Download Article
Download Article
Headbands that dig into your temples or your ears when you’re wearing them are super frustrating, especially if they’re plastic and don’t have much give to them. While you can try to stretch out a plastic headband, be careful to ensure that it doesn’t break. If all else fails, you can try adding padding to your headband or buying a different one in a looser style, like elastic.
Steps
-
Find an object that’s slightly larger than your own head. Usually, a stack of books or the arm of a couch is ideal. Try to find something that’s just a few inches wider than your own head so that your headband won’t snap. [1] X Research source- You can also use a headform, like for wigs, if you have one.
-
Stretch your headband over the object. Carefully open up your plastic headband and place it around the books or the arm of the couch. Make sure that it is spread open wide, but not so wide that you can hear cracking or breaking.Warning: If you spread your headband open too wide, it could snap in half.
Advertisement -
Leave it on the object for at least 24 hours. At the end of 24 hours, check on your headband to see if it has stretched at all. It may be slightly larger now so that it doesn’t dig into your temples as much. [2] X Research source- Plastic headbands don’t have much give to them, so they’ll only be able to stretch out less than 1 in (2.5 cm). If your headband still doesn’t fit, consider buying a different style or a larger size.
Advertisement
-
Stretch your headband out over a large object. Find a stack of books, the arm of your couch, or a headform that’s slightly larger than your own head. Carefully open up your headband and place it over the object so that it stays stretched out. [3] X Research source
- Use caution as you stretch your headband, as plastic ones have the potential to snap in half.
-
Put a hair dryer on a medium heat setting. Hair dryers can get pretty hot, so keep yours down to a low or medium setting. Cool air won’t do anything, though, so it has to be warm. [4] X Research sourceTip: If your hair dryer has any attachments on it, like a diffuser, take them off first.
-
Heat up the headband for 2 to 3 minutes. Move your hair dryer up and down the length of the headband to heat it up slowly. If you start to smell melting plastic, turn off your hair dryer right away. [5] X Research source
- If you heat your headband for too long, you could melt and ruin it.
-
Let the headband cool down for 30 minutes. Your headband will be warm and pliable, so don’t touch it yet. Give it a few minutes to cool down and conform to the shape of the new, larger object. [6] X Research source- If you pick up your headband before it’s cool, it will snap back to its original shape instead of stretching out.
Advertisement
-
Cut 2 5 in (13 cm) lengths of satin ribbon. You can use any color of ribbon you’d like to, but try to choose ribbon that’s about 1 in (2.5 cm) wide. Cut 2 pieces, and don’t worry if they look like they’re going to fray. [7] X Research source
- You can find ribbon at most craft supply stores.
- Although adding padding won’t stretch your headband, it may help stop it from digging into your head when you wear it.
-
Fold each ribbon in half, then add some hot glue. Fold the ribbon pieces so that the ends meet, then add a pea-sized dot of hot glue to the ends. Press them down with your fingers for about 30 seconds to let the glue dry. [8] X Research source
Warning: Careful, the hot glue will be super hot! Try to keep it off your fingers.
-
Keep folding the ribbon until it’s the width of your headband. Fold the ribbon in half again and add a dot of hot glue to keep it in place. Keep folding your ribbon until it’s about as wide as your headband is, or a little wider. [9] X Research source
-
Glue the ribbon to the ends of your headband with hot glue. Put a dot of hot glue onto the inside of the ends of your headband where it sits behind your ears, then stick the ribbon to the inside of it. Hold it in place for about 30 seconds, then add the other folded ribbon to the other side. [10] X Research source
- It’s okay if the ribbon sticks out a little bit, because it will be hidden behind your ears when you wear it.
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Warnings
- Be super gentle when you stretch your headband, and if you hear a snapping or cracking sound, stop right away.Thanks
Advertisement
Things You’ll Need
Stretching Your Headband over an Object
- Stack of books, arm of the couch, or a headform
Heating Your Headband with a Hair Dryer
- Stack of books, arm of the couch, or a headform
- Hair dryer
Adding Ribbon to Cushion Your Headband
- Ribbon
- Hot glue gun
- Hot glue
References
- ↑ https://www.youtube.com/watch?v=FUDbN4OpGcg&feature=youtu.be&t=148
- ↑ https://ask.metafilter.com/332071/Wide-plastic-headbands-that-wont-give-my-big-ol-noggin-a-headache
- ↑ https://ask.metafilter.com/332071/Wide-plastic-headbands-that-wont-give-my-big-ol-noggin-a-headache
- ↑ https://ask.metafilter.com/332071/Wide-plastic-headbands-that-wont-give-my-big-ol-noggin-a-headache
- ↑ https://ask.metafilter.com/332071/Wide-plastic-headbands-that-wont-give-my-big-ol-noggin-a-headache
- ↑ https://ask.metafilter.com/332071/Wide-plastic-headbands-that-wont-give-my-big-ol-noggin-a-headache
- ↑ https://www.youtube.com/watch?v=FUDbN4OpGcg&feature=youtu.be&t=251
- ↑ https://www.youtube.com/watch?v=FUDbN4OpGcg&feature=youtu.be&t=234
- ↑ https://www.youtube.com/watch?v=FUDbN4OpGcg&feature=youtu.be&t=252
About This Article
Thanks to all authors for creating a page that has been read 30,422 times.
Advertisement
89%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
