] X Research source
Advertisement
-
Open the book where the loose pages belong. If a few pages in your book have come loose, not to worry. Open your book to the spot where you'd like to insert the loose page.
- If the book doesn't stay open on its own, make sure to weigh down the pages with a paperweight. This way the book won't start closing before you're done inserting the loose page.
-
Apply a thin line of glue along the binding of the page in the book. Place a thin line of archival glue along the vertical edge of the page to which you'd like to adhere your loose page. The glue should be as close to the binding as you can get it. Make sure you're using an archival glue, which should be acid free.
- Do not glue multiple loose pages onto one another as this will not be stable over time.
- You can purchase archival glues from craft stores or an archival supplier.
-
Insert the page back into place. Carefully place the page back into place, taking care to align the edges of your loose page with the edges of adjacent pages. [6] X Research source
- To prevent any glue from oozing out, you can put a piece of wax paper along the page to soak up any escaping glue. This way your pages won't glue together. [7] X Research source
-
Close the book and place it under weights. To ensure the page lays flat within the book while it's drying, weigh down the book with another heavier book.
-
Leave the book to dry for 24-48 hours. While archival glue will dry within a few hours, it's best practice to leave the book for at least 24 hours to set. [8] X Research source
Advertisement
-
Identify the direction of the tear. On the torn page, identify if the tear has a single direction. If it doesn't, you'll want to repair only one direction of the tear at a time. [9] X Research source
-
Cut a strip of tape a 1 ⁄ 4 inch (0.6 cm) longer than the tear. Cut your archival tape a 1 ⁄ 4 inch (0.6 cm) longer than the tear so the repair will be more stable.
- You should be selective with what kind of tape you use. An archival document repair tape will be safest for your book.
-
Place the tape along the tear. Center the tape over the tear so the tape will extend beyond the tear in both directions. Then place the tape along the tear and smooth it down with your hands or a stiff folder. [10] X Research source
- If using a stiff folder, use the folder's edge to smooth the tape down.
Advertisement
-
Use a dry cleaning sponge to remove surface dirt. Use a dry cleaning sponge, which is a block of vulcanized rubber found at archival stores, to gently rub away dirt. Brush away any residue with a soft brush or soft brush attachment on your vacuum. [11] X Research source
- Do not ever use water with your sponge. This will cause permanent damage to your book.
-
Absorb grease stains with paper towels. If you've got a pesky grease stain, you can place paper towels along the stain and close the book. This should absorb the grease from a freshly made stain. [12] X Research source
-
Erase away pencil marks. Using a plastic eraser you can remove pencil marks by erasing in a forward motion. Brush away the eraser dust with a soft brush or vacuum. [13] X Research source
- Ink marks cannot be removed.
Advertisement
Community Q&A
Search
-
QuestionHow do I fix a crease on the cover of a book?Community AnswerPlace heavy things on top of the book for a while; the crease should come out or lessen in severity.
-
QuestionWill this work with hardcover books too?Community AnswerRepairing loose or torn pages will be the same for hardcover books. You should also be able repair a loose hardback cover in the same way. However, hardback books present other issues that need repairing, such as spine replacements, that are not common with paperback books.
-
QuestionIs rubber cement or Elmer's glue better to use for conserving a book?Community AnswerYou should not ever use rubber cement, so Elmer's glue will be a better choice. However, if you're working with particularly brittle pages use an archival glue for best results.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
Submit a Tip
All tip submissions are carefully reviewed before being published
Thanks for submitting a tip for review!
Warnings
- If your paperback book is of monetary or sentimental value, you should take your book to a professional book conservator to ensure the best results.Thanks
Advertisement
Things You Will Need
- Archival glue
- Dry sponge
- Eraser
- Brushes
- Wax paper
- Heavy books
- Rubber bands
References
- ↑ https://blog.library.si.edu/blog/2019/04/30/the-fix-repairing-an-adhesive-bound-paperback/
- ↑ https://blog.library.si.edu/blog/2019/04/30/the-fix-repairing-an-adhesive-bound-paperback/
- ↑ https://blog.statemuseum.nd.gov/blog/book-repair-gateway-feeling-accomplished
- ↑ https://blog.statemuseum.nd.gov/blog/book-repair-gateway-feeling-accomplished
- ↑ https://blog.statemuseum.nd.gov/blog/book-repair-gateway-feeling-accomplished
- ↑ https://cool.culturalheritage.org/coolaic/sg/bpg/annual/v17/bp17-09.html
- ↑ https://penandthepad.com/repair-paperback-books-6073088.html
- ↑ https://blog.statemuseum.nd.gov/blog/book-repair-gateway-feeling-accomplished
- ↑ https://www.dartmouth.edu/library/preservation/repair/dartmouth-book-repair_manual_torn-pages.pdf
- ↑ https://www.dartmouth.edu/library/preservation/repair/dartmouth-book-repair_manual_torn-pages.pdf
- ↑ https://www.nedcc.org/free-resources/preservation-leaflets/7.-conservation-procedures/7.2-surface-cleaning-of-paper
- ↑ https://collections.dartmouth.edu/teitexts/book-repair/diplomatic/SimpleBookRepairManual-diplomatic.html#sbr-20
- ↑ https://www.dartmouth.edu/library/preservation/repair/dartmouth-book-repair_manual_cleaning.pdf
About This Article
Article Summary
X
To repair a loose page in a paperback book, apply a line of archival glue along the binder and stick the page in place. Then, weigh the book down with a heavy object so the page stays flat, and leave it to dry for 24-48 hours. If you’re repairing a torn page, cut a piece of archival tape that’s slightly longer than the tear, then flatten it out over the tear with your fingers so it reaches past the ends of the tear in both directions. For a detached cover, apply glue to the spine of the cover and the pages, stick them together, and weigh the book down while it dries for 24 hours. For tips on how to fix a break in a binding, read on!
Did this summary help you?
Thanks to all authors for creating a page that has been read 540,148 times.
Reader Success Stories
- "Outstanding article on how to fix books! Easily read with very good how-to pictures. I highly recommend this booklet if you are wanting to restore those much loved books of yours to near new condition again so that you can keep on loving them!" ..." more
Advertisement
82%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"Outstanding article on how to fix books! Easily read with very good how-to pictures. I highly recommend this booklet if you are wanting to restore those much loved books of yours to near new condition again so that you can keep on loving them!"
..."
more
"I have a very large collection of paperback books that I have been collecting for 32 years and there are over a thousand easily. I am currently in the process of sorting them and have found that some of them need some TLC. So I found this."
..."
more
"I am a children's librarian working with volunteers with developmental disabilities to learn how to repair books. Videos plus text format allowed the first effective 1:1 instruction, leading to independent repair of books. Thank you."
..."
more
"Binding and rebinding is not that hard; the key is a little info and lots of patience. I have learned to give myself a week--at least-- to complete a project."
..."
more
"The first section helped a lot, as it was something I have had trouble with. I learned the other techniques years ago, though not the tip about rubber bands."
..."
more
