Download Article
Download Article
It can be really frustrating to deal with a clogged syringe and regular cleaning doesn’t always help. If possible, throw used syringes away and use a new one each time. Reusing syringes can lead to infections. [1] X Research source However, if using a new syringe is not an option, you can try a few different ways of removing a clog. Once the clog is removed, sterilize it before using it again.
Steps
-
Wear protective gloves for safety before handling the needles. Put on latex or latex-free sterile gloves to protect yourself from infection if you can. Even with gloves on, however, remain cautious when handling needles as these gloves will not protect you from a needle-stick.r [2] X Trustworthy Source PubMed Central Journal archive from the U.S. National Institutes of Health Go to source
- If gloves are not available, wash your hands thoroughly with soap and water before and after handling the syringe.
- If soap and water are not available, opt for an antibacterial hand lotion as an alternative.
-
Detach the needle from the syringe with pliers. Hold the syringe in your non-dominant hand and face the needle away from you and others. Use pliers to grasp the needle and pull it off of the syringe. [3] X Trustworthy Source PubMed Central Journal archive from the U.S. National Institutes of Health Go to source
- Some syringes may have a screw-on attachment. If this is the case, use your pliers to unscrew the needle from the syringe.
Advertisement -
Fill a large glass flask or jar with hot water. Choose a clean glass container that is large enough for you to submerge the entire needle. Fill the container with hot water from the tap. Place the needles in the hot water, pointy side down, and allow them to soak while running the hot water over them for 3-5 minutes. [4] X Research source
- If your tap water is not safe to drink, use boiled water instead.
-
Reattach the needle to a clean syringe. Draw the syringe plunger out. Tightly hold the bottom of the needle between your fingers and insert it into the tip of the syringe. [5] X Research source
- If you have a screw-on syringe, twist the needle at its base to reattach it to the syringe.
-
Blow air through the needle to remove any remaining residues. Hold the syringe between your fingers. Face the needle away from you and hold it over a napkin, towel, or sink. Push the plunger down to blow air through the needle. Draw the plunger out again and repeat this step several times until the plunger moves freely and easily. [6] X Research source
Advertisement
-
Preheat an oven to 248 degrees F (120 degrees C). Use a lab oven or autoclave if you can. This equipment is the optimal size and shape for heating medical equipment like syringes. [7] X Research source
- If you are using a traditional kitchen oven, you will also need to use an oven safe container to house your syringes.
-
Place the needle in the oven, upside down. In a lab oven, place a napkin on the bottom of the oven. Stand the needle, pointy side up, on the napkin. Lean it against the oven rack to help keep the needle standing. [8] X Research source
- In a traditional oven you may need to try different set-ups using your oven racks and an oven safe container to get the needles to stand vertically.
- Try placing the needle, pointy side up, inside a baking dish on the bottom rack. Allow the needles to rest against the bars of the top rack.
- The heat will melt any residue inside the syringe, so it’s important to stand the needle up so that the melted residue can flow out of the needle.
-
Bake the needles for 10 minutes before removing. Remove the needles from the oven carefully and place them on a clean towel or in a sterilized jar. Use tongs or oven mitts to remove the needles as they will be hot to the touch. [9] X Research source
- The heat should have melted any residue that was stuck in the syringe.
-
Flush the syringe with isopropyl alcohol to remove any remaining materials. You can buy rubbing alcohol at the grocery store or pharmacy in the first-aid section. Fill a small jar or glass with about 1 in (2.5 cm) of the alcohol. Insert the tip of the needle and draw back the syringe plunger to fill the syringe. Expel the solution into the sink by pushing the plunger down. [10] X Research source
- Avoid contact with your eyes and wear goggles for extra precaution.
- Avoid inhalation of the fumes from the isopropyl alcohol. Wear a vapor respirator or proceed in a well-ventilated area.
Advertisement
Expert Q&A
Search
-
QuestionAre there any other methods for unclogging a blocked syringe?Dr. Ian Kroes is a board-certified Family Medicine Physician and the Founder of Peninsula Doctor, a concierge medical practice in Menlo Park, California. With over 20 years of professional experience, Dr. Kroes specializes in Primary Care, which encompasses care for the entire family. In addition, Dr. Kroes has a deep interest in longevity care that focuses on ways to optimize patients' health. This includes attention to nutrition, fitness, and preventative testing. Dr. Kroes received a B.S. in Applied Physical from UC Berkeley and has earned a medical degree from Stanford University.You can put a needle through the opening of the syringe if there's some particulate matter blocking the syringe. Keep in mind that the syringe cannot be used medically or should not be used for any medical purposes because this will make the syringe unsterile.
-
QuestionHow do you get dried blood out of a syringe?Drew Hawkins1Community AnswerYou can unclog a syringe with dried blood in it by removing the syringe needle with a pair of pliers or by unscrewing it, filling a container that can hold the needle and syringe with hot water, and soaking them in the water for about 5 minutes. Then, remove the needle and syringe and reattach them, pull some of the water into the syringe through the needle and push it out by pressing on the plunger to force out any remaining pieces of the clog.
-
QuestionCan you use the same syringe twice on yourself?Drew Hawkins1Community AnswerNo, it's really unsanitary and unsafe to use the same syringe and needle on yourself twice. It can spread disease and potentially cause an infection. To be safe, discard both the needle and the syringe in an appropriate disposal container.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Warnings
- Best practices in syringe use involves disposing of syringes in a sharps container after just one use.Thanks
Advertisement
Tips
- Consider a needle-exchange program. These programs will give new syringes and needles to people who inject drugs without a prescription. Search online for a needle-exchange site near you. [11] X Research sourceThanks
- Reusing a syringe requires additional steps for complete disinfection.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Things You’ll Need
Using Hot Water to Unclog the Syringe
- Pliers
- Clean, hot tap water (or boiled water)
- Latex or latex-free gloves
- Hand soap or antibacterial hand lotion
- Glass flask or jar
Using Heat to Melt the Clog in a Syringe
- Autoclave or oven
- Oven-safe container (if using a traditional kitchen oven)
- Isopropyl (rubbing) alcohol
- Safety goggles
- Glass jar or dish
Expert Interview
Thanks for reading our article! If you’d like to learn more about healthcare, check out our in-depth interview with Ian Kroes, MD .
References
- ↑ https://www.thewellproject.org/hiv-information/cleaning-equipment-injecting-drugs
- ↑ https://www.ncbi.nlm.nih.gov/books/NBK138495/
- ↑ https://www.ncbi.nlm.nih.gov/books/NBK138488/
- ↑ https://youtu.be/NHZoxcozDjI?t=2
- ↑ https://youtu.be/NHZoxcozDjI?t=13
- ↑ https://youtu.be/NHZoxcozDjI?t=19
- ↑ https://youtu.be/NHZoxcozDjI?t=29
- ↑ https://youtu.be/NHZoxcozDjI?t=32
- ↑ https://youtu.be/NHZoxcozDjI?t=37
About This Article
Thanks to all authors for creating a page that has been read 113,186 times.
Advertisement